Page 355 of 400
undefined
8710-08
RKSTICS
All Door Lock Prevention Function when a Door is Open
All doors, except the tailgate and hood, output "UNLOCK" signal for 5 seconds when the
"LOCK" signal is inputted (while the ignition key is removed and one of any doors is open).
When the door is closed during the UNLOCK output, the UNLOCK output stops immediately.
When the ignition key is inserted during the UNLOCK output, the output continues for approx. 5
seconds.
If the ignition switch is in the "ON" position or the ignition switch is removed, the above steps
are performed. If the key is in the key cylinder, the ignition key reminder function is activated.
This function does not work if the vehicle speed is over 10 km/h. 1.
2.
3.
4.
5.
(*1) LOCK switches in all doors including tailgate (*2) Door switches in all doors excluding tailgate
Page 357 of 400
undefined
8710-08
RKSTICS
Door Ajar Warning
The warning light in instrument panel comes on when opening any of doors including
tailgate while the vehicle speed is below 10 km/h.
The warning light goes off when closing the door under step 1.
The warning light blinks when the vehicle speed is over 10 km/h while the warning light is
turned on.
The warning light blinks when a door is open while the vehicle speed is over 10 km/h.
The warning light goes off when closing the door under step 3.
The warning light comes on when the vehicle speed goes below 10 km/h under step 3. 1.
2.
3.
4.
5.
6.
Page 365 of 400
undefined
8710-08
RKSTICS
Circuit Diagram of STICS (Related to Front/Rear Defogger Timer)
The defogger system defrosts or demists
the window glass with the heated wire
integrated in glass.
When operating the defogger switch,
STICS controls the operating time only in
IGN2 position.
Rear defogger switch
(Tailgate window and outside rearview
mirror heated glass switch) The tailgate
window and outside rearview mirro
r
heated glass is turned on for 12 minutes
when pressing this switch.
Windshield heated glass switch
The windshield heated glass is turned on
for 12 minutes when pressing this switch.
Page 373 of 400
undefined
8710-08
RKSTICS
Time Lag Power Window Control
The power window relay output is "ON" when turning on the ignition switch.
The power window relay output is "ON" for 30 seconds when turning off the ignition switch.
The power window relay output is "OFF" when opening the driver's door or the passenger's
door.
The power window relay is turned "OFF" when receiving the remote control key lock signal
(armed mode) during its extended operation period of 30 seconds. 1.
2.
3.
Definition of Terms
DOOR OPEN and DOOR CLOSE
DOOR OPEN: Any of all door switches (including hood and tailgate) is in "OPEN" position.
DOOR CLOSE: All door switches (including hood and tailgate) are in "CLOSE" position. 1.
The door lock/unlock operation does not affect the engine hood.
DOOR LOCK: Indicates that all door lock switches (including tailgate) are in LOCK positions.
DOOR UNLOCK: Indicates that any of all door lock switches (including tailgate) is in UNLOCK
position. 2.
Page 374 of 400

RKSTICS
undefined
8710-08
Power Sleep Mode
1. Entering Condition
1) When all the doors including the hood are closed.
2) When the ignition key is in "OFF" position.
3) When there is no key in the driver's/passenger's door key cylinder.
4) The system enters into the sleep mode for saving power if there is any change for 6
seconds while the driver's/passenger's/rear doors and tailgate are locked with the above
three conditions met.
2. The sleep mode is deactivated immediately if any of them is out of the specified
conditions (wake-up mode).
Also, the sleep mode is deactivated when receiving the UNLOCK signal from the remote
control key.
3. During the sleep mode, the sleep mode is deactivated for 30 seconds when room
lamp, key hole illumination, tail lamp or power window is operated or after the
system receives the UNLOCK signal from the remote control key.
However, if the lamps and power window mentioned above are "OFF" and the conditions in
item (1) are met, the system enters into the sleep mode again.
Page 378 of 400

RKSTICS
undefined
8710-08
Specifications of Remote Control Key
When any of switches on remote control key is pressed, the integrated CPU in remote control
key sends the coded control message to the CPU in receiver to control the vehicle.
Switch Functions on Remote Control Key
Door Lock Button
Lock (briefly press)
If you press this button briefly, all doors and the
tailgate are locked and the theft deterrent mode
is activated.
When the theft deterrent mode is activated, the
hazard warning flashers blink twice. -
-
Door Unlock/Panic Button
1. Unlock (briefly press)
If you press this button briefly, all doors and the
tail gate are unlocked and the theft deterrent
mode is deactivated.
When the deterrent mode is deactivated,
hazard warning flashers blink once. -
-
2. Panic function (press and hold)
If you are in your vehicle and feel threatened while the
ignition key is inserted into the key switch, you may activate
the alarm to call attention. If you press this button, the
warning siren will sound for approx. 27 seconds.
The panic function will stop when any of the buttons on the
remote control key is pressed. -
-Panic Button
(operative only when the ignition
key is inserted)
The coding signal is transmitted only if pressing the door unlock button long (approx.
2 seconds) when coding the remote control key.