2007 CADILLAC SRX lock

{CAUTION:
Lifting a vehicle and getting under it to do
maintenance or repairs is dangerous
without the appropriate safety equipment
and training. The jack provided with your
vehicle is designed only for changing a
at tire. If it is used for anything else, you
or others could be badly injured or killed
if the vehicle slips off the jack. Use the
jack provided with your vehicle only for
changing a at tire.
4. Turn the wheel wrench clockwise to raise the
jack lift head until the jack just ts under the
vehicle.5. Raise the jack by turning the wheel wrench
clockwise until the slots in the jack head t
into the metal ange located behind the
triangle on the plastic molding as shown.
Notice:Using a jack to raise the vehicle
without positioning it correctly could damage
your vehicle. When raising your vehicle on
a jack, be sure to position it correctly under the
frame and avoid contact with the plastic
molding.
431

6. Put the compact spare tire near you.
7. Raise the vehicle by turning the wheel wrench
clockwise. Raise the vehicle far enough off
the ground for the compact spare tire to
t under the vehicle.8. Remove all the wheel nuts and take off the
at tire.
9. Remove any rust or
dirt from the wheel
bolts, mounting
surfaces and spare
wheel.
432

13. Lower the vehicle by attaching the wheel
wrench to the jack and turning the wrench
counterclockwise. Lower the jack completely.14. Tighten the wheel
nuts rmly in a
crisscross sequence,
as shown.
Do not try to put a wheel cover on the compact
spare tire. It will not t. Store the wheel cover
securely in the rear of the vehicle until you have the
at tire repaired or replaced.
434

To release the spare tire from the secondary latch,
do the following:
1. If the cable is not visible, start this procedure
at Step 3.
2. If the cable is visible,
place the wrench on
the hoist drive nut
and turn the wrench
counterclockwise
until approximately
6 inches (15 cm) of
cable is exposed.
3. Attach the wheel wrench to the jack and raise
the jack at least 10 turns.
4. Place the jack under the vehicle, ahead of the
rear bumper. Position the center lift point of
the jack under the center of the spare tire.5. Turn the wheel wrench clockwise to raise the
jack until it lifts the secondary latch spring.
6. Keep raising the jack until the spare tire stops
moving upward and is held rmly in place, this
lets you know that the secondary latch has
released.
7. Lower the jack by turning the wheel wrench
counterclockwise. Keep lowering the jack
until the spare tire is resting on the wheel
wrench.
437

8. Grasp the spare tire with both hands and pull
it out from under the vehicle.
9. Reach under the vehicle and remove the
wheel wrench and jack.10. Tilt the retainer and slip it through the wheel
opening when the spare tire has been
completely lowered.
11. Turn the wrench clockwise to raise the cable
back up if the cable is hanging.
Have the hoist assembly inspected as soon as
you can. You will not be able to store a spare tire
using the hoist assembly until it has been
repaired or replaced.
438

To store the spare tire and tools, do the following:
1. Lay the compact spare tire on the ground
at the rear of the vehicle. Position the
compact spare tire so that the valve stem is
pointed down facing the rear of the vehicle.
2. Lower the cable to the ground. SeeRemoving
the Spare Tire and Tools on page 426.3. Tilt the retainer downward and slip it through
the center hole of the spare tire.
Make sure the retainer is fully seated across
the underside of the wheel.
4. Attach the wheel wrench to the hoist shaft.
5. Turn the wheel wrench clockwise to lift
the spare tire.
6. When the tire is almost in the stored position,
turn the tire so that the valve stem is towards
the rear of the vehicle.
This will help when you check and maintain
tire pressure in the spare.
7. Raise the tire fully against the underside of
the vehicle. Continue turning the wheel
wrench until you feel more than two clicks.
This indicates that the compact spare
tire is secure and the cable is tight. The spare
tire hoist cannot be overtightened.
441

Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected
from short circuits by a combination of fuses
and circuit breakers. This greatly reduces
the chance of res caused by electrical problems.
Look at the silver-colored band inside the fuse.
If the band is broken or melted, replace the fuse.
Be sure you replace a bad fuse with a new
one of the identical size and rating. If a fuse blows,
see your dealer for service immediately.
If you ever have a problem on the road and
don’t have a spare fuse, you can “borrow” one
that has the same amperage. Pick some
feature of your vehicle that you can get along
without – like the radio or cigarette lighter – and
use its fuse, if it is the correct amperage. Replace
it as soon as you can.
The fuses are located in three fuse blocks, one
located in the engine compartment on the
passenger’s side and the other two under the
rear seat.
Underhood Fuse Block
The underhood fuse block is located in the engine
compartment on the right side of the vehicle.
SeeEngine Compartment Overview on page 356
for more information on location.
To access the fuses, push in the two tabs located
on each side of the fuse block cover. Then lift
the cover off.
455

Relays Usage
FOG LAMP SS
MICROFront Fog Lamps
SPARE Spare
IGN MAIN SS
MICROIgnition Switch (ON)
STRTR HC
MICROStarter Solenoid
PWR/TRN HC
MICROPowertrain/Engine Control Module
HI BEAM SS
MICROHigh-Beam Headlamps
BLWR HC
MICROFront Blower Motor Assembly
WPR HC
MICROWindshield Wiper System - On/Off
WPR HI HC
MICROWindshield Wiper System -
Low/High
HEAD LAMP
WASH HC
MICROHeadlamp Washer Pump (Option)
LO BEAM-LP
MICRO/HID-HC
MICROLow-Beam Headlamps
REAR WASH
SS MICRORear Washer PumpRelays Usage
HORN SS
MICROHorn
A/C CMPRSR
CLTCH SS
MICROAir Conditioning Compressor Clutch
FUEL PUMP
SS MICROFuel Pump
ACCY SS
MICROAccessory Power (Rear Wipers,
Inside Rearview Mirror)
J Case Fuses Usage
FAN 2 Right Cooling Fan Motor
SPARE Spare
FAN 1 Left Cooling Fan Motor
SPARE Spare
STRTR Starter Solenoid
LPDB 2LRPDB (Left Side Rear
Power Distribution Box)
ABS MOTOR Anti-lock Brake System Module
LPDB 1LRPDB (Left Side Rear
Power Distribution Box)
RPDB 1RRPDB (Right Side Rear
Power Distribution Box)
SPARE Spare
457