Page 9 of 314

MAIN KEY WITH REMOTE CONTROL
The metal insert (A) of the key is grip-retractable.
The key operates:
❒the ignition switch;
❒driver’s door lock;
❒passenger side airbag deactivation switch;
❒the dead lock device (where provided).
❒cut-in of door lock device (D) when the electric system is failing (e.g.
run-down battery);
❒cut-in of child lock safety device (E) on rear doors.
Button (B) opens the metal insert (A).
To refit the metal insert (A) into the key grip:
– keep button (B) pressed
– move the metal insert (A)
– release button (B) and then turn the metal insert (A) until hearing the
click as it locks into place.
Button
Ëunlocks the doors, the tailgate and the fuel cap.
Button
Álocks the doors, the tailgate and the fuel cap.
Button
Runlocks the boot.
Led (C) (where required) comes on when sending the control to the
receiver.
8
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0015m
WARNINGButton (B) should only be pressed when the key is away from the body, in
particular from the eyes and from objects that can be spoilt (e.g. clothes). Make
sure the key can never be touched by others, especially children, who may
inadvertently press the button.
F0H0246m
Page 14 of 314

13
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Replacing the battery of the key with remote control
If when pressing the remote control buttons the led (F) on the key
flashes briefly only once, the battery should be replaced with an
equivalent one that can be purchased at common stores.
Battery replacement:
❒press button (A) and move the metal insert (B) to open position;
❒use a finely-tipped screwdriver to turn the screw (C);
❒pull out the battery holder (D) and replace the battery (E) making
sure that the bias is correct;
❒re-insert the battery holder (D) in the key and lock it turning the
screw (C).
Request for additional remote controls
The system can recognise up to 8 keys with incorporated remote
control. Should a new key with remote control be necessary, contact a
Fiat Dealership, taking with you the CODE card, a personal identity
document and the car’s ownership documents.
F0H0018m
Used batteries are harmful to the environment. They should be disposed of as specified by law in
the special containers provided, or take them to a Fiat Dealership, which will deal with their
disposal.
Page 15 of 314

14
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
KEY WITHOUT REMOTE CONTROL (SPARE KEY)
(where required)
The metal insert (A) of the key is grip-retractable.
The key operates:
❒the ignition switch;
❒the driver’s door;
❒passenger side airbag deactivation switch;
❒the dead lock device (where provided);
❒cut-in of door lock device (C) when the electric system is failing (e.g.
run-down battery;
❒cut-in of child lock safety device (D) on rear doors.
Button (B) opens the metal insert (A).
To refit the metal insert (A) into the key grip:
– keep button (B) pressed
– move the metal insert (A)
– release button (B) and then turn the metal insert (A) until hearing the
click as it locks into place.F0H0014m
WARNINGButton (B) should only be pressed when the key is away from the body, in
particular from the eyes and from objects that can be spoilt (e.g. clothes). Make
sure the key can never be touched by others, especially children, who may
inadvertently press the button.
F0H0322m
Page 16 of 314
KEY WITHOUT REMOTE CONTROL (SPARE KEY)
(where required)
The metal insert (A) of the key is fixed.
The key operates:
❒the ignition switch;
❒the driver’s door;
❒passenger side airbag deactivation switch;
❒the dead lock device (where provided);
❒cut-in of door lock device (C) when the electric system is failing (e.g.
run-down battery);
❒cut-in of child lock safety device (D) on rear doors.
15
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0340m
F0H0322m
Page 18 of 314
17
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNINGIf the battery of the key with remote control is down, the dead lock device can be
activated only using the metal insert of the key in the door revolving plug as
previously described. The dead lock device guarantees the best protection against unwanted access. Therefore, it should be actuated every
time the car is parked and left unattended.
Page 117 of 314

INERTIAL FUEL CUT-OFF SWITCH
It is located next to the passenger’s door pillar, at the bottom (move the
covering aside to reach it) and it comes into operation in the case of a
crash by cutting off fuel and switching off the engine.
When the fuel cut-off switch is on, warning light è(if any) comes on
together with the message on the multifunction reconfigurable display.
Carefully inspect the car to find fuel leaks, e.g. in the engine
compartment, under the car or near the tank.
If no fuel leaks are found and the car can be started again, press button
(A) to reset the fuel system and the lights.
After a crash, remember to turn the ignition key to STOP to prevent
battery run-down.
116
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNINGIf, after an accident, you can smell petrol or see that the fuel feed system is leaking,
to avoid the risk of fire, do not reset the switch.
F0H0085m
Page 179 of 314

ENGINE STARTING
The car is fitted with an electronic engine lock device.
If the engine fails to start, see paragraph “Fiat CODE
system” in section “Dashboard and controls”.
The engine may be noisier than usual during the first
seconds of operation, especially after it has not been
used for a while. This characteristic feature of the
hydraulic tappet system does not compromise
functionality or reliability. The system devised for the
Fiat Idea was designed to limit maintenance
interventions.STARTING PROCEDURE FOR PETROL
VERSIONS
Proceed as follows:
❒Ensure that the handbrake is up;
❒Put the gear lever into neutral;
❒Press the clutch pedal down to the floor without
touching the accelerator;
❒Turn the ignition key to AVV and let it go the
moment the engine starts.
If the engine does not start at the first attempt, return
the ignition key to STOP before repeating starting.
If, when the ignition key is on MAR, warning light
Y
remains lit together with warning light U, turn the
key to STOP and then back to MAR; if the warning
light remains on, try with the other keys provided with
the car.
178
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR
We recommend that during the initial period you do not drive to full vehicle performance (e.g.:
excessive acceleration, long journeys at top speed, sharp braking, etc.).
When the engine is switched off never leave the ignition key in the MAR position to prevent
pointless current absorption from draining the battery.
WARNINGRunning the engine in confined areas is extremely dangerous. The engine consumes
oxygen and produces carbon monoxide which is a highly toxic and lethal gas.
Page 182 of 314

PARKING
Proceed as follows:
❒stop the engine and engage the handbrake;
❒engage a gear (on a slope, engage first gear if the car is faced uphill or
reverse if it is faced downhill) and leave the wheels steered.
Block the wheels with a wedge or a stone if the car is parked on a steep
slope. Avoid leaving the car parked with a wheel on the sidewalk or
steered against the kerb. Do not leave the ignition key at MAR to
prevent draining the battery. Always remove the key when you leave
the car.
181
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR
HANDBRAKE
The handbrake lever is located between the two front seats.
Pull the handbrake lever upwards until the car cannot be moved.
Four or five clicks are generally enough when the car is on level ground while nine or ten may be required if the car
is on a steep slope or laden.
IMPORTANT If this is not the case, contact Fiat Dealership to have the handbrake adjusted.
When the handbrake lever is pulled up and the ignition key is at MAR the panel warning light xwill come on.
To release the handbrake:
❒slightly lift the handbrake and press release button (A);
❒keep button (A) pressed in and lower the lever. Warning light xwill go out.
Press the brake pedal when carrying out this operation to prevent the car from moving accidentally.
IMPORTANT If the handbrake lever tends to approach the end of stroke (slot on central console), contact Fiat
Dealership to have the handbrake adjusted.
WARNINGNever leave children unattended in the car. Always remove the ignition key when
leaving the car and take it out with you.
F0H0149m