2007 PONTIAC GRAND PRIX ignition

Sunroof
If the vehicle has a sunroof, it includes a sliding
glass panel and a sunshade.
The switch to control
the sunroof is located
in the headliner.
The switch works only while the ignition is on, or in
ACC, or Retained Accessory Power (RAP) is on.
SeeRetained Accessory Power (RAP) on
page 106.Vent:Open the sunshade by hand. Push the switch
toward the rear of the vehicle once and the sunroof
will open to the vent position. Push the switch
forward to close.
Open/Express-Open:Push the switch toward the
rear of the vehicle a second time and the sunroof
will open the remainder of the way. The sunshade
will open with the sunroof if the switch is pushed
toward the rear of the vehicle twice.
Close:Push and hold the front of the switch until
the sunroof motor stops. The sunshade must
be closed by hand.
128

The main components of the instrument panel are the following:
A. Side Window Defogger Outlets. SeeOutlet
Adjustment on page 166.
B. Air Outlets. SeeOutlet Adjustment on page 166.
C. Turn Signal/Multifunction Lever and Cruise
Controls. SeeTurn Signal/Multifunction Lever
on page 135andCruise Control on page 140.
D. TAP-Shift
®Control (If Equipped). See
Automatic Transaxle Operation on page 110.
E. Hazard Warning Flashers Button. See
Hazard Warning Flashers on page 134.
F. Instrument Panel Cluster. SeeInstrument Panel
Cluster on page 169.
G. Windshield Wiper Lever. SeeWindshield Wiper
Lever on page 138.
H. Ignition. SeeIgnition Positions on page 105.
I. Driver Information Center (DIC) (If Equipped).
SeeDriver Information Center (DIC) on
page 186.
J. Audio System. SeeAudio System(s) on
page 233.K. Audio Steering Wheel Controls (If Equipped).
SeeAudio Steering Wheel Controls on
page 277.
L. Hood Release. SeeHood Release on page 345.
M. Tilt Steering Wheel Lever, on Steering Column.
SeeTilt Wheel on page 135.
N. Interior Lamps Brightness Control. SeeInterior
Lamps on page 146.
O. Passenger Air Bag Status Indicator. See
Passenger Airbag Status Indicator on page 173.
P. Climate Controls. SeeClimate Control
System on page 157.
Q. Shift Lever. SeeAutomatic Transaxle Operation
on page 110.
R. Traction Control Button (If Equipped). See
Traction Control System (TCS) on page 292.
S. Head Up Display (HUD) Control (If Equipped).
SeeHead-Up Display (HUD) on page 151.
T. Glove Box. SeeGlove Box on page 126.
U. Instrument Panel Fuse Block. SeeInstrument
Panel Fuse Block on page 460.
133

Hazard Warning Flashers
The hazard warning ashers warn others. They
also let police know you have a problem.
Your front and rear turn signal lamps will ash on
and off.
The hazard warning
asher button is located
on top of the steering
column.
The hazard warning ashers work no matter what
ignition position the key is in, and even if the
key is not in the ignition.Press the button to make the front and rear turn
signal lamps ash on and off. Press the button
again to turn the ashers off.
When the hazard warning ashers are on, your
turn signals will not work.
Other Warning Devices
If you carry reective triangles, you can set them up
at the side of the road about 300 feet (100 m)
behind your vehicle.
Horn
Press on or near the horn symbols on the steering
wheel pad to sound the horn.
134

Reducing Speed While Using
Cruise Control
There are two ways to reduce the vehicle’s speed
while using cruise control:
Press and hold the set button until you reach
the lower speed desired, then release it.
To slow down in very small amounts,
briey press the set button. Each time you do
this your vehicle will slow down about
one mph (1.6 km/h).
Passing Another Vehicle While Using
Cruise Control
Use the accelerator pedal to increase the vehicle’s
speed. When you take your foot off the pedal,
the vehicle will slow down to the cruise control
speed set earlier.
Using Cruise Control on Hills
How well the cruise control will work on hills
depends upon the vehicle’s speed, its load, and
the steepness of the hills. When going up
steep hills, the accelerator pedal might have to be
used in order to maintain the vehicle’s speed.
When going downhill, the brakes might have to be
applied, or the transaxle might have to be
shifted to a lower gear to keep the vehicle’s speed
down. Doing either of these things will take the
vehicle out of cruise. It may be better not to
use the cruise control if the brakes constantly have
to be applied, or the vehicle continuously needs
to be shifted to a lower gear.
Ending Cruise Control
There are two ways to turn off the cruise control:
Step lightly on the brake pedal
Move the cruise control switch to off
Erasing Speed Memory
When the cruise control or the ignition is turned
off, the cruise control set speed memory is erased.
143

Exterior Lamps
The exterior lamp control is located to the left of
the steering wheel on the multifunction lever.
O(Exterior Lamp Control):Turn the band with
this symbol on it to operate the exterior lamps.
The exterior lamp band has four positions:
O(Off):Turning the band to this position turns
off all lamps.
AUTO (Automatic):Turning the band to this
position sets the exterior lamps in automatic mode.
AUTO mode will turn the exterior lamps on and
off depending on how much light is available
outside the vehicle.To override AUTO mode, turn the control to off.
To reset to AUTO mode turn the control to exterior
lamps and then back to AUTO. Automatic mode
will also reset when your vehicle is turned off
and then back on again when the control is left in
the AUTO position.
;(Parking Lamp):Turning the band to this
position turns on the parking lamps together with
the following:
Sidemarker Lamps
Taillamps
License Plate Lamps
Instrument Panel Lights
The parking brake indicator light will come on and
stay on when the parking lamps are on with the
engine off and the ignition to ACC.
5(Headlamps):Turning the control to this
position turns on the headlamps, together with the
previously listed lamps and lights.
144

Headlamps on Reminder
A warning chime will sound if the vehicle’s ignition
is off and the driver’s door is opened when the
exterior lamp control is left on in either the
headlamp or parking lamp position.
Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) can make it easier
for others to see the front of your vehicle during
the day. DRL can be helpful in many different
driving conditions, but they can be especially
helpful in the short periods after dawn and before
sunset. Daytime running lamps are required to
function at all times on all vehicles rst sold
in Canada.
A light sensor on top of the instrument panel
makes the DRL work, so be sure it is not covered.
The DRL system will make the low-beam
headlamps come on at reduced brightness when
the following conditions are met:
The ignition is on.
The exterior lamps control is off.
The parking brake is released.While the DRL are on, only the vehicle’s low-beam
headlamps will be on at reduced brightness.
The turn signal, taillamps, sidemarker and other
lamps will not be on. The instrument panel cluster
will not be lit up either.
When it is dark enough outside, the DRL will turn
off and the vehicle’s headlamps and parking
lamps will turn on. The other lamps that come on
with the headlamps will also come on.
When it is bright enough outside, the headlamps
will go off and the DRL will come on.
To idle the vehicle with the DRL off, turn the
exterior lamp control off and then do one of the
following:
Turn the exterior lamp control to the parking
lamp position.
Turn the exterior lamp control to the headlamp
position.
Turn the exterior lamp control from AUTO to
off and back to AUTO.
This feature is not available for vehicles rst sold
in Canada.
145

To turn off the automatic headlamp feature when it
is dark outside, move the exterior lamp control
to the parking lamp position. The parking lamps
will remain illuminated and the headlamps will turn
off. The fog lamps will also go on if they were
on previously.
As with any vehicle, the regular headlamp system
should be turned on when needed.
Fog Lamps
If equipped, fog lamps provide brighter roadway
lighting for better vision in foggy or misty
conditions.
-(Fog Lamps):Turn the second band on the
exterior lamps control lever to this position to
turn the fog lamps on. The band will return to its
original position.
This symbol appears on
the instrument panel
cluster when the
fog lamps are on.To turn the fog lamps off, turn the band up to the
fog lamp symbol and release it. The band will
return to its original position. If the high-beam
headlamps are on, the fog lamps will turn off. The
fog lamps will go on again when the low-beam
headlamps are turned back on.
The parking lamps must be on for the fog lamps
to work.
Some localities have laws that require the
headlamps to be on along with the fog lamps.
Exterior Lighting Battery Saver
If the parking lamps or headlamps have been left
on after the ignition has been turned to off, the
exterior lamps will turn off after about 10 minutes.
This protects the battery from being drained.
Use the exterior lamp control to turn the lamps
back on, if they are still needed.
Interior Lamps
The interior lamps can be controlled, or
automatically turn on or off under certain conditions.
They are explained in the following text.
146

Entry Lighting
The entry lighting feature turns the interior lights
on before anyone enters the vehicle. The
interior lamps will come on for 40 seconds when
the doors are unlocked using the remote
keyless entry transmitter and the ignition is in
OFF. After 40 seconds have elapsed, the interior
lamps will slowly fade out. The lamps will fade
out before 40 seconds have elapsed if one of the
following is done:
Lock all doors using the remote keyless entry
transmitter.
Lock the doors using the power door lock
switch.
When any door is opened, entry lighting is
cancelled. The interior lamps will stay on while
any door is opened and slowly fade out when all
doors are closed. The interior lamps may stay
on for up to 25 seconds after all doors have been
closed if they have not been locked.
Delayed Entry Lighting
The delayed lighting feature will continue to light
the interior of the vehicle for 25 seconds after
all the doors have been closed. Delayed lighting
will not occur while the ignition is in RUN or ACC.
After 25 seconds have elapsed, the interior
lamps will slowly fade out. The lamps will fade out
before the 25 seconds have elapsed if one of
the following is done:
The ignition is turned to RUN or ACC.
The doors are locked using the remote keyless
entry transmitter.
The doors are locked using the power door
lock switch.
To turn the delayed lighting feature off or on, see
“Personal Programming Modes” underDIC
Vehicle Customization on page 226DIC Controls
and Displays.
148