Page 33 of 211
25
8000256M
Exterior
"
%/*
"
%/*
"
%/-
"
%/-
"
%//
"
%0/
"
%/F
"
%/F
"
%/F
"
%/F
"
%/F
"
%/0
7 ,1
//
9
%/&
4
%/3
<
%%-
%%&
4
%%&
)
%-%
5
%-*
@
32
"
32
H
%2%
Page 34 of 211
26
(
%.F
(
0
-*
5
--
)
>
-0
-.
4 $
-&
(
%.F
A
/2
Instruments
*.
)
*.
+
*.
*.
*.5
*.
(
*.
@
*.
4
*&
8
-2
,1
/2
$
/2
H
F2
$
-.
9
-F
@
-F
-F
<
-F
@ 5
33
Page 35 of 211

27
Instrument panel
1 Turn signals
2 Text window
3 Temperature gauge
The pointer should be approximately midway
on the gauge when driving.
Do not drive the car if the warning light is
on. The text window will provide you with
additional information.
If the engine temperature remains high, check
coolant level - see page 154.
4 Trip odometer/reset button
The trip odometer is used for measuring
shorter distances. The last digit indicates 1/10
mile/kilometer. Press the button quickly to
toggle between trip odometers 1 and 2. Hold in
the button for more than 2 seconds to reset.
5 Odometer
6 Speedometer
7 General warning light (see page 28).
23800662d346
5119
8
7 101312
1
14
Please note that this symbol does not
indicate a fault with your car.
At low speeds or when the car is not moving,
the temperature readings may be slightly
higher than the actual ambient temperature.
12 Clock/reset button
Turn the button to adjust the clock.
13 Fuel gauge
\b
\f
\f \b
\f
\b
\f
\b\f\f
!
" #$%\b&
'\b\f\f
!" #(\b&
When the warning light comes on there are
approximately 2.1 US gal. (8 liters) of fuel
remaining.
14 Indicator and warning lights
8 High beam indicator light
9 Tachometer
Indicates engine speed in thousands of rpm.
Do not drive for long with the needle in the red
section. The engine has an built-in function
preventing too high engine speed. When this
function operates, you may discern some
pulsation, which is normal.
10 Gear and driving mode indicator
The currently selected driving mode is
displayed here. If you use the Geartronic
function on the automatic transmission, the
currently selected gear will be displayed.
11 Ambient temperature indicator
This display indicates the air temperature
outside your car. A "snowflake" symbol in the
text window is displayed when the temperature
is in the range of 23 - 36° F (-5 - +2° C).
Page 36 of 211

28
Indicator and warning lights
The indicator and warning lights described on pages 28 and 29 should never stay on when driving*
When the ignition key is turned, all of the warning lights in the lower
right-hand side of the instrument panel should go on to test the function
of the bulbs. If a light does not go off after the engine has started, thesystem indicated should be inspected.
NOTE: The parking brake reminder light will not go off until the
parking brake has been fully released.
Warning lamp in the
center of the instrument
panel
This lamp lights up red or yellow depending
on the severity of the fault that has been
detected.
Red symbol - Stop the vehicle as soon as
possible in a suitable location and read the
message shown in the text window. The
symbol and accompanying text will remain on
until the fault has been corrected.
Yellow symbol - Follow the instructions
shown in the text window. The text can be
A6
(
Parking
Brake
Parking brake reminder light
,
1
5
#
Generator warning light
BRAKE
Brake failure warning light
!
"
&
$
'
(
'
(
$ $!
&
&
#)
%F&
5
#
Oil pressure warning light
!
"
&
'
(
(
$
&
"
)
%02
* Rear fog light, if used, and trailer turn signal,
if towing a trailer, will go on while driving.
3801130m
erased by pressing the READ button (see page
30), or will disappear automatically after two
minutes.
NOTE: When the message “TIME FOR
REGULAR SERVICE” is displayed, the text
can be erased and the yellow symbol light can
be turned off by pressing the READ button.
The text will disappear and the symbol light
will go out automatically after two minutes.
Page 37 of 211
29
Indicator and warning lights
=
6
Anti-lock Brake System ABS
(<) ,
1
6
)
%%/
Stability Traction Control (STC) system
(option), or Dynamic Stability Traction
Control (DSTC) system (option)
)5
')5
A
)
%%F %%0
Turn signal indicator - trailer (certain
models)
C
C
Seat belt reminder
$
Tire pressure warning light
)
%*-
Rear fog light symbol
CHECK
ENGINE
Malfunction indicator lamp
On-Board Diagnostics II (OBDII): As you
drive, a computer called “OBDII” monitors
your car’s engine, transmission, electrical and
emission systems. The CHECK ENGINE
light will light up if the computer senses a
condition that potentially may need correcting.
When this happens, please have your car
checked by a Volvo retailer as soon as
possible.
(5H5!HBH
)
C
H
H8
5
#
#
7
G
C
Supplemental Restraint System (SRS)
8
%2
)") C
$
, 1
6
Page 38 of 211
30
Text information window
Messages in the text window
When a warning light in the instrument panel comes on, a message is also
displayed in the text window. After you have read the message, you can
erase it by pressing button A (see illustration above).
5
4
8
8
(
,
1
9 (
H
C
(
8
,
1 (
A
3800648d
General messages !
$)
!*
"#
"!
$)
!*
$%
& '$#"!+!#
,
-)) **#
("'!.#
/*
0 * 1 #
-)
$%
& $)'
$*!+!#
,
-))
#
* )"
+ "+ $%
&!2)#*
* )
( $ $#'$
$%
&+*
# 1((*&1(((!*" )1 (
)
&* 1
)
1* )) ) +*
#&
*
*)
#)
,-
%
.
/3!)
#
%(
0-
%
. /
1!)
#
%(
0-
%
. "#
"/
1!)
#
%(
0-
%
.("'/
1!)
#
%(
/+*
#.$* #
"4
1
&5
&".
1
&5
Page 39 of 211

31
Switches in the center console
The positions of these buttons may vary,
depending on the specifications of your car
Stability Traction Control (STC)*/
Dynamic Stability Traction Control
(DSTC)**
Press this switch to turn the Spin Control (SC)
function of the STC/DSTC system on or off.
To help reduce the risk that the SC function is
turned off inadvertently, the switch must be
held in for at least half a second to disable this
function.
See pages 115-116 for more information.
R-models only:
(
5
)
%%F
9
C
)5$(
5
* Standard on all models except R-models.
** Standard on R-models, optional on all other
models. Disconnecting the alarm
This button is used to temporarily disconnect
alarm sensors. See page 85 for further
information.
3603558m
3603549m3603546m
3603555m
3603550m
Auxiliary socket
This 12 volt socket can be used to plug in
certain accessories. The ignition key must be
in position 1 (or higher) for the auxiliary
socket to function. See also page 41 for more
information.
Front/rear park assist (option/acces-
sory)
See page 100 for more information on this
function.
3603563m
3603553m
Power child locks (option)
See page 86 for more information on this
function.
3603554m
Four-C active chassis system (option)
See page 99 for information on this function.
Page 40 of 211

32
Trip computer (option)
ABC3601859d
Trip computer
The trip computer stores information gathered from several systems in
your car and has four menus that can be displayed in the text window.
•'
•(
•5
•(
•5 ,5
1
4
C
8
(
9 (
Trip computer controls and functions
The four* trip computer functions can be accessed by twisting control B
one step at a time in either direction. Twisting the control a fifth time**
returns you to the original function.The trip computer can be reset (current data will be erased from system
memory) by pressing RESET (button C).
1. Driving distance on current fuel reserve
This function shows the approximate distance that can be driven on the
fuel remaining in the tank. This calculation is based on average fuel
consumption during the last 12 miles (20 km) of driving and the amount
of fuel remaining in the tank when the reading was taken.
When the driving distance on current fuel reserve is less than 12 miles
(20 km), “----” will be displayed in the text window.
2. Average fuel consumption
This value indicates fuel consumption since the last time the trip
computer was reset (by pressing RESET, button C). When the engine is
switched off, information on fuel consumption is stored and remains in
system memory until the RESET (button C) is pressed again.
3. Current fuel consumption
This value indicates the current fuel consumption, based on readings
taken once per second. When the car is not moving, “----” will be
displayed.
4. Average speed
This value indicates average speed since the last time the trip computer
was reset (by pressing RESET, button C). When the engine is switched
off, information on average speed is stored and remains in system
memory until the RESET (button C) is pressed again.
5. Current speed in miles per hour (Canadian models only)
This function provides the driver with an instantaneous conversion of the
car’s current speed from km/h to mph.
* Five functions on Canadian models
** A sixth time on Canadian models