BR-10
BRAKE FLUID
Revision: 2006 November2007 350Z
BRAKE FLUIDPFP:KN100
On-Vehicle InspectionNFS00008
LEVEL CHECK
Check that the fluid level in the reservoir tank is within the stan-
dard (between MAX and MIN lines).
Visually check around the reservoir tank for fluid leaks.
If fluid level is excessively low, check brake system for leaks.
If warning lamp remains illuminated after parking lever is
released, check brake system for fluid leakage.
Drain and RefillNFS00009
CAUTION:
Refill with new brake fluid “DOT3”.
Do not reuse drained brake fluid.
Do not let brake fluid come in contact with painted surfaces on the body. This might damage the
paint, so if it does come in contact, immediately wipe area and wash off with water.
1. Connect a vinyl tube to bleed valve.
2. Depress the brake pedal, loosen the bleed valve, and gradually
remove the brake fluid.
3. Before working, turn the ignition switch OFF and disconnect the
connectors of ABS actuator and control unit or battery negative
terminal.
4. Make sure there is no foreign material in the reservoir tank, and
refill with new brake fluid.
5. Rest foot on brake pedal. Loosen bleed valve. Slowly depress
pedal until it stops. Tighten bleed valve. Release brake pedal.
Repeat this process a few times, then pause to add new brake
fluid to master cylinder. Continue until new brake fluid flows out.
Bleed Air. Refer to BR-11, "
Bleeding Brake System" .
SBR451D
BRA0007D
BRA0006D
