2006 VOLVO C70 lights

In accordance with applicable U.S. and Canadian regulations, the following list of warranties is provided.
New Vehicle Limited Warranty
Parts and Accessories Limited Warranty
Corrosion Protection Limited Warranty
Seat Belt and Supplemental Restraint Systems Limited Warranty
Emission Design and Defect Warranty
Emission Performance Warranty
These are the federal warranties; other warranties are provided as required by state/ provincial law. Refer to your
separate Warranty and Service Records Information booklet for detailed information concerning each of the warranties.
Periodic maintenance helps minimize emissions
Periodic maintenance will help keep your vehicle running well. Your Warranty and Service Records Information
booklet provides a comprehensive periodic maintenance schedule up to 150,000 miles (240,000 km) of vehicle
maintenance. The schedule includes components that affect vehicle emissions. This page describes some of the
emission-related components.
Vehicle Event Data (Black Box)
Your vehicle's driving and safety systems employ computers that monitor, and share with each other, information
about your vehicle's operation. One or more of these computers may store what they monitor, either during normal
vehicle operation or in a crash or near-crash event. Stored information may be read and used by:
Volvo Car Corporation
service and repair facilities
law enforcement or government agencies
others who may assert a legal right to know, or who obtain your consent to know such information.
pg. 155 Maintenance and servicing
Maintaining your car
Owner maintenance
Periodic maintenance requirements and intervals are described in your vehicle's Warranty and Service Records
Information booklet.
The following points can be carried out between the normally scheduled maintenance services.
Each time the car is refueled:
Check the engine oil level
Clean the windshield, windshield wipers, headlights, and tail lights
Monthly:
Check cold tire pressure in all tires. Inspect the tires for wear.
Check that engine coolant and other fluid levels are between the indicated "min" and "max" markings.
Clean interior glass surfaces with a glass cleaner and soft paper towels.
Wipe driver information displays with a soft cloth.
Visually inspect battery terminals for corrosion. Corrosion may indicate a loose terminal connector, or a battery near
the end of its useful service life. Consult your Volvo retailer for additional information.
As needed:
Wash the car, including the undercarriage, to reduce wear that can be caused by a buildup of dirt, and corrosion that
can be caused by salt residues.
ProCarManuals.com

Battery fluid contains sulfuric acid. Do not allow battery fluid to contact eyes, skin, fabrics or painted surfaces. If
contact occurs, flush the affected area immediately with water. Obtain medical help immediately if eyes are affected.
pg. 164 Maintenance and servicing
Bulbs
Bulbs used in the car1. Low beam headlight 55W H11
2. Bi -Xenon headlight (option) 35W D2S
3. High beam headlight 55W HB3
4. Brake light, Rear fog light P21/W5
5. Turn signal, front/ rear (amber bulb) PY21W
6. Tail lights, Parking light, Side marker light P21/W5
7. Footwell lighting, cargo compartment light W5W
8. Vanity mirror 1,2W
9. License plate lighting,
Parking light in headlight housing
Side turn signal (amber bulb) W5W
10. Front fog light (option) 55W H11
NOTE:
Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the heat and will
leave a deposit on the reflector, which will damage it.
The optional Bi -Xenon headlight bulbs contain trace amounts of mercury. These bulbs should always be disposed
of by a trained and qualified Volvo service technician.
Certain bulbs not listed here should only be replaced by a trained and qualified Volvo service technician.
pg. 165 Maintenance and servicing
Replacing front bulbs
ProCarManuals.com

Removing the headlight housing
The entire headlight housing must be lifted out when replacing the high/low beam, parking light, turn signal, and side
marker bulbs. To lift out the housing:
Remove the key from the ignition and turn the headlight switch to position 0.
Open the hood.
Pull up the headlight housing's retaining pin (1)
Pull the headlight housing to one side and then forward (2).
Disconnect the wiring connector.
Lift out the headlight housing and place it on a soft surface to avoid scratching the lens.
After the defective bulb has been replaced, reinsert the housing in the reverse order. Check that the retaining pin is
correctly inserted.
WARNING!
Bi -Xenon headlights (option) - due to the high voltage used by these headlights, these bulbs should only be replaced
by a trained and qualified Volvo service technician.
Low beam bulb
Open the hood.
Remove the headlight housing.
Press the retaining clamps to the sides.
Release the bulb's retaining spring by pressing it to the right, and then moving it outward and downward.
Pull out the bulb.
Disconnect the wiring connector from the bulb. Installing a new bulb.
Insert the new bulb. It can only be installed in one position.
ProCarManuals.com

Side marker light
Turn the bulb holder counterclockwise, pull it out, and replace the bulb.
Reinstall the bulb holder. It can only be installed in one position.
Front fog light (option)
Switch off all lights and turn the key to position 0.
Remove the panel around the fog light housing. Depress the tabs around the edges as shown in the illustration in the
right column.
Unscrew both torx screws in the fog light housing and remove it.
Disconnect the connector from the bulb.
Turn the bulb counterclockwise and pull it out.
Install the new bulb in its seat and turn it clockwise.
Reconnect the connector to the bulb.
Secure the fog light housing with the screws and press the panel back into place.
pg. 168 Maintenance and servicing
Replacing bulbs in the trunk
ProCarManuals.com

Removing the tail light bulb holder
All bulbs in the tail light cluster can be replaced from the trunk. To access the bulb holder:
Switch off all lights and turn the key to position 0.
Remove the covers in the left/right panels as shown above to access the bulbs.
Disconnect the wiring connector from the bulb holder.
Press the catches together and pull out the bulb holder.
Replace the defective bulb.
Press the wiring connector back into position.
Press the bulb holder into place and reinstall the cover.
Location of tail light bulbs
1. Brake light
2. Parking light
3. Fog light (driver's side only)
4. Turn signal
5. Back-up light
NOTE: If the message indicating a burned out bulb remains in the information display after the bulb has been
replaced, consult a trained and qualified Volvo service technician.
ProCarManuals.com

Rear reading lights
Insert a screwdriver and turn it gently to detach the bulb housing.
Remove the defective bulb.
Install a new bulb.
Press the bulb housing back into place.
High-level brake light
These bulbs are of a special type. It is recommended that they be replaced by a trained and qualified Volvo service
technician.
pg. 169 Maintenance and servicing
Replacing interior bulbs
License plate lighting
Replacing the bulb
Switch off all lights and turn the key to position 0.
Remove the screw with a screw driver.
Detach the entire bulb housing and carefully pull it out. Turn the connector counterclockwise and pull out the bulb.
Replace the bulb.
Reinstall the connector and turn it clockwise.
Reinstall the entire bulb housing and screw it into place.
Footwell lighting
The footwell lighting is located under the dashboard on the driver's and passenger's sides. To replace a bulb:
ProCarManuals.com

Insert a screwdriver under the edge of the lens. Turn the screwdriver gently to detach the lens.
Remove the defective bulb.
Install a new bulb.
Press the lens back into place.
Vanity mirror lighting
Insert a screwdriver under the center of the lower edge of the mirror, turn it, and carefully pry up the lugs at the
edge.
Move the screwdriver under the edge on the left and right-hand sides (near the black rubber sections) and pry
carefully to release the lower edge of the mirror.
Pry carefully and lift out the entire mirror and the cover.
Remove the defective bulb and replace it with a new one.
To reinstall the mirror, begin by pressing the three lugs at the upper edge of the mirror back into place.
Press the three lower lugs back into place.
Trunk lights
Insert a screwdriver and turn it gently to detach the bulb housing.
Remove the defective bulb.
Install a new bulb.
Press the bulb housing back into place.
pg. 170 Maintenance and servicing
Fuses
Replacing fuses
There are relay/fuse boxes located in the engine compartment and the passenger compartment.
If an electrical component fails to function, this may be due to a blown fuse. The easiest way to see if a fuse is blown
is to remove it.
To do so:
Pull the fuse straight out. If a fuse is difficult to remove, special fuse removal tools are located on the inside of the
fuse box covers.
From the side, examine the curved metal wire in the fuse to see if it is intact.
If the wire is broken, insert a new fuse of the same color and amperage (written on the fuse).
If fuses burn out repeatedly, have the electrical system inspected by a trained and qualified Volvo service technician.
ProCarManuals.com

12. Feed to heated rear window, 30A
13. Starter motor relay, 30A
14. Trailer connector, 40A
15. Power retractable hard top, 30A
16. Feed to audio system, 30A
17.Windshield wipers, 30A
18. Feed to passenger compartment fuse box, 40A
19. Not in use
20. Horn, 15A
21. Not in use
22. Subwoofer, 25A
23. Engine control module (ECM)/transmission control module (TCM), 10A
24. Not in use
25. Not in use
26. Ignition switch, 15A
27. A/C compressor 10A
28. Not in use
29. Front fog lights (option), 15A
30. Not in use
31. Not in use
32. Fuel injectors, 10A
33. Heated oxygen sensor, vacuum pump, 20A
34. Ignition coils, engine control module, climate unit pressure sensor, 10A
35. Engine sensor valves, A/C relay, 15A
36. Engine control module (ECM), throttle sensor, 10A
pg. 172 Maintenance and servicing
Fuses
Fuse box in the passenger compartment
The fuse box in the passenger compartment is located under the glove compartment.
To access the fuses:
1. Remove the upholstery covering the fuse box by first pressing in the center pins in the mounting clips approximately
0.5 in (1 cm) with a small screwdriver and then pulling the pins out.
2. Turn both retaining screws (2) counterclockwise until they release.
3. Fold down the fuse box (3) half way. Pull it toward the seat until it stops. Fold it down completely. The fuse box can
be unhooked completely.
4. Replace the blown fuse.
5. Close the fuse box in reverse order.
6. Pull the center pins fully out of the mounting clips, secure the upholstery with the mounting clips and press the pins
ProCarManuals.com