2007 PONTIAC GRAND PRIX lock

Tilt Wheel
A tilt wheel enables the position of the steering
wheel to be adjusted. The lever that lets the
steering wheel tilt is located on the outboard side
of the steering column.
To tilt the steering wheel, hold it and pull the lever.
Move the steering wheel to a comfortable driving
position and release the lever to lock it into place.
Tilt the steering wheel to the highest position to
give more room when exiting and entering
the vehicle.
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
GTurn and Lane-Change Signals. See
Turn and Lane-Change Signals on page 136.
3Headlamp High/Low-Beam Changer. See
Headlamp High/Low-Beam Changer on
page 137.
-Fog Lamps. SeeFog Lamps on page 146.
135

6(Low Speed):Push the lever up to the
second position for steady wiping cycles at a slow
speed.
1(High Speed):Push the lever up to the
third position for steady wiping cycles at a high
speed.
7(Mist):For a single wiping cycle, push the
lever down once and let go. The wipers will
stop after one cycle. For additional cycles, hold
the lever down.
About 30 seconds after the wipers are on, the
headlamps, taillamps, and instrument panel
lighting will come on, and the Driver Information
Center (DIC) back lighting will decrease to
the night time mode. About ten seconds after the
wipers are turned off, all the lamps will go back
to the AUTO (Automatic) mode. SeeExterior
Lamps on page 144.
Windshield Washer
{CAUTION:
In freezing weather, do not use your
washer until the windshield is warmed.
Otherwise the washer uid can form ice
on the windshield, blocking your vision.
The windshield washer button is located at the
end of the windshield wiper lever.
K(Washer Fluid):Press this button to activate
the washer uid to spray onto the windshield.
The wipers will run for a few cycles to clear the
windshield. For more wash cycles, press and hold
the button.
If the vehicle is low on washer uid, the LOW
WASHER FLUID message will appear on
the Driver Information Center (DIC) display. See
“LOW WASHER FLUID” underDIC Warnings
and Messages on page 200for more information.
139

Instrument Panel Brightness
This feature controls the brightness of the
instrument panel lights.
The interior lamps
control is located on the
instrument panel, to
the left of the steering
column.
Turn the control to adjust the brightness of the
instrument panel lights.
Courtesy Lamps
When a door is opened, the courtesy lamps will
automatically come on. These lamps will also
come on when the interior lamps control is fully
turned clockwise.
Dome Lamp
If the vehicle does not have an overhead console,
it will have a dome light located in the front of
the headliner.
The switch on this lamp has three positions. The
on position will turn on the lamp anytime. The
door position will turn on the lamp whenever
a door is opened. The off position will shut off the
lamp completely, even while a door is opened.
147

Entry Lighting
The entry lighting feature turns the interior lights
on before anyone enters the vehicle. The
interior lamps will come on for 40 seconds when
the doors are unlocked using the remote
keyless entry transmitter and the ignition is in
OFF. After 40 seconds have elapsed, the interior
lamps will slowly fade out. The lamps will fade
out before 40 seconds have elapsed if one of the
following is done:
Lock all doors using the remote keyless entry
transmitter.
Lock the doors using the power door lock
switch.
When any door is opened, entry lighting is
cancelled. The interior lamps will stay on while
any door is opened and slowly fade out when all
doors are closed. The interior lamps may stay
on for up to 25 seconds after all doors have been
closed if they have not been locked.
Delayed Entry Lighting
The delayed lighting feature will continue to light
the interior of the vehicle for 25 seconds after
all the doors have been closed. Delayed lighting
will not occur while the ignition is in RUN or ACC.
After 25 seconds have elapsed, the interior
lamps will slowly fade out. The lamps will fade out
before the 25 seconds have elapsed if one of
the following is done:
The ignition is turned to RUN or ACC.
The doors are locked using the remote keyless
entry transmitter.
The doors are locked using the power door
lock switch.
To turn the delayed lighting feature off or on, see
“Personal Programming Modes” underDIC
Vehicle Customization on page 226DIC Controls
and Displays.
148

Delayed Exit Lighting
For exiting the vehicle at night, the vehicle is
equipped with the delayed exit lighting feature. After
the key is removed from the ignition, the interior
lamps will light for up the amount of seconds set in
the Driver Information Center (DIC). See “Personal
Programming Mode Screens” underDIC Vehicle
Customization on page 226. After the set time has
elapsed, the interior lamps will slowly fade. The
lamps will fade before the set time has elapsed if
one of the following is done:
The ignition is turned to RUN or ACC.
The doors are locked using the remote keyless
entry transmitter.
The doors are locked using the power door lock
switch.
When any door is opened, delayed exit lighting is
cancelled. The interior lamps will stay on while
any door is opened and will slowly fade out when
all the doors are closed. The interior lamps will
stay on for the set time after all the doors
have been closed if they have not been locked.
To turn the delayed exit lighting feature off or on,
see “Personal Programming Mode Screens”
underDIC Vehicle Customization on page 226.
Front Reading Lamps
If the vehicle has a sunroof, there are reading
lamps in front of the sunroof switch located on the
headliner. These lamps will come on when the
doors are opened. Press the side of each reading
lamp to turn them on and off when the doors
are closed.
Overhead Console Reading Lamps
The vehicle may have reading lamps on the
overhead console. These lamps will turn on when
the doors are opened. When the doors are
closed, press the side of each lamp to turn them
on and off.
Rear Assist Handle Reading Lamps
If the vehicle has a reading lamp on each rear
assist handle, press the side of each lamp to turn
it on or off.
149

I II III IIII (Brightness):Turn the outer ring on the
HUD control clockwise to dim the display and
counterclockwise to brighten it.
w(Up):Press this portion of the switch on the
HUD control to move the image up.
x(Down):Press this portion of the switch on
the HUD control to move the image down.
Move the image as low as possible on the
windshield, keeping it in full view.
?(Page):Press this button to select the display
formats. Release the page button when the
format number with the desired display is shown
on the HUD.
Format One:This display gives the
speedometer reading (in English or metric
units), transaxle positions, compass direction,
and the outside air temperature.
Format Two:This display includes the
information in Format One without the compass
direction and the outside air temperature.
Format Three:This display includes all the
information in Format One, but turns the
instrument cluster lighting off. Format three is
only available at night.
All formats will show the turn-by-turn guidance
information. It will display the next turn, direction,
street name, and distance to the selected
destination. When you near your destination, the
HUD will display a distance bar that will ll in
the closer you get to your destination. All
navigation information is provided to the HUD by
the navigation radio, if the vehicle has one.
The warning indicators still appear on the
instrument panel when required. The HUD will
display Stealth Mode On.
The HUD will store the last display format selected.
If the last format displayed was Format One or
Format Three, then Format One will be displayed
when the vehicle is started.
If the last format was Format Two, then Format
Two will be displayed.
154

The HUD image displayed on the windshield will
automatically dim and brighten to compensate
for outside lighting.
The HUD image can temporarily light up
depending on the angle and position of the
sunlight on the HUD display. This is normal and
will change when the angle of the sunlight on
the HUD display changes.
Polarized sunglasses could make the HUD image
harder to see.
Care of the HUD
Clean the inside of the windshield as needed to
remove any dirt or lm that could reduce the
sharpness or clarity of the HUD image.
To clean the HUD lens, use a soft, clean cloth that
has household glass cleaner sprayed on it.
Wipe the HUD lens gently, then dry it. Do not
spray cleaner directly on the lens because
the cleaner could leak into the unit.
If You Cannot See the HUD Image
When the Ignition Is On
Is anything covering the HUD lens?
Is the HUD dimmer setting bright enough?
Is the HUD image adjusted to the proper
height?
Are you wearing polarized sunglasses?
Still no HUD image? Check the fuse in the
instrument panel fuse block. SeeInstrument
Panel Fuse Block on page 460.
If the HUD Image Is Not Clear
Is the HUD image too bright?
Are the windshield and HUD lens clean?
If the HUD image is not correct, contact your
dealer.
Keep in mind that the windshield is part of the
HUD system. SeeWindshield Replacement
on page 399.
155

Fan
9
(Fan):Turn the knob by this symbol, located on
the left side of the climate control panel, clockwise
or counterclockwise to increase or decrease the fan
speed. The fan speed will be temporarily reduced
between the transition to a new mode. The fan will
resume the original speed when the transition to the
new mode is complete.
9(Off):Turn the knob to this position to turn the
climate control system off. Only the heated seat
and/or rear defrost can be operated when the fan
is off.
Mode
Turn the middle knob to select the following modes:
H(Vent) (Outside Air):This mode directs
outside air to the instrument panel outlets. If driving
in city traffic, and the vehicle is stopped and
idling, or the weather is hot, press the recirculation
button. To prevent the air inside the vehicle
from becoming stale, be sure to turn off
recirculation periodically.
)(Bi-Level):This mode directs half of the air to
the instrument panel outlets, and the remaining
air to the oor outlets. Some air may be directed
toward the windshield. Slightly cooler air is directed
to the instrument panel outlets and warmer air is
directed to the oor outlets.
6(Floor):This mode directs most of the air to
the oor outlets with some air directed toward
the side window outlets and a little air directed to
the windshield.
In this mode, the system will automatically use
outside air. The air conditioning compressor will
be engaged unless the outside temperature
is 40°F (4°C) or below.
Recirculation cannot be selected when in this
mode even though the indicator light comes on
when the recirculation button is pressed.
The middle knob on the climate control panel can
also be used to select the defog or defrost mode.
158