140 Navigation
Route guidance
Muting current voice instructions
Press J.
The current announcement is stopped.
You will hear the next navigation
announcement normally.
Switching voice instructions On/Off
Switching off
During a navigation announcement
press J for 2 seconds.
You will hear a confirmation beep if the
beep tones option was activated in the
system settings (
page 201).
The message
Voice Announcements
Muted
will appear briefly. Further route
guidance takes place using only the
symbols in the display. If a new route
guidance cycle is started, the
announcements are automatically
switched on again.
Switching on again
Press j. The navigation displays are only visible
while route guidance is active.
To switch to the navigation display from
another display, e.g.
from CD operation:
Press b or c .
Two examples are shown below:
Display example 1: The road you are currently driving on is
shown on the status bar, in this case
I-90.
The indication
120 mi is the distance to
the next driving maneuver.
If the GPS position display (
page 154) is
active, the GPS data are shown instead of
the street name.
Navigation displays
i
Using the multifunction steering wheel
buttons, the display unit can be
changed between km or miles (see
your vehicle’s Operator’s Manual).
When the display unit is set to
miles, the COMAND will indicate
distances in miles (mi) or feet (ft).
When the display unit is set to km,
the COMAND will indicate
distances in kilometers (km) or
meters (m).
220_Navigati_US_A_2006.fm Seite 140 Mittwoch, 22. Dezember 2004 1:13 13
150 Navigation
During route guidance
Press a soft key, e.g. .
Press E.
A list of restaurants near your location
is displayed. The arrows left from the entries indicate
the direction of the destination. The
distances indicated are straight line
distances to the destination.
Press
G or g to select a destination
from the list.
Press the Details soft key if required.
Details on the destination are shown.
Name soft key:
Brings you to name input of a stopover
destination (
page 193).
Sort soft key:
Sorts list entries either by increasing
distance or alphabetically.
After you have selected a destination,
press E.
The Start Route Guidance menu will
appear (
page 139).
Press E.
The system calculates the route to the
selected stopover destination. Deleting or replacing a stopover
destination
Activate the soft key display
(
page 144).
Press the St-over soft key.
The menu for deleting or changing a
stopover destination will appear.i
Prior to this, a list may be displayed in
which you can select the desired
category, e.g.
Barbecue/Southern,
pressing G or g .
220_Navigati_US_A_2006.fm Seite 150 Mittwoch, 22. Dezember 2004 1:13 13
