PR-4
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
Revision: 2006 November2007 350Z
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTINGPFP:00003
NVH Troubleshooting ChartNDS00003
Use the chart below to help you find the cause of the symptom. If necessary, repair or replace these parts.
×: ApplicableReference page
PR-5—
—
—
—
PR-5PR-7
NVH in RFD section
NVH in FAX, RAX, FSU, and RSU section
NVH in WT section
NVH in WT section
NVH in RAX section
NVH in BR section
NVH in PS section
Possible cause and SUSPECTED PARTS
Uneven rotating torque
Center bearing improper installation
Excessive center bearing axial end play
Center bearing mounting (insulator) cracks, damage or deterioration
Excessive joint angle
Rotation imbalance
Excessive runout
DIFFERENTIAL
AXLE AND SUSPENSION
TIRES
ROAD WHEEL
DRIVE SHAFT
BRAKES
STEERING
SymptomNoise××××××××××××××
Shake× × ××××××
Vibration××××××× ×× × ×
PR-6
REAR PROPELLER SHAFT
Revision: 2006 November2007 350Z
ComponentsNDS00005
Removal and InstallationNDS00006
REMOVAL
1. Set transmission to neutral position.
2. Release parking brake.
3. To keep space for removing propeller shaft, first detach rear-side
mounts (4 locations) of exhaust tube and main muffler. Then
lower exhaust tube and main muffler, and support them with jack
or equivalent. (See the figure.)
4. Attach protector (special service tool) to propeller shaft. (When
reused.)
1. Propeller shaft
PDIA0645E
PDIA1274E
Tool number : — (J-46208)
SDIA1091E