2007 MERCEDES-BENZ SLR CLASS Owners Manual

296 Operation
Vehicle care
Vehicle washing
Hand-wash
Do not use hot water or wash your vehicle
in direct sunlight.
Only use a mild car wash detergent,
which is recommended by
Mercedes-Benz.
Only use a soft sponge or a washing
brush.
Thoroughly spray the vehicle with a
diffused jet of water.
Direct only a very weak spray towards
the ventilation intake.
Use plenty of water and rinse the
sponge and chamois frequently.
Rinse with clean water and thoroughly
dry with a chamois.
Do not allow cleaning agents to dry on
the finish.
Automatic car wash
You can have your car washed in an auto-
matic car wash from the start. Automatic
car washes without brushes are
preferable.
To protect the filter system, switch the
automatic climate control to air
recirculation mode (
page 195).
If the vehicle is very dirty, prewash it be-
fore running it through the automatic car
wash.!When washing the vehicle, fine and rigid
particles in sponges or brushes could scratch or
otherwise damage the paint. This applies to
both, hand-wash or automatic car wash.
Mercedes-Benz recommends you to have your
vehicle cleaned at an automatic car wash from
the start, preferably one without brushes, or to
use plenty of water when hand-washing your
vehicle.
Do not wash the car in direct sunlight and when
the body surface is hot.
In the winter, remove salt residue quickly and
thoroughly.
!Do not use scouring agents on these parts.
Never apply strong force and only use a soft,
non-scratching cloth when cleaning the vehicle.
Do not attempt to wipe the surface with a dry
cloth or sponge.
Otherwise you may scratch or damage the paint.
!Do not clean your vehicle in an automatic
touchless car wash which uses caustic spray.
Otherwise, the caustic spray will damage the
paint or ornamental moldings.
!Make sure that the windshield wiper switch
is set to0 (
page 52). Otherwise, the rain
sensor could activate and cause the wipers to
move unintentionally. This may lead to vehicle
damage.
Due to the width of the vehicle, fold in exterior
rear view mirrors prior to running the vehicle
through an automatic car wash to prevent
damage to the mirrors.
iAfter running the vehicle through an auto-
matic car wash, wipe any wax off of the wind-
shield (
page 297). This will prevent smears
and reduce wiping noise which can be caused by
residual wax on the windshield.

297 Operation
Vehicle care
Power washer
Cleaning the windows and wiper blades
Remove the SmartKey from the starter
switch.
Fold the wiper arm away from the
windshield (
page 361).
You must feel the wiper arm engage in
position.
Clean the wiper blade inserts with a
clean cloth and detergent solution.
Use a soft, clean cloth and a mild win-
dow cleaning solution on all outside
and inside glass surfaces.
An automotive glass cleaner is
recommended.Cleaning the headlamps
Wipe the headlamp lens with a damp
sponge.
!Do not use power washer to clean your
vehicle or the engine.
!The hood must be opened (page 250) be-
fore folding the wiper arm away from the wind-
shield. You could otherwise damage the hood
and/or the wiper arms.
!Never open or close the hood when the wip-
er arms are folded away from the windshield.
You could otherwise damage the hood and/or
the wiper arm.
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch
before cleaning the wiper blades. Otherwise
the wiper motor could suddenly turn on and
cause injury.
!Do not pull on the wiper blade inserts. They
could tear.
!To clean the window interior, do not use a
dry cloth, abrasives, solvents or cleaners con-
taining solvents. Do not touch the inside of the
front, rear or side windows with hard objects
such as an ice scraper or ring. Doing so may
damage the windows.
!Fold the windshield wiper arms back onto
the windshield before turning the SmartKey in
the starter switch.
Hold on to the wiper when folding the wiper arm
back. If released, the force of the impact from
the tensioning spring could crack the windshield.
!Only use windshield washer fluid suitable
for plastic lamp lenses. Unsuitable windshield
washer fluid may cause damage to the plastic
lenses of the headlamps.
Do not use

a dry cloth

abrasive products

solvents

cleaning agents containing solvents
You could otherwise scratch or damage the lens
surface.

Practical hints
What to do if ...
Where will I find ...?
Unlocking in an emergency
Replacing SmartKey batteries
Replacing bulbs
Replacing wiper blades
Flat tire
Batteries
Towing the vehicle
Fuses

300 Practical hints
What to do if ...
Lamps in instrument clusterGeneral information:
If any of the following lamps in the instru-
ment cluster fails to come on during the bulb self-check when switching on the
ignition, have the respective bulb checked
and replaced if necessary.
ProblemPossible cause/consequenceSuggested solutions
vThe yellow ABS/ESP® warn-
ing lamp comes on while the
engine is running.Risk of accident!
The ESP
® has been switched off.
When the ESP
® is switched off it will not
stabilize the vehicle if the system recog-
nizes that the vehicle starts to skid or that
a wheel is spinning.
Switch the ESP® back on (page 86).
Exceptions: (
page 85).
If leaving the ESP® switched off, adapt your
speed and driving to the prevailing road and
weather conditions.
If the ESP
® cannot be switched on:
Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.
Risk of accident!
The ESP
® is not operational due to a
malfunction.
Read and observe additional messages in
the multifunction display (
page 314).
Continue driving with added caution.
Adapt your speed and driving to the prevail-
ing road and weather conditions.
Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.

301 Practical hints
What to do if ...
ProblemPossible cause/consequenceSuggested solutions
vThe yellow ABS/ESP® warn-
ing lamp flashes while
driving.Risk of accident!
The ESP
®, ABS, or traction control has
come into operation because of detected
traction loss in at least one tire.
The cruise control is deactivated.
When driving off, apply as little throttle as
possible.
While driving, ease up on the accelerator.
Adapt your speed and driving to the prevail-
ing road and weather conditions.
Do not deactivate ESP®.
Exceptions: (
page 85).
Failure to follow these instructions increases
the risk of an accident.

302 Practical hints
What to do if ...
ProblemPossible cause/consequenceSuggested solutions
-The yellow ABS indicator
lamp comes on while the
engine is running.Risk of accident!
The ABS has detected a malfunction and
has switched off. The BAS and the ESP
®
are also switched off.
If the ABS control unit is malfunctioning,
other systems such as the automatic
transmission may also be malfunctioning.
The electro-hydraulic brake system is still
functioning normally but without ABS
available.
Continue driving with added caution. Wheels
may lock during hard braking, reducing
steering capability.
Have the system checked at an authorized
Mercedes-Benz Center immediately.
Failure to follow these instructions increases
the risk of an accident.
Read and observe messages in the
multifunction display (
page 314).
The charging voltage has fallen below
10 volts. The ABS has switched off.
The battery may not be charged
sufficiently.When the voltage is above this value again, the
ABS is operational again and the ABS indicator
lamp should go out.
If the ABS indicator lamp does not go out:
Have the generator (alternator) and the
battery checked.

303 Practical hints
What to do if ...
ProblemPossible cause/consequenceSuggested solutions
3(Canada only)
;(USA only)
The red brake warning lamp
comes on while driving and
you hear a warning sound.
You are driving with the parking brake set.Release the parking brake (page 49).
3(Canada only)
;(USA only)
The red brake warning lamp
comes on while the engine is
running and you hear a
warning sound.
Risk of accident!

There is a malfunction in the
electro-hydraulic brake system.

There is insufficient brake fluid in the
reservoir.
Carefully stop the vehicle in a safe location
or as soon as it is safe to do so and contact
an authorized Mercedes-Benz Center. Do
not add brake fluid! This will not solve the
problem.
Read and observe messages in the
multifunction display (
page 314).
Warning!G
Driving with the brake warning lamp illumi-
nated can result in an accident. Have your
brake system checked immediately if the
brake warning lamp stays on. Do not add
brake fluid before checking the brake
system.
Overfilling the brake fluid reservoir can re-
sult in spilling brake fluid on hot engine
parts and the brake fluid catching fire. You
can be seriously burned.
!If you find that the brake fluid in the brake
fluid reservoir has fallen to the minimum mark or
below, have the brake system checked for brake
pad thickness and leaks.