REAR PROPELLER SHAFT
PR-9
C
E
F
G
H
I
J
K
L
MA
B
PR
Revision: 2006 November2007 350Z
When Installing Reused Propeller Shaft
CAUTION:
When installing propeller shaft, handle it carefully.
1. With protector (special service tool) attached, align matching marks to install propeller shaft to final drive
companion flange, and then tighten to specified torque. Refer to PR-6, "
Components" .
2. Remove protector (special service tool) from propeller shaft.
3. Return exhaust system to its original position. For tightening torque, EX-3, "
EXHAUST SYSTEM" .
4. After assembly, perform a driving test to check propeller shaft vibration. If vibration occurred, separate
propeller shaft from final drive. Reinstall companion flange after rotating it by 90, 180, 270 degrees. Then
perform driving test and check propeller shaft vibration again at each point.
PR-10
SERVICE DATA AND SPECIFICATIONS (SDS)
Revision: 2006 November2007 350Z
SERVICE DATA AND SPECIFICATIONS (SDS)PFP:00030
General SpecificationsNDS00007
Propeller Shaft Runout LimitNDS00008
Applied modelVQ35DE
M/T A/T
Propeller shaft model 2S80A CFRP
Number of joints2
Coupling method with transmission Sleeve type
Type of journal bearings Shell type (Non-disassembly type)
Distance between yokes 95 mm (3.74 in)
Shaft length (Spider to spider) 1321 mm (52.007 in) 1283 mm (50.512 in)
Shaft outer diameter 85.0 mm (3.346 in)
Model2S80A CFRP
Propeller shaft runout limit 1.5 mm (0.059 in) or less
