2007 Lancia Musa heating

95
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
These operating conditions are obtained pressing in
sequence the air recirculation button C.
After a preset time, the climate control system will
turn air recirculation off automatically for safety
reasons, thus enabling outside air inlet.IMPORTANT The air recirculation system
makes it possible to reach the required heating or
cooling conditions faster.
It is however inadvisable to use it on rainy/cold
days as it would considerably increase the
possibility of the windows misting inside, especially
if the climate control system is off.
When the outside temperature is below 5-7°C, air
recirculation is switched off (air is taken from the
outside) to prevent misting.
WARNINGIt is inadvisable to use the air recirculation feature with low outside temperature
as the windows might mist over quickly.

97
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
Button for fast windscreen and
front side window
demisting/defrosting F
Press this button: the climate control
system will automatically switch on
all the functions required for fast windscreen and
front side window demisting/defrosting, that is:
❒climate control system compressor on (with
proper climatic conditions);
❒air recirculation off;
❒maximum air temperature HI on both areas;
❒fan speed according to engine coolant
temperature in order to limit letting cold air into
the passenger compartment for demisting the
windows;
❒air flow directed to the windscreen and front side
window vents;
❒heated rear windowIMPORTANT The fast windscreen
demisting/defrosting function stays on for approx.
3 minutes after the engine coolant temperature
exceeds 50°C (petrol versions) or 35°C
(Multijet versions).
When the max. demisting/defrosting function is on,
the led on the relevant button and that on the
heated rear window button turn on. Message FULL
AUTO on the display will turn off.
When the max. demisting/defrosting function is on,
the only manual operations possible are manual
adjustment of the fan and switching rear window
heating off.
Press button F or air recirculation button C or
compressor button B or AUTO buttons N o H to
reset the previous system operation conditions.

98
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
Button for demisting/defrosting
the heated rear window and door
mirrors G
Press this button to switch on the
heated rear window
demisting/defrosting function. The led on the
button will come on.
This function will be automatically switched off
after the preset time, or pressing the button again or
when stopping the engine. It will not start up
automatically when the engine is started again.
IMPORTANT Do not apply stickers on the inside of
the rear window over the heating filaments to avoid
damage that might cause it to stop working
properly.❒climate control system compressor off;
❒fan off.
The heated rear window can be switched on and off
normally when the system is off by pressing button
G.
IMPORTANT The climate control system electronic
unit stores the system settings made before the
system was switched off and restores them as soon
as a button is pressed (with the exception of the
heated rear window button). The function which
the button corresponds to will be switched on, if it
was off when the system was switched off. It will be
kept if, on the other hand, it was on when the
system was switched off.
Press the AUTO button to switch the climate control
system back on.
OFF button E (system off)
To switch the climate control system
off, press button E, also the display
will go off.
The climate control system
conditions when the system is off are the following:
❒Every led off;
❒set temperatures not displayed;
❒air recirculation on, thus isolating the passenger
compartment;

FAILURE WARNINGS
Any electric power steering failure is indicated by
cluster warning light gcoming on (together, with
the message on the multifunction display - see the
“Warning lights” chapter).
In the event of electric power steering failure, the
car can be driven with mechanical steering to the
closest Lancia Dealership.IMPORTANT The steering may become slightly stiff
following parking manoeuvres including a great
deal of steering. This is normal and caused by the
system to prevent motor overheating. No servicing is
required. The electrical power steering system will
return to normal operation the next time the car is
used.
151
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
WARNING
Always switch the engine off, remove the key from the starting device and actuate
the steering lock before carrying out any maintenance operation, especially when
the wheels are raised from the ground. In case this is not possible (e.g. when the
key must be in MAR position or the engine running), remove the electric power
steering main fuse before carrying out any maintenance operation.

PRETENSIONERS
To increase the efficiency of the seat belts, the car is
fitted with pretensioners. These devices, in the event
of a violent crash, rewind the seat belts a few
centimetres. In this way they ensure that the seat
belt adheres perfectly to the wearer before the
restraining action begins.
The seat belt locks to indicate that the device has
intervened; the seat belt cannot be drawn back up
even when guiding it manually.IMPORTANT To obtain the highest degree of
protection from the action of the pretensioning
device, wear the seat belt keeping it firmly close to
the chest and pelvis.
A small amount of smoke may be produced. This
smoke is in no way toxic and presents no fire
hazard.
The pretensioner does not require any maintenance
or greasing.
Anything that modifies its original conditions
invalidates its efficiency.
If due to unusual natural events (floods, sea storm,
etc.) the device has been affected by water and
mud, it must necessarily be replaced.
162
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
Operations which lead to knocks, vibrations or localised heating (over 100°C for a maximum of 6
hours) in the area around the pretensioners may cause damage or trigger them. These devices are
not affected by vibrations caused by irregularities of the road surface or low obstacles such as
kerbs, etc. Contact a Lancia Dealership for any assistance.
WARNING
The pretensioner can only be used once. After a collision that has triggered it,
have it replaced at a Lancia Dealership. Pretensioner validity is written on the
plate set on the upper oddment compartment on passenger side. Pretensioners
should be replaced at Lancia Dealership as this date approaches.

If you are still unable to start the engine, perform
the emergency start-up procedure (see “Emergency
start-up” in section “In an emergency”) and contact
Lancia Dealership.
IMPORTANT Never leave the ignition key at MAR
when the engine is off.
STARTING PROCEDURE FOR MULTIJET
VERSIONS
Proceed as follows:
❒Ensure that the handbrake is up;
❒Put the gear lever into neutral;
❒Turn the ignition key to MAR: the warning lights
m,UandYwill light up on the instrument
panel;
❒Wait for the warning lights
Yandm. The
hotter the engine is, the quicker this will happen;
❒Press the clutch pedal down to the floor without
touching the accelerator;❒Turn the ignition key to AVV as soon as warning
light
mgoes out. If you wait too long you will
lose the benefit of the work done by the glow
plugs. Release the key as soon as the engine
starts.
IMPORTANT With cold engine, the accelerator
pedal shall be completely released while turning the
ignition key to AVV.
If the engine does not start at the first attempt,
return the ignition key to STOP before repeating
starting.
If, when the ignition key is on MAR, warning light
Y remains lit, turn the key to STOP and then back
to MAR; if the warning light remains on, try with
the other keys provided with the car.
If you still cannot start the engine, contact Lancia
Dealership.
IMPORTANT Never leave the ignition key at MAR
when the engine is off.
185
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
The warning light mwill flash for 60 seconds at start-up or during prolonged cranking to signal
a fault in the glow plug heating system. You can use the car as usual if the engine starts but you
should contact a Lancia Dealership as soon as possible.

PARKING THE CAR
To park the car safely it is absolutely necessary to
press the brake pedal and to engage first gear or
reverse R and also the hand brake if the car is on a
slope; it is also absolutely necessary to wait for the
multifunction display showing the gear engaged to
go off before releasing the brake pedal.
IMPORTANT NEVER leave the car with gearbox in
neutral N.
IMPORTANT NOTES
❒With the car stopped and a gear engaged always
keep the brake pedal pressed until deciding to
move off, then release the brake pedal and
accelerate gradually;
❒during prolonged halts with the engine running it
is advisable to keep the gearbox in neutral N;
❒when the car is parked facing uphill, to safeguard
clutch efficiency do not use the accelerator to
keep the car still since clutch overheating could
damage it. Use the brake pedal and press the
accelerator pedal only when deciding to move off;❒use second gear only when more control is needed
for moving off manoeuvres with poor grip;
❒if, in reverse gear R, first gear is to be engaged or
vice versa, shift gear only when the car is stopped
completely and with the brake pedal pressed;
❒though highly inadvisable, if when travelling
downhill for some unexpected reason the car is
set to neutral N, when the engagement of a gear
is requested, the system automatically engages
the best gear in relation to the speed of the car to
allow the correct transmission of torque to the
wheels;
❒when travelling downhill with a gear engaged and
the accelerator released (if the car is moving),
beyond a pre-established speed, the system
engages the clutch automatically to give the car
adequate engine braking.
199
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR

209
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
WARNING LIGHTS AND MESSAGES
GEAR NOT AVAILABLE ....................................... 228
MANOEUVRE NOT ENABLED ............................ 229
PRESS BRAKE PEDAL – REPEAT
MANOEUVRE ....................................................... 230
ENGAGE N ........................................................... 231
REAR FOGLIGHTS .............................................. 232
FRONT FOG LIGHTS ........................................... 232
LEFT-HAND DIRECTION INDICATOR ................ 232
RIGHT-HAND DIRECTION INDICATOR .............. 232
SIDELIGHTS AND LOW BEAMS ......................... 233
FOLLOW ME HOME ............................................ 233
MAIN BEAM HEADLIGHTS ................................. 233
CRUISE CONTROL .............................................. 234
POSSIBLE PRESENCE OF ICE ON THE ROAD .. 234
FUEL CUTOFF
SWITCHED ON .................................................... 235
CAR PROTECTION SYSTEM FAILURE -
LANCIA CODE ..................................................... 236
“DUALDRIVE” ELECTRIC POWER
STEERING FAILURE............................................ 237
DIESEL FUEL FILTER SENSOR FAILURE ......... 237
GLOW PLUG WARMING FAILURE...................... 237
ABS SYSTEM FAILURE - SYSTEM
UNAVAILABLE ..................................................... 238
RAIN SENSOR FAILURE ...................................... 238 GENERAL WARNINGS ......................................... 211
LOW BRAKE FLUID............................................. 212
HANDBRAKE ON ................................................. 212
FRONT PASSENGER AIR BAG DEACTIVATED... 213
SEAT BELTS NOT FASTENED............................. 213
LOW BATTERY CHARGE .................................... 214
LOW ENGINE OIL PRESSURE ............................ 214
ENGINE COOLANT FLUID HIGH
TEMPERATURE ................................................... 215
INCOMPLETE DOOR LOCKING .......................... 217
“DUALDRIVE” ELECTRIC POWER
STEERING SYSTEM ............................................ 217
SPEED LIMIT EXCEEDED ................................. 218
FUEL RESERVE ................................................... 218
WATER IN DIESEL FUEL FILTER ...................... 219
GLOW PLUGS ...................................................... 220
ASR - WHEEL ANTISKID SYSTEM ..................... 220
BRAKE PAD WEAR ............................................. 220
LOW TYRE PRESSURE ...................................... 221
GLOW FLAT TYRE ............................................. 222
REDUCE GEARS .................................................. 224
MANUAL MODE NOT AVAILABLE...................... 224
AUTOMATIC MODE NOT AVAILABLE ................ 225
CLUTCH OVERHEATING .................................... 226
PRESS BRAKE PEDAL – DELAYED STARTING ... 227