2007 PONTIAC GRAND PRIX ignition

3. Put the two halves back together. Make sure
the cover is on tight so water will not get
inside the transmitter.
4. Test the operation of the transmitter with the
vehicle.
Remote Vehicle Start
Your vehicle may have a remote start feature.
This feature allows you to start the engine
from outside the vehicle. It may also start the
vehicle’s heating or air conditioning systems and
rear window defogger. When the remote start
system is active, the climate control system will
heat or cool the inside of the vehicle based on the
outside temperature. The rear window defogger
will be turned on by the climate control system
when it is heating the inside of the vehicle. Normal
operation of the system will return after the key
is turned to RUN.
Laws in some communities may restrict the use of
remote starters. For example, some laws may
require a person using remote start to have
the vehicle in view when doing so. Check local
regulations for any requirements on remote starting
of vehicles.Do not use the remote start feature if your vehicle
is low on fuel. Your vehicle may run out of fuel.
The remote start feature provides two separate
starts per ignition cycle, each with 10 minutes of
engine running time.
The remote start system needs to be reset after
your vehicle’s engine is started two times using the
transmitter’s remote start button. The remote
start system is reset by inserting the vehicle’s key
into the ignition switch and turning to RUN.
SeeIgnition Positions on page 105for information
regarding the ignition positions on your vehicle.
Your remote keyless entry transmitter with
the remote start button provides an increased
range of operation. You can start your vehicle from
about 492 feet (150 m) away. However, the
range may be less while the vehicle is running,
and as a result you may need to be closer to your
vehicle to turn it off than you were to turn it on.
There are other conditions which can affect
the performance of the transmitter, seeRemote
Keyless Entry (RKE) System on page 86for
additional information.
90

/(Remote Start):If your vehicle has the remote
vehicle start feature, the keyless entry transmitter
will have a button with this symbol on it.
To start the vehicle using the remote start feature,
do the following:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter’s lock
button, then immediately press and hold
the transmitter’s remote start button for
4 seconds or until the vehicle’s turn signal
lamps ash. The vehicle’s doors will be
locked.
3. When the vehicle starts, the parking lamps
will turn on and remain on while the engine
is running, and the DIC will display REMOTE
START ACTIVE PRESS HAZARD SWITCH
TO CANCEL.
The engine will shut off automatically after
10 minutes, unless a time extension has been
done or the vehicle’s key is inserted into
the ignition switch and turned to RUN.
If you enter the vehicle after a remote start,
and the engine is still running, insert the
key into the ignition switch and turn to RUN
to drive the vehicle.4. To manually shut off a remote start, do any of
the following. The parking lamps will turn off.
Aim the remote keyless entry transmitter
at the vehicle, and press the remote
start button.
Turn on the hazard warning ashers.
Turn the ignition switch to RUN and then
to OFF.
Your vehicle’s engine can be started two times
using the transmitter’s remote start feature. If only
one remote start procedure has been done,
since last driving the vehicle, or resetting the
remote start system, the engine may be started
again remotely by following the remote start
procedure a second time.
If the remote start procedure is used again before
the rst 10 minute time frame has ended, the
rst 10 minutes will immediately expire and
the second 10 minute time frame will start.
The remote vehicle start feature will not operate if
any of the following occur:
The remote start system is disabled through
the DIC.
The vehicle’s key is in the ignition.
A door on the vehicle is open.
91

The vehicle’s hood is open.
The hazard warning ashers are on.
There is an emission control system
malfunction.
The engine coolant temperature is too high.
The oil pressure is low.
Two remote vehicle starts have already been
provided for that ignition cycle.
If a remote start is attempted and is unsuccessful,
the Driver Information Center (DIC) will display
REMOTE START DISABLED.
Vehicles that have the remote vehicle start feature
are shipped from the factory with the remote start
system enabled. The system may be enabled/
disabled through the DIC. See “REMOTE START”
underDIC Controls and Displays (Base Level DIC)
on page 186orDIC Controls and Displays (Uplevel
DIC with Trip Computer) on page 190for additional
information.
Remote Start Ready
If your vehicle does not have the remote vehicle
start feature, it may have the remote start
ready feature. This feature gives you the ability tolock or unlock your vehicle from about 492 feet
(150 m) away and allows your dealer to add
the manufacturer’s remote vehicle start feature.
See your dealer if you would like to add the
manufacturer’s remote vehicle start feature to
your vehicle.
Doors and Locks
Door Locks
{CAUTION:
Unlocked doors can be dangerous.
Passengers, especially children, can
easily open the doors and fall out of a
moving vehicle. When a door is
locked, the handle will not open it.
You increase the chance of being
thrown out of the vehicle in a crash if
the doors are not locked. So, wear
safety belts properly and lock the
doors whenever you drive.
CAUTION: (Continued)
92

Power Door Locks
To lock or unlock all
doors from inside the
vehicle, use the
power door lock switch
located on either
front door.
Move the switch on the driver’s door to the right to
lock or to the left to unlock the doors. Move the
switch on the passenger’s door to the left to lock or
to the right to unlock the doors.
If the vehicle has the content theft-deterrent
system, the vehicle may be programmed to arm
the system with the power door lock switch.
See “Lock Switch Arm” underDIC Vehicle
Customization on page 226for more information
on programming the system.
Delayed Locking
This feature delays the locking of the vehicle’s
doors for ve seconds after the last door is closed.
Two chimes will sound when the power door
lock switch or the LOCK button on the remote
keyless entry transmitter is pressed when a door
is open. The chimes indicate that the delayed
locking feature is on.
The doors can be locked immediately by pressing
the power door lock switch or the LOCK button
on the transmitter a second time.
The delayed locking feature will not activate when
the ignition is in RUN or ACC.
You can program this feature on or off through the
Driver Information Center (DIC) See “Personal
Programming Mode Screens” underDIC Vehicle
Customization on page 226.
Driver’s Side
94

When you want to open a rear door when the
security lock is on, do the following:
1. Unlock the door using the remote keyless
entry transmitter, if equipped, the power
door lock switch, or by lifting the rear door
manual lock.
2. Open the door from the outside.
To cancel the rear door security lock, do the
following:
1. Unlock the door and open it from the outside.
2. Insert the key into the security lock slot
and turn it so the slot is in the vertical position.
Lockout Protection
The lockout protection feature makes it more
difficult to lock the key in the vehicle. If the driver’s
door is open while the key is in the ignition, the
door cannot be locked with the power door
lock switch.
This feature cannot guarantee that you will never be
locked out of the vehicle. If the key is not left in the
ignition, or, if the manual door lock pin is used, the
key could still be locked inside the vehicle. Always
remember to take the key with you.
Trunk
{CAUTION:
It can be dangerous to drive with the trunk
lid open because carbon monoxide (CO)
gas can come into your vehicle.
You cannot see or smell CO. It can cause
unconsciousness and even death. If you
must drive with the trunk lid open or if
electrical wiring or other cable connections
must pass through the seal between the
body and the trunk lid:
Make sure all other windows are shut.
Turn the fan on your heating or cooling
system to its highest speed and select
the control setting that will force
outside air into your vehicle. See
Climate Control System.
If you have air outlets on or under
the instrument panel, open them all
the way.
SeeEngine Exhaust on page 119.
96

Power Windows
Use the switches on the
driver’s door to operate
each of the windows.
Push the switch down or up to open or close the
window. The top switches operate the front
windows, and the bottom switches operate the
rear windows.
Each passenger door also has a switch, located
on the armrest, that operates that window.
Push the switch rearward or forward to open or
close the window.
The power window switches only work if the ignition
is on or in ACC, or while Retained Accessory
Power (RAP) is active. SeeRetained Accessory
Power (RAP) on page 106for more information.
Express-Down Window
The driver’s window switch has an express-down
feature. This allows the window to open fully without
having to continuously hold the switch. Tap the
switch down, and the driver’s window will open a
small amount. Press the switch fully down and
release and the window will go all the way down.
To stop the window while it is lowering, press the
bottom of the switch. To raise the window,
press and hold the bottom of the switch.
Window Lockout
o
(Window Lockout):The driver’s window
switch includes a lockout feature located above
the power window switches on the driver’s
door. Move the switch to the right to prevent the
passengers sitting in the rear from using their
window switches. The driver can still control all the
windows with the lockout on. Move the switch to
the left to disengage the lockout feature.
99

Arming with the Power Lock Switch
The vehicle’s content theft-deterrent alarm system
can be activated when the key is removed from
the ignition and the power door lock switch
of either the driver’s or front passenger’s door is
used to lock the vehicle. The door needs to
be in the open position when pressing the power
door lock switch. The alarm system will not
activate if the door is closed and the power door
lock switch is pressed. This system can be
activated through the Driver’s Information
Center (DIC). See “Lock Switch Arm” under the
Personal Programming Mode Screens inDIC
Vehicle Customization on page 226.
When the doors are locked using the power door
lock switch of either front door, the red light,
on top of the instrument panel will start ashing
indicating that the system is arming. After all
the doors are closed there will be a time delay and
then the red light will begin to ash at a very
slow rate indicating the system is armed.
Arming with the Remote Keyless Entry
Transmitter
The alarm system will arm when the remote keyless
entry transmitter is used to lock the doors after the
key is removed from the ignition. The red light will
come on to indicate that the system is arming. After
all doors are closed and locked, and after a time
delay, the red light will begin ashing at a very slow
rate to show the system is armed.
Arming Conrmation
A red light located on top of the instrument panel,
towards the center of the vehicle and near the
windshield, will ash slowly to conrm when
the system is armed.
Disarming with the Remote Keyless
Entry Transmitter
The alarm system will disarm when the remote
keyless entry transmitter is used to unlock
the doors. The red light will go out to show that
the system is disarmed.
101

PASS-Key®III Operation
The vehicle is
equipped with
PASS-Key
®III
(Personalized
Automotive Security
System) theft-deterrent
system. PASS-Key
®III
is a passive
theft-deterrent
system.
This means nothing special needs to be done to
arm or disarm the system. It works when the key is
inserted or removed from the ignition.
PASS-Key
®III uses a transponder in the ignition
key that matches a decoder in the vehicle.
When the PASS-Key
®III system senses that the
wrong key has been inserted into the ignition, it
shuts down the vehicle’s starter and fuel systems.The starter will not work and fuel will stop owing to
the engine. If someone tries to start the vehicle
again with the wrong key, the vehicle will not start.
Anyone using a trial-and-error method to start the
vehicle will be discouraged to do so because of the
high number of electrical key codes.
When trying to start the vehicle, if the engine does
not start and the STARTING DISABLED DUE TO
THEFT SYSTEM warning message on the Driver
Information Center (DIC) comes on, the key may
have a damaged transponder. Turn the ignition off
and try again.
If the engine still does not start, and the key
appears to be undamaged, try another ignition key.
At this time, you may also want to check the fuse.
SeeFuses and Circuit Breakers on page 460.Ifthe
engine still does not start with the other key, the
vehicle needs service. If the vehicle does start, the
rst key may be faulty. See your dealer who can
service the PASS-Key
®III to have a new key made.
In an emergency, contact Roadside Assistance.
SeeRoadside Assistance Program on page 498for
more information.
103