REAR DISC BRAKE
BR-49
C
D
E
G
H
I
J
K
L
MA
B
BR
Revision: 2006 November2007 350Z
Disassembly and Assembly of Brake Caliper Assembly (With Brembo Calipers)NFS00018
DISASSEMBLY
1. Insert a piece of wood as shown in the figure, blow air in through
the flare nut mounting hole, and remove the piston and piston
boot.
CAUTION:
Do not get fingers caught in the piston.
2. Remove the piston boot from the piston.
3. Using a flat-bladed screwdriver, remove the piston seal.
CAUTION:
Be careful not to damage cylinder inner wall.
Never remove the four bolts from the inner and outer
sides of the caliper. Do not tighten them further, either.
CALIPER INSPECTION
Caliper
CAUTION:
Use new brake fluid to clean. Never use mineral oils such as gasoline or kerosene.
Check for corrosion, wear, or damage to the cylinder inner wall, and replace the caliper if there are
any non-standard conditions.
Piston
CAUTION:
Since the piston surface is plated, do not repair using sandpaper.
Check piston surface for corrosion, wear, and damage. If any non-standard condition is detected,
replace applicable part.
ASSEMBLY
1. Apply polyglycol ether based lubricant to the piston seal (1), and
install them to the cylinder body.
CAUTION:
Do not reuse piston seal.
PFIA0281E
SFIA1321E
PFIA0872E
