2007 CHEVROLET KODIAK Owners Manual

Matching Transmitter(s) to Your
Vehicle
Each remote keyless entry transmitter is coded to
prevent another transmitter from unlocking your
vehicle. If a transmitter is lost or stolen, a
replacement can be purchased through your
dealer. Remember to bring any remaining
transmitters with you when you go to your dealer.
When the dealer matches the replacement
transmitter to your vehicle, any remaining
transmitters must also be matched. Once your
dealer has coded the new transmitter, the
lost transmitter will not unlock your vehicle. Each
vehicle can have a maximum of four transmitters
matched to it.
Battery Replacement
Under normal use, the battery in your remote
keyless entry transmitter should last about
two years.
You can tell the battery is weak if the transmitter
won’t work at the normal range in any location.
If you have to get close to your vehicle before the
transmitter works, it’s probably time to change
the battery.
Notice:When replacing the battery, use care
not to touch any of the circuitry. Static
from your body transferred to these surfaces
may damage the transmitter.
1. Insert a thin object, such as a coin, into the
slot between the covers of the transmitter
near the key ring hole. Remove the bottom by
twisting the object.
2. Remove and replace the battery, positive (+)
side down. Use one CR2032 battery.
89

3. Align the covers and snap them together.
4. Check the operation of the transmitter. If the
transmitter does not work after battery
replacement, it may need to be
resynchronized to your vehicle. See
Resynchronizationfollowing.
Resynchronization
Resynchronization may be necessary due to the
security method used by this system. The
transmitter does not send the same signal twice to
the receiver. The receiver will not respond to a
signal it has been sent previously. This prevents
anyone from recording and playing back the signal
from the transmitter.
To resynchronize your transmitter, stand close to
your vehicle and simultaneously press and
hold the LOCK and UNLOCK buttons on the
transmitter for at least five seconds. The door locks
should cycle to confirm resynchronization. If the
locks do not cycle, see your dealer for service.
90

Doors and Locks
Door Locks
{CAUTION:
Unlocked doors can be dangerous.
Passengers, especially children, can
easily open the doors and fall out of a
moving vehicle. When a door is
locked, the handle will not open it.
You increase the chance of being
thrown out of the vehicle in a crash if
the doors are not locked. So, wear
safety belts properly and lock the
doors whenever you drive.
CAUTION: (Continued)
CAUTION: (Continued)

Young children who get into unlocked
vehicles may be unable to get out.
A child can be overcome by extreme
heat and can suffer permanent injuries
or even death from heat stroke.
Always lock your vehicle whenever
you leave it.
Outsiders can easily enter through an
unlocked door when you slow down
or stop your vehicle. Locking your
doors can help prevent this from
happening.
There are several ways to lock and unlock your
vehicle.
If your vehicle is equipped with keyless entry, you
can use your transmitter to lock or unlock your
vehicle. SeeRemote Keyless Entry (RKE) System
Operation on page 88.
91

To lock or unlock your door from the outside, use
your key.
To lock the door from
the inside, slide the
manual lever on
the door down. To
unlock the door, slide
the manual lever up.Power Door Locks
If your vehicle has
power door locks, press
the bottom of the
power door lock switch
to lock all the doors
at once. To unlock all
the doors at once, press
the top of the power
door lock switch.
When a door is locked, the inside door handle will
not work.
92

Windows
{CAUTION:
Leaving children, helpless adults, or pets
in a vehicle with the windows closed is
dangerous. They can be overcome by the
extreme heat and suffer permanent
injuries or even death from heat stroke.
Never leave a child, a helpless adult, or a
pet alone in a vehicle, especially with the
windows closed in warm or hot weather.
Manual Windows
Turn the hand crank on each door to raise or
lower the window.
93

Power Windows
If your vehicle has power windows, the switches
for all windows are located on the driver’s door. In
addition, each passenger door has a switch for
their own window.
Press the rearward part of the switch to lower the
window. Press the forward part of the switch to
raise the window.
The power windows will operate when the ignition
is in ACCESSORY or RUN.
Express-Down
The driver’s window has an express-down feature.
This allows the window to be lowered fully
without continuously holding the switch. Press the
switch down fully to initiate the express-down
feature. Press the top of the switch to stop
the window from lowering.
Window Lockout (Crew Cab)
o
(Window Lockout):The driver’s window
switches include a lockout feature. This prevents
the passenger’s from operating their windows.
The driver can still operate all windows with
the lockout on. Press the button to turn the
lockout feature on and off.
Sliding Rear Window
To open the sliding rear window, pull the latch
toward the driver’s side of the vehicle.
To close the window, slide the window toward the
passenger’s side of the vehicle. The latch will
automatically lock into place. Try to open
the window without releasing the latch to be sure
the window is in the locked position.
Regular Cab Switches
Crew Cab Switches
94

Sun Visors
To block out glare, you can swing down the
visors. You can also swing them out to block glare
from the side.
Starting and Operating Your
Vehicle
New Vehicle Break-In
Notice:Your vehicle does not need an
elaborate break-in. But it will perform better in
the long run if you follow these guidelines:
Let your engine warm up before you
operate your vehicle under load.
Keep your speed at 55 mph (88 km/h) or
less for the rst 500 miles (805 km).
Do not drive at any one speed, fast or
slow, for the rst 500 miles (805 km).
Do not make full-throttle starts.
Avoid making hard stops for the rst
200 miles (322 km) or so. During this time
your new brake linings are not yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every time
you get new brake linings.
Use the lowest gear you can when you start
a loaded vehicle in motion and when going
up hills to avoid overloading the engine.
Check and adjust engine and transmission
uid levels often and be sure tires are
properly inated for the load you are
carrying.
If you have a Caterpillar®diesel engine, see
the Caterpillar®Diesel Engine Operation
and Maintenance Manual.
95

Ignition Positions
With your key in the ignition switch, you can turn it
to five different positions.
A (ACCESSORY):This position allows you to use
things like the radio, power windows and the
windshield wipers when the engine is off. To get
into ACCESSORY, push in the key and turn it
toward you. Your steering wheel will remain
locked, just as it was before you inserted the key.B (LOCK):This position locks your ignition,
steering wheel and transmission. It is a
theft-deterrent feature. You will only be able to
remove your key when the ignition is turned
to LOCK.
C (OFF):This position lets you turn off the engine
but still turn the steering wheel. It does not lock
the steering wheel like LOCK. Use OFF if
you must have your vehicle in motion while the
engine is off.
D (RUN):This is the position for driving.
The battery could be drained if you leave the key
in the ACCESSORY or RUN position with the
engine off. You may not be able to start your
vehicle if the battery is allowed to drain for
an extended period of time.
E (START):This position starts your engine.
96