2007 Acura TL engine

With the clutch pedal pressed,
move the shift lever to the first/
second gear side of the neutral
gate, then shif t to reverse.If you are still unable to shif t to
reverse, apply the parking brake,
and turn the ignition key to the
ACCESSORY (I) or LOCK (0)
position.
Press the clutch pedal, and shif t to
reverse.
With the clutch pedal still pressed,
start the engine.
If you need to use this procedure to
shif t to reverse, your vehicle may be
developing a problem. Have the
vehicle checked by your dealer.
1. 2.
3.
4.
Manual T ransmission
252
——
y

y
(%yy

µ
µ
µµ µ
µ To
avoid transmission damage, come
to a complete stop before shifting
into Park. The shift lever must be in
Park before you can remove the key
from the ignition switch.
Use this position for
your normal driving. The transmis-
sion automatically adjusts to keep
the engine at the best speed for the
driving conditions.
ForfasteraccelerationwheninD,
you can get the transmission to
automatically downshift by pushing
the accelerator pedal to the floor.
The transmission will shift down one,
two or three gears, depending on
your speed.
Press
the brake
pedal to shift from Park to reverse.
To shift from neutral to reverse,
come to a complete stop and then
shift.
Your vehicle has a reverse lockout so
you cannot accidentally shift to
reverse from neutral or any other
driving position when the vehicle
speed exceeds 5 6 mph (8 10
km/h).
If you cannot shift to reverse when
the vehicle is stopped, press the
brake pedal, slowly shift to neutral,
andthenshifttoreverse.
If there is a problem in the reverse
lockout system, or your vehicle’s battery
is disconnected or goes dead,
you cannot shift to reverse. (Refer to
on page ).
Use neutral if you
need to restart a stalled engine, or if
it is necessary to stop briefly with
the engine idling. Shift to the Park
position if you need to leave your
vehicle and apply the parking brake.
Press on the brake pedal when you
are moving the shift lever from
neutral to another gear.
This position mechani-
cally locks the transmission. Use
Park whenever you are turning off or
starting the engine. To shift out of
Park, you must press on the brake
pedal and have your foot off the
accelerator pedal.
If you have done all of the above and
still cannot move the lever out of
Park, see on
page . 258 258
To shift from:
PtoR
RtoN
NtoD DtoL
LtoD
DtoN NtoR RtoP Do this:
Press the brake pedal, then
move the shift lever.
Move the lever.
Drive (D)
Reverse (R)
Shif t L ock Release
Neutral (N)
Park (P)
Shif t L ock Release
Automatic Transmission
254
——
y

y
(%yy

µWhen you move the shif t lever f rom
‘‘D’’ to the Sequential SportShift
mode, the display shows the selected
gear.
With the shif t lever in ‘‘D’’ position,
you can select the Sequential
SportShift mode to shift gears much
like a manual transmission, but
without a clutch pedal.
To enter the Sequential SportShif t
mode, move the shif t lever f urther to
the driver’s side. To return to ‘‘D,’’
move the shift lever to the
passenger’s side.
When you move the
shif t lever to this position, the
transmission shifts to the lowest
gear that can be selected without
exceeding the engine redline. At
normal speeds, it selects third gear.
As the vehicle slows, it selects
second gear at about 56 mph
(90 km/h), and f irst gear at about 29
mph (47 km/h). Accelerating in f irst
gear, the transmission upshif ts to
second gear at about 37 mph
(59 km/h). You must move the shif t
lever to D f or the transmission to
upshif t to third gear. On Type-S, at
closed throttle, it selects second gear
at about 61 mph (98 km/h), and first
gear at about 37 mph (59 km/h).
CONT INUED
Sequential SportShif t ModeLow (L)
Automatic Transmission
Driving
255
SELECTED GEAR
——
y
y
(%yy

´µ
´ µ
In Sequential SportShif t mode, each
time you push f orward on the shif t
lever, the transmission shifts to a
higher gear. Pull back on the lever to
downshif t. The number of the gear
selected is displayed on the
instrument panel.
In Sequential SportShif t mode, you
can also shif t up or down by using
the (right side) or (lef t side)
paddleshiftersoneachsideof the
steering wheel.
Each time you press the right side
( ), the transmission shif ts to a
higher gear. Press the lef t side ( )
to downshif t. The number of the
gear selected is displayed on the
instrument panel.When you accelerate away f rom a
stop, the transmission will start in
f irst gear. You have to manually
upshif t between f irst and f if th gears.
Make sure you upshif t bef ore the
engine speed reaches the
tachometer’s red zone.
The transmission remains in the
selectedgear(5,4,3,2,or1).There
is no automatic downshif t when you
push the accelerator pedal to the
f loor.
On Type S only
Automatic Transmission
256
——
y

y
(%y
y

à
à à
àà
à
à
à
The transmission may automatically
downshif t f rom the higher gear to
the lower gear under these
conditions:
Downshif ting gives you more power
when climbing, and provides engine
braking when going down a steep hill.
The transmission will also shif t
automatically as the vehicle comes to
a complete stop. It will downshif t to
f irst gear when the vehicle speed is
under 9 mph (15 km/h).
If you try to manually downshif t at a
speed that would cause the engine to
exceed the redline in a lower gear,
the transmission will not downshif t.If the vehicle speed slows to below
the redline of the selected lower gear
position while the indicator is
f lashing, the transmission will
downshif t and the display will show
the selected lower gear.
The table shows the speed ranges
f or upshif ting and downshif ting.
To shift from 43
54
To shift from
43
54 To shift from
12
23
34
45
Thegearindicatorwillflashthe
numberof thelowergearseveral
times, then return to the higher gear.
Speed range
under 18 mph
(29 km/h)
under 38 mph
(60 km/h)
Speed range
under 34 mph
(55 km/h)
under 47 mph
(75 km/h) Speed range
over 0 mph
(0 km/h)
over 9 mph
(14 km/h)
over 18 mph
(29 km/h)
over 37 mph
(60 km/h)
Driving uphill Driving on level roads and downhill
CONT INUED
Automatic Transmission
Driving
257
——
y
y
(%yy

à
à
à
àà
à
à
à
To shift from
21
32
43
54 Speed range
under 29 mph
(47 km/h)
under 56 mph
(90 km/h)
under 93 mph
(150 km/h)
under 130 mph
(209 km/h)
To release the reverse lockout, make
sure the ignition switch is in the
ACCESSORY(I) position.Make sure the ignition switch is in
the LOCK (0) position. Set the parking brake.
This allows you to move the shif t
lever out of Park if the normal
method of pushing on the brake
pedal does not work. This procedure
is also used to release the reverse
lockout. If you exceed the maximum speed
f or the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may f eel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
rpm below the red zone.
When you are in Sequential
SportShif t mode, and the vehicle is
stopped, push f orward on the shif t
lever to shif t to second gear. You will
see ‘‘2’’ in the display. Starting out in
second gear will help to reduce
wheelspin in deep snow or on a
slippery surf ace. To shift from
21
32
43
54 Speed range
under 37 mph
(54 km/h)
under 61 mph
(98 km/h)
under 93 mph
(150 km/h)
under 130 mph
(209 km/h)
1.
2.
Type S only
Shif t L ock Release Engine Speed L imiter
Starting in Second Gear
Automatic Transmission
258
——
y
y
(%yy

Put a cloth on the edge of the shif t
lock release slot cover. Using a
small f lat-tipped screwdriver or a
metal f ingernail f ile, caref ully pry
on the edge of the cover to remove
it.Remove the key from the shift
lock release slot. Press the brake
pedal, and restart the engine.
If you need to use the shif t lock
release, it means your vehicle is
developing a problem. Have the
vehicle checked by your dealer.
Insert a key into the shift lock
release slot.
Push down on the key and move
the shift lever out of Park to
neutral.
To release the reverse lockout,
move the shift lever from neutral
to reverse, then to Park.
3. 6.
5. 4.
Automatic Transmission
Driving
259
SHIFT LOCK RELEASE SLOT
COVER
——
y
y
(%yy

Check the brakes after driving
through deep water. Apply the
brakes moderate ly to see if they feel
normal. If not, apply them gently and
frequently until they do. Be extra
cautious in your driving.
Your
vehicle is equipped with disc
brakes at all four wheels. A power
assist helps reduce the effort needed
on the brake pedal. The anti-lock
brake system (ABS) helps you retain
steering control when braking very
hard.
Constant application of the brakes
when going down a long hill builds
up heat and reduces their effective-
ness. Use the engine to assist the
brakes by taking your foot off the
accelerator and downshifting to a
lower gear.
Resting
your foot on the brake pedal
applies the brakes slightly. This
builds up heat, and reduces brake
effectiveness and brake pad life. In
addition, fuel economy can be
reduced. It also keeps your brake
lights on all the time, confusing
drivers behind you. The
hydraulic system that operates
the brakes has two separate circuits.
Each circuit works diagonally across
the vehicle (the left-front brake is
connected with the right-rear brake,
etc.). If one circuit should develop a
problem, you will still have braking
at two wheels, but the brake pedal
may not f eel normal (see page f or more inf ormation). If the brake pads need replacing, you
will hear a distinctive, metallic
screeching sound when you apply
the brake pedal. If you do not have
the brake pads replaced, they will
screech all the time and braking
ef f ectiveness could be reduced. It is
normal for the brakes to occasionally
squeal or squeak when you apply
them.
326
Braking System Design
Brake Wear Indicators
Braking System
Driving
261
——
y
y
(%yy