’07Camry hybrid_U (L/O 0610)
147
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
(o)
This message is to warn the driver that
the electronic key battery is low.
Change the key battery as soon as pos-
sible to ensure that the smart key sys-
tem operates properly.
The message appears with the master
warning light and a warning tone sounds.
(p)
This message warns the driver that the
steering lock function malfunctions. At
this time, the amber indicator light on
the “POWER” switch flashes.
The hybrid system will not be turned on
in this case. Contact your Toyota dealer
as soon as possible.
The message appears with the master
warning light and a warning tone sounds.(q)
This message appears when the steer-
ing lock is stuck. The message appears
for 15 seconds. At this time, the green
indicator light on the “POWER” switch
flashes.
To free the steering lock, rotate the steer-
ing wheel slightly left or right while press-
ing the “POWER” switch.
The message appears with the master
warning light and a warning tone sounds.
(r)This message is to remind the driver to
change the engine oil. The message is
a prior notice.
Toyota recommends that the engine oil
be changed as soon as possible.
If the driving range after the previous oil
change reaches 7200 km (4500 miles), the
message appears for about 15 seconds
with the master warning light and a warn-
ing tone sounds.
The engine oil maintenance data must be
reset after the engine oil change. See
following “Resetting the engine oil mainte-
nance data”.
’07Camry hybrid_U (L/O 0610)
148
2007 CAMRY HV from Oct. ’06 Prod. (OM33749U)
(s)
This message is to remind the driver to
change the engine oil.
Change the engine oil as soon as pos-
sible.
If the driving range after the previous oil
change reaches 8000 km (5000 miles), the
message appears with the master warning
light and a warning tone sounds. The
message stays on with the “POWER”
switch set at ON.
The engine oil maintenance data must be
reset after the engine oil change. See
“Resetting the engine oil maintenance
data” below for the procedure to reset the
system.Resetting the engine oil maintenance
data
The engine oil maintenance data must be
reset after replacement of the engine oil.
Reset the data by the following procedure:
1. Turn off the hybrid system with the trip meter A reading shown.
For details, see “—Odometer and two trip
meters” on page 138 in this Section. 2. The “POWER” switch must be set at ON while holding down the trip meter
reset knob. A message “OIL MILEAGE
RESET MODE” will appear on the dis-
play.
3. Hold down the knob at least 5 sec- onds. A message “COMPLETE” will ap-
pear and the message “OIL MILEAGE
RESET MODE” goes off. (t)This message appears when the washer
fluid level becomes very low.
Fill the tank as soon as possible.
The message appears with the master
warning light a warning tone sounds.
(u)
This message appears when the driver ’s
door is opened with the “POWER”
switch turned off and the moon roof
opened.
When you leave your vehicle, be sure to
close the moon roof.
The message appears with the master
warning light and a warning tone sounds.
