2007 Lancia Musa warning light

133
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
The tilted seats are fastened in this position by the action of the side
struts.
IMPORTANT Tilting is only possible with rear seats positioned
completely backwards.
Partial extension
Operating the required part (right or left) of the seat in the same way
it is possible to obtain partial extension of the boot as illustrated.
IMPORTANT For rear seat complete tilting it could be necessary to
move the front seats forward.
To return the cushions on the floor
Use tapes (B) to return the cushions on the floor.
L0D0111m
L0D0112m
L0D0110m
WARNING
With table folded seats, in the event of a
crash it can be dangerous to carry heavy
objects on the rear seat back.
WARNING
The position of the rear seat backs folded
on the respective cushions shall not be
considered a loading position and
therefore cannot bear heavy weights.

134
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
BONNET
TO OPEN THE BONNET
Proceed as follows:
❒pull lever A in the direction of the arrow;
❒move the lever B to the right as shown by the arrow;
❒lift the bonnet and at the same time release the rod C from the clip
D, then insert the rod end in its housing E on the bonnet.
IMPORTANT Before opening the bonnet, check that windscreen
wiper arms are not lifted from the windscreen.
L0D0113m
L0D0114mL0D0115m
WARNING
For safety reasons the bonnet shall
always be perfectly closed when
travelling. Always check for proper
bonnet locking. If the bonnet is left
inadvertently open, stop the car
immediately and close the bonnet.

135
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
TO CLOSE THE BONNET
Proceed as follows:
❒hold the bonnet up with one hand and with the
other remove rod C from recess D and replace it
in its locking device E;❒lower the bonnet at approx. 20 centimetres from
the engine compartment and then let it drop,
ensuring that it is fully closed and not just held
in position by the safety catch. If the bonnet does
not close properly, do not push it down but open
it again and repeat the above procedure.
IMPORTANT Always check that the bonnet is
closed properly to avoid its opening while the car is
travelling.
WARNINGIf the supporting rod is not positioned correctly the bonnet may fall violently.
WARNING
Carry out operations when the vehicle is stationary.

136
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
ROOF/SKI RACKS (where provided)
IMPORTANT Use roof/ski racks provided at Lineaccesori Lancia.
Always attain to the installation instructions provided with the kit
and have the roof racks installed by skilled personnel.
IMPORTANT Never exceed the max. permissible loads (see section
“Technical specifications”).
After few kilometers, check that fastening screws are firmly tightened.
HEADLIGHTS
ADJUSTING THE HEADLIGHT BEAM
Proper adjustment of the headlight beams is of vital importance for
your safety and comfort and also for the other road users. To ensure
you and other drivers have the best visibility conditions when
travelling with the headlights on, the headlights must be set properly.
Contact Lancia Dealership to have the headlights properly adjusted.
Headlight aiming device
The device can be operated with the ignition key at MAR and dipped
beam headlights on. When the car is loaded, it slopes backwards.
This means that the headlight beam rises. In this case, it is necessary
to return it to the correct position.
L0D0116m L0D0248m
Never activate the sunroof with roof racks mounted.

137
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
To adjust the headlight slant
To adjust the headlight slant operate buttons
andÒlocated on the
dashboard.
The display provides the visual indication of the positions during the
adjustment operation.
Position 0 - one or two people occupying the front seats.
Position 1 - five people.
Position 2 - five people + load in the boot.
Position 3 - driver + maximum permissible load stowed in the boot.
IMPORTANT Check beam aiming every time the load carried
changes.
HEADLIGHT ADJUSTMENT ABROAD
The dipped-beam headlights are adjusted for circulation in the
country in which the vehicle is marketed. In countries with opposite
circulation, to avoid glaring oncoming vehicles, it is necessary to
cover the areas of the headlight as shown below: this is done using
non-transparent sticker tape.
Figures refer to passing from right-hand drive to left-hand drive.
L0D0116m
L0D0118m
L0D0119m

138
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
ABS SYSTEM
The car is fitted with an ABS braking system, which
prevents the wheels from locking when braking,
makes the most of road grip and gives the best
control when emergency braking under difficult
road conditions.
System is completed by EBD (Electronic Braking
Force Distribution), which distributes the braking
action between front and rear wheels.
IMPORTANT To have the maximum efficiency of
the braking system, it is necessary a setting period
of about 500 km: during this period it is better to
avoid sharp, repeated and prolonged brakes.ABS INTERVENTION
The driver can tell the ABS system has come into
action because the brake pedal pulsates slightly and
the system gets noisier: it means that the car speed
should be altered to fit the type of road surface.
If the ABS system cuts in, it is a sign that the grip
between tyre and the road surface has reached the
limit: you must slow down to match the speed to the
road grip available.
FAILURE WARNINGS
ABS failure
If there is a fault, the instrument panel warning
light
>will come on together with the message
(where provided) on the reconfigurable
multifunction display (see the “Warning lights”
chapter).
In this case the braking system is still efficient,
though without the aid of the ABS system. Drive
carefully to the closest Lancia Dealership to have
the system checked.
If the ABS system cuts in, it is a sign that the grip between tyre and the road
surface has reached the limit: you must slow down to match the speed to the road
grip available.
WARNING
The ABS exploits the tyre-road grip at the best, but it cannot improve it; you
should therefore take every care when driving on slippery surfaces without taking
unnecessary risks.
WARNING

139
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
EBD failure
It is signalled by lighting up of instrument panel
warning lights
>andxtogether with the message
(where provided) on the multifunction display
(see the “Warning lights” chapter).In this case with sharp braking the rear wheels
might lock too early, with the possibility of
skidding. Drive extremely carefully to the nearest
Lancia Dealership to have the system checked.
When the ABS cuts in, and you feel the brake pedal pulsating, do not remove your
foot, but keep it pressed; in doing so you will stop in the shortest amount of space
possible under the current road conditions.
WARNING
WARNING
If brake fluid low warning light xlights up on the instrument panel (together,
where provided, with the message on the multifunction display), stop immediately
the car and contact the closest Lancia Dealership. Fluid leaks from the hydraulic
system, in fact, can compromise the braking system, both traditional systems and
systems with ABS.

140
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
ESP SYSTEM
(Electronic Stability Program)
(where provided)
The ESP system is an electronic system controlling
the car stability in the event of tyre grip loss.
The ESP system is therefore particularly useful
when grip conditions of the road surfaces change.
ESP SYSTEM INTERVENTION
It is indicated by the blinking of the warning light
áon the instrument panel, to inform the driver that
the car is in critical stability and grip conditions.
The performance of the system, in terms of active
safety should not induce the driver to take pointless
and unnecessary risks. The style of driving must in
any case always be adapted to the conditions of the
road surface, visibility and traffic. Road safety is
always the driver’s responsibility. ESP SYSTEM OPERATION
The ESP system is automatically inserted when the
car is started and cannot be deactivated.
FAILURE WARNINGS
In the event of failure, the ESP system is
automatically disconnected and the warning light
áwill come on with fixed light on the instrument
panel together with the message on the
multifunction display. In this case contact a Lancia
Dealership as soon as possible.
WARNING
The performance of the system, in terms of active safety should not induce the
driver to take pointless and unnecessary risks. The style of driving must in any
case always be adapted to the conditions of the road surface, visibility and
traffic. Road safety is always the driver’s responsibility.