2007 NISSAN 350Z turn signal

TROUBLE DIAGNOSIS FOR SYSTEM
BRC-121
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
MA
B
BRC
Revision: 2006 November2007 350Z
3. CHECK VDC/TCS/ABS CONTROL UNIT POWER AND GROUND CIRCUIT
1. Disconnect VDC/TCS/ABS control unit connector B114.
2. With the ignition switch turned on and off, check voltage
between VDC/TCS/ABS control unit connector and ground.
3. Check continuity between VDC/TCS/ABS control unit and
ground.
OK or NG
OK >> Check battery (terminal looseness, low voltage, etc.) For
any non-standard condition. If any non-standard condi-
tion exists, recharge or replace battery as necessary.
NG >> The corresponding harness circuit is open or shorted.
Repair the circuit.
VDC/TCS/ABS Control Unit 2NFS0004O
INSPECTION PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
Check self-diagnosis results.
When any item other than “EMERGENCY BRAKE” is indicated in self-diagnosis display, follow the instructions
below.
CAUTION:
“EMERGENCY BRAKE” is indicated when control unit itself is detected as an error. If this display item
is indicated, replace control unit.
Is the above displayed in the self-diagnosis display items?
YES >> Replace VDC/TCS/ABS control unit and re-conduct the self-diagnosis.
NO >> INSPECTION END
Brake Fluid Level Switch SystemNFS0004P
INSPECTION PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
1. Check brake reservoir tank fluid level. If the level is low, add brake fluid.
2. Erase the self-diagnosis results and check self-diagnosis results.
Is the above displayed in the self-diagnosis display items?
YES >> GO TO 2.
NO >> INSPECTION END
Signal name VDC/TCS/ABS control unit Ground Voltage
Power supply 1 —Battery voltage
(Approx. 12 V)
SFIA1903E
Signal name VDC/TCS/ABS control unit Ground Continuity
Ground 28, 29 — Yes
SFIA1897E
Self-diagnosis results
EMERGENCY BRAKE
Self-diagnosis results
BR FLUID LEVEL LOW