EM–1262GR-FE ENGINE MECHANICAL – ENGINE UNIT
EM
(d) Remove the lock pin of the chain tensioner. Check
that each timing mark is aligned with the crankshaft
at the TDC / compression.
(e) Remove the pulley set bolt.
37. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY (w/
Oil Pump) (See page LU-17)
38. INSTALL WATER PUMP ASSEMBLY (See page CO-
13)
39. INSTALL ENGINE REAR OIL SEAL RETAINER
(a) Apply seal packing in a continuous line as shown in
the illustration.
Seal packing:
Toyota Genuine Seal Packing Block, Three
Bond 1207B or Equivalent
Standard seal diameter:
2.0 to 3.0 mm (0.079 to 0.118 in.)
NOTICE:
• Remove any oil from the contact surface.
• Install the crankcase within 3 minutes after
applying seal packing.
• Do not start the engine for at least 2 hours
after the installation.
A132117E01
A131897E03
