SRS-42
SPIRAL CABLE
Revision: 2006 November2007 350Z
SPIRAL CABLEPFP:25554
Removal and InstallationNHS0000U
REMOVAL
CAUTION:
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least
3 minutes.
Do not use air tools or electric tools for servicing.
1. Remove driver air bag module. Refer to SRS-40, "
Removal and Installation" .
2. Disconnect horn switch connector.
3. Set the steering wheel in the neutral position.
4. Remove steering wheel. Refer to PS-7, "
STEERING WHEEL" .
5. Remove combination meter assembly. Refer to DI-24, "
Removal and Installation for Combination Meter" .
6. Loosen the spiral cable fixing screws, and then remove the spiral cable.
CAUTION:
Do not disassemble spiral cable.
Do not apply lubricant to the spiral cable.
7. Remove the horn switch connector and then remove spiral cable
connector.
CAUTION:
Also, with the steering linkage disconnected the cable may
snap by turning the steering wheel beyond the limited num-
ber of turns.
1. Steering wheel 2. Driver air bag module connector 3. Spiral cable
4. Screw (Do not remove) 5. Wiper and washer switch 6. Screw
7. Sreering column assembly 8. Combination meter 9. Lighting and turn signal switch
PHIA1255E
SHIA0193E
