2007 PONTIAC GRAND PRIX oil dipstick

A. Windshield Washer Fluid Reservoir. See
“Adding Washer Fluid” underWindshield
Washer Fluid on page 377.
B. Battery. SeeBattery on page 381.
C. Remote Positive (+) Terminal. SeeJump
Starting on page 382.
D. Underhood Fuse Block. SeeUnderhood Fuse
Block on page 462.
E. Engine Coolant Recovery Tank. SeeCooling
System on page 366.
F. Pressure Cap. SeePressure Cap on page 364.
G. Power Steering Fluid Reservoir (low in
engine compartment). SeePower Steering
Fluid on page 376.
H. Supercharger Oil Fill Location (If Equipped).
SeeSupercharger Oil on page 355.I. Electric Cooling Fan. SeeCooling System on
page 366.
J. Engine Oil Dipstick. See “Checking Engine Oil”
underEngine Oil on page 350.
K. Engine Oil Fill Cap. See “When to Add Engine
Oil” underEngine Oil on page 350.
L. Engine Coolant Bleed Valve. See “How to Add
Coolant to the Radiator” underCooling
System on page 366.
M. Automatic Transaxle Fluid Dipstick. See
“Checking the Fluid Level” underAutomatic
Transaxle Fluid on page 357.
N. Brake Master Cylinder Reservoir. See “Brake
Fluid” underBrakes on page 378.
O. Engine Air Cleaner/Filter. SeeEngine Air
Cleaner/Filter on page 355.
347

A. Windshield Washer Fluid Reservoir. See
“Adding Washer Fluid” underWindshield
Washer Fluid on page 377.
B. Battery. SeeBattery on page 381.
C. Underhood Fuse Block. SeeUnderhood Fuse
Block on page 462.
D. Remote Positive (+) Terminal. SeeJump
Starting on page 382.
E. Pressure Cap. SeePressure Cap on page 364.
F. Power Steering Fluid Reservoir. SeePower
Steering Fluid on page 376.
G. Engine Oil Dipstick. See “Checking Engine Oil”
underEngine Oil on page 350.H. Engine Oil Fill Cap. See “When to Add Engine
Oil” underEngine Oil on page 350.
I. Automatic Transaxle Fluid Dipstick. See
“Checking the Fluid Level” underAutomatic
Transaxle Fluid on page 357.
J. Brake Master Cylinder Reservoir. See “Brake
Fluid” underBrakes on page 378.
K. Engine Air Cleaner/Filter. SeeEngine Air
Cleaner/Filter on page 355.
L. Engine Coolant Recovery Tank. SeeCooling
System on page 366.
349

Engine Oil
If this symbol, along with
the LOW OIL LEVEL
message appears on the
Driver Information
Center (DIC), it means
you need to check
the engine oil level
right away.
For more information, see LOW OIL LEVEL under
DIC Warnings and Messages on page 200. You
should check the engine oil level regularly;
this is an added reminder.
Checking Engine Oil
It is a good idea to check the engine oil every time
you get fuel. In order to get an accurate reading,
the oil must be warm and the vehicle must be
on level ground.
The engine oil dipstick handle is a yellow loop.
SeeEngine Compartment Overview on page 346
for the location of the engine oil dipstick.
1. Turn off the engine and give the oil
several minutes to drain back into the oil pan.
If you do not do this, the oil dipstick might
not show the actual level.
2. Pull out the dipstick and clean it with a paper
towel or cloth, then push it back in all the
way. Remove it again, keeping the tip down,
and check the level.
350

When to Add Engine Oil
If the oil is below the cross-hatched area at the tip
of the dipstick, you will need to add at least one
quart/liter of oil. But you must use the right kind.This section explains what kind of oil to use. For
engine oil crankcase capacity, seeCapacities and
Specications on page 466.
Notice:Do not add too much oil. If the engine
has so much oil that the oil level gets above
the cross-hatched area that shows the
proper operating range, the engine could be
damaged.
SeeEngine
Compartment Overview
on page 346for the
location of the engine oil
ll cap.
Be sure to add enough oil to put the level
somewhere in the proper operating range in the
cross-hatched area. Push the dipstick all the
way back in when you are through.
3800 V6 Engine
5.3L V8 Engine
351

How to Add Automatic Transaxle Fluid
Refer to the Maintenance Schedule to determine
what kind of transaxle uid to use. See
Recommended Fluids and Lubricants on page 483.
If the uid level is low, add only enough of the
proper uid to bring the level into the crosshatched
area on the dipstick.
1. Pull out the dipstick.
2. Using a long-neck funnel, add enough uid at
the dipstick hole to bring it to the proper level.
It does not take much uid, generally less
than one pint (0.5 L). Do not overll.
Notice:Use of the incorrect automatic
transaxle uid may damage your vehicle, and
the damages may not be covered by your
warranty. Always use the automatic transaxle
uid listed inRecommended Fluids and
Lubricants on page 483.
3. After adding uid, recheck the uid level as
described under “How to Check Automatic
Transaxle Fluid,” earlier in this section.
4. When the correct uid level is obtained, push
the dipstick back in all the way.
Engine Coolant
The cooling system in the vehicle is lled with
DEX-COOL®engine coolant. This coolant
is designed to remain in the vehicle for ve years
or 150,000 miles (240 000 km), whichever
occurs rst, if only DEX-COOL
®extended life
coolant is added.
The following explains the cooling system and
how to add coolant when it is low. If there is
a problem with engine overheating or if coolant
needs to be added to the radiator, seeEngine
Overheating on page 364.
A 50/50 mixture of clean, drinkable water and
DEX-COOL
®engine coolant will:
Give freezing protection down to
−34°F (−37°C).
Give boiling protection up to 265°F (129°C).
Protect against rust and corrosion.
Help keep the proper engine temperature.
Let the warning lights and gages work as they
should.
360