2006 LEXUS LX470 tow

IN CASE OF AN EMERGENCY
353
(b) Using a flat bed truck
40X014b
Tie down points
40X015a
40X016c
If your Lexus is transported by a flat bed, it should be tied
down at locations A and B as shown above.
40X017d
Rear emergency towing hook
NOTICE
Do not use the rear emergency towing hook.

IN CASE OF AN EMERGENCY
354
Tie down angle
40X018c
If you use chains or wires to tie down your vehicle, the
angles shaded black must be at 45.
(c) Towing with a sling type truck
40X021b
NOTICE
Do not tow with a sling type truck, either from the front
or rear. This may cause body damage.

IN CASE OF AN EMERGENCY
355
(d) Emergency towing
40x600a
If towing is necessary, we recommend you to have it done
by your Lexus dealer or a commercial tow truck service.
If towing service is not available in an emergency, your
vehicle may be temporarily towed by a cable or chain
secured to the emergency towing hook. Use extreme
caution when towing the vehicle.
NOTICE
Never tow a vehicle from the rear with four wheels on the
ground. This may cause serious damage to the
transmission.
A driver must be in the vehicle to steer it and operate the
brakes.
Towing in this manner may be done only on hard −surfaced
roads for a short distance and at low speeds. Also, the wheels,
axles, drive train, steering and brakes must all be in good
condition.
CAUTION
Use extreme caution when towing the vehicle. Avoid
sudden starts or erratic driving maneuvers which would
place excessive stress on the emergency towing hook
and towing cable or chain. The hook and towing cable
or chain may break and cause serious injury or damage.
NOTICE
 Do not use front and rear eyelets. It is not designed
for towing.
 Use only a cable or chain specifically intended for
use in towing vehicles. Securely fasten the cable or
chain to the towing hook provided.
Before towing, check that the center differential is unlocked.
(The indicator light must be off with the ignition on.) Release
the parking brake and put the transmission in “N”. The ignition
key must be in “ACC” (engine off) or “ON” (engine running).

IN CASE OF AN EMERGENCY
356
CAUTION
If the engine is not running, the power assist for the
brakes and steering will not work so steering and
braking will be much harder than usual.
Emergency towing hook precautions:
Before emergency towing, check that the hook is not broken
or damaged and that the installation bolts are not loose.
 Fasten the towing cable or chain securely to the hook.
 Do not jerk the hook. Apply steady and even force.
 To avoid damaging the hook, do not pull from the side or at
a vertical angle. Always pull straight ahead.
CAUTION
If the emergency towing hook is used to get out when
your vehicle becomes stuck in the mud, sand or other
condition from which the vehicle cannot be driven out
under its own power, make sure to observe the
precautions mentioned below. Otherwise, excessive
stress will be put on the hook and the towing cable or
chain may break, causing serious injury or damage.
If the towing vehicle can hardly move, do not forcibly
continue the towing. Contact your Lexus dealer or a
commercial tow truck service for assistance.
 Tow the vehicle as straight ahead as possible.
 Keep away from the vehicle during towing.
Tips for towing a stuck vehicle:
The following methods are effective to use when your
vehicle is stuck in the mud, sand or other condition from
which the vehicle cannot be driven out under its own
power. Use extreme caution when towing the vehicle. In
addition, keep away from the vehic les and towing cable or
chain when towing.
 Remove the sand and soil in the front and the back of the
tires.
 Place stones or wood under the tires.

INTRODUCTION
398
NOTICE
Remember that battery and ignition cables carry high
currents or voltages. Be careful of accidentally
causing a short circuit.
 Add only “T oyota Super Long Life Coolant” or similar
high quality ethylene glycol based nonsilicate,
nonamine, nonnitrite, and nonborate coolant with
longlife hybrid organic acid technology to fill the
radiator. “Toyota Super Long Life Coolant” is a
mixture of 50% coolant and 50% deionized water (for
the U.S.A.) or 55% coolant and 45% deionized water
(for Canada).
 If you spill some of the coolant, be sure to wash it off
with water to prevent it from damaging the parts or
paint.
 Before closing the engine hood, check to see that you
have not forgotten any tools, rags, etc.
 Do not drive with the air cleaner removed, or
excessive engine wear could result. Also backfiring
could cause a fire in the engine compartment.
 Do not overfill automatic transmission fluid, transfer
oil and power steering fluid, or the transmission,
transfer and power steering could be damaged.
 Be careful not to scratch the glass surface with the
wiper frame.
PARTS AND TOOLS
Here is a list of parts and tools you will need to perform
do−it−yourself maintenance. Remember all Lexus parts are
designed in metric sizes, so your tools must be metric.
Checking the engine oil level
Parts (if level is low):
“Toyota Genuine Motor Oil” or equivalent
Oil grade: ILSAC multigrade engine oil. For recommended
oil viscosity, see page 412.
Tools:
 Rag or paper towel
 Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low):
“Toyota Super Long Life Coolant” or similar high quality
ethylene glycol based non −silicate, non −amine, non −nitrite,
and non −borate coolant with long life hybrid organic acid
technology.
“Toyota Super Long Life Coolant” is a mixture of 50% coolant
and 50% deionized water (for the U.S.A.) or 55% coolant
and 45% deionized water (for Canada).
Tools:
 Funnel (only for adding coolant)

INTRODUCTION
399
Checking brake fluid
Parts (if level is low):
FMVSS No. 116 DOT 3 or SAE J1703 brake fluid
Tools:
 Rag or paper towel
 Funnel (only for adding fluid)
Checking power steering fluid
Parts (if level is low):
Automatic transmission fluid DEXRON
II or III
Tools:
 Rag or paper towel
 Funnel (only for adding fluid)
Checking suspension fluid AHC
Parts (if level is low):
Suspension fluid AHC
Tools:
 Rag or paper towel
 Funnel (only for adding fluid)
Checking battery condition
Tools:
Warm water
 Baking soda
 Grease
 Conventional wrench (for terminal clamp bolts)
Checking and replacing the blade type fuses
Parts (if replacement is necessary):
Fuse with same amperage rating as original
Checking the cartridge type fuses
Parts (if replacement is necessary):
Genuine Lexus fuse or equivalent with same amperage
rating as original
Adding washer fluid
Parts:
Water
 Washer fluid containing antifreeze (for winter use)
Tools:
 Funnel

CHASSIS
420– STEERING
Free play
Less than 40 mm (1.6 in.)
Power steering fluidAutomatic transmission fluid DEXRONII or III
– SUSPENSION
Fluid type
Suspension fluid AHC
– TIRES AND WHEELS
Tire sizeP275/60R18 111H
Tire inflation pressure
Recommended cold tire inflation pressure
Normal driving
Trailer towing
Front 200 kPa (2.0 kgf/cm2 or bar, 29 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Spare 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 240 kPa (2.4 kgf/cm2 or bar, 35 psi)
Spare 240 kPa (2.4 kgf/cm2 or bar, 35 psi)
Wheel size18 x 8J
Wheel nut torque131 N·m (13.4 kgf·m, 97 ft·lbf.)
NOTE:
For complete information on tires (e.g. replacing tires or replacing wh\
eels), see “Checking tire inflation pressure”
through “Aluminum wheel precautions” on page 424 through 443.

ELECTRICAL COMPONENTS
447
64x502b
Driver’s side kick panel
64X501b
Passenger’s side kick panel
No.FuseAMPERECIRCUIT
1 ABS NO.240Anti− lock brake system
2 ABS NO.150Anti−lock brake system
3 AHC50Active height control suspension
(AHC)
4 WIPS7.5No circuit
5 TOWING30Trailer lights
6 MIR HTR15Outside rear view mirror
defogger
7 RR HTR10Rear air conditioning system
8 HAZTRN15Emergency flashers, Turn signal
lights
9 ALTS7.5Charging system
10 NVIR20Lexus night view system
11 FR FOG15Fog lights
12 TOWING
BRK30Trailer lights
13 HEAD
CLNER20Headlight cleaner
14 FRIG10Charging system
15 PANEL7.5Instrument panel light
16 TOWING TAIL30Trailer lights