2006 LEXUS LX470 tow

OCCUPANT RESTRAINT SYSTEMS
108
16X185b
Third seat
Lean forward and pull the lock release lever. Then lean
back to the desired angle and release the lever.
CAUTION
Avoid reclining the seatback any more than needed.
The seat belts provide maximum protection when the
passengers are sitting up straight and well back in the
seats. If you are reclined, the lap belt may slide past
your hips and apply restraint forces directly to the
abdomen or your neck may contact the shoulder belt.
In the event of a frontal collision, the more the seat is
reclined, the g reater the risk of death or personal injury.
Tumbling second seat for third seat entry
16X186b
For easy access to the third seat, tumble the second seat
in accordance with the following procedure.
Before tumbling the second seat, stow the second seat
buckles as shown in the illustration.
This prevents the buckles from falling out when you tumble the
second seat.
NOTICE
The seat belt buckles must be stowed before you tumble
the second seat.

OCCUPANT RESTRAINT SYSTEMS
11 0
Tumbling second seat
16X186b
Before tumbling the second seat, stow the second seat
buckles as shown in the illustration.
This prevents the buckles from falling out when you tumble the
second seat.
NOTICE
The seat belt buckles must be stowed before you tumble
the second seat.
16X646
1. Lower the head restraints to the lowest position, unlock
the seatback by pulling the lever on the side of the
seatback and fold it down.
16X188c
2. Pull the lever under the seat cushion or pull the strap on
the rear end of the seat cushion and swing the whole seat
forward.

OCCUPANT RESTRAINT SYSTEMS
11 2
16x248a
If you cannot raise the seatback because of the locked seat
belt, do not try it hard. Release the lock of the seat belt in the
following way.
1 Push in the lower front edge of the seatback cushion to
slacken the seat belt.
2Let the seat belt retract a little.
CAUTION
Do not sit on or place anything on the tumbled
seatback while driving.
 Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback and
by trying to pull up the edge of the bottom cushion.
Failure to do so will prevent seat belt from operating
properly.
Tumbling third seat
16X190b
Before tumbling the third seats, stow the third seat belt
and buckles as shown in the illustration.
This prevents the belt and buckles from falling out when you
tumble the third seat.

OCCUPANT RESTRAINT SYSTEMS
11 3
16X233
Seat belt hanger
For the outer seat belts, use the seat belt hangers to
prevent the belts from being tangled.
NOTICE
 The seat belts must be stowed before you tumble the
third seat.
16x623
Make sure to stow the third center seat belt in order
not to cause damage on the seat belt by pinching it
between the third seat inner leg and seat striker.

OCCUPANT RESTRAINT SYSTEMS
11 5
16X624
4. Remove the seat hook covers from the back of the seat
cushion and install them onto the seat anchor brackets.
CAUTION
Be sure to install the seat hook covers on the seat
hooks, or you may get burned when they become hot.
16X195c
When returning the third seat to its original position, stow the
holding strap and the seat hook covers into the holder facing
the direction shown in the illustration.
5. To return it to the original position, reverse the steps
above.
CAUTION
 Do not sit on or place anything on the tumbled
seatback while driving.
 Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback and
by trying to pull up the edge of the bottom cushion.
Failure to do so will prevent seat belt from operating
properly.

OCCUPANT RESTRAINT SYSTEMS
11 6
Removing third seats
16X190a
Before removing the third seats, stow the third seat belt
and buckles as shown in the illustration.
This prevents the belt and buckles from falling out when you
tumble the third seat.
16X233
Seat belt hanger
For the outer seat belts, use the seat belt hangers to
prevent the belts from being tangled.
NOTICE
 The seat belts must be stowed before you tumble the
third seat.

OCCUPANT RESTRAINT SYSTEMS
11 7
16X623
Make sure to stow the third center seat belt in order
not to cause damage on the seat belt by pinching it
between the third seat inner leg and seat striker.
16X192c
1. Lower the head restraint to the lowest position. Pull the
reclining lever up and fold down the seatback.
16X193g
2. While turning the lever, lift and slide the whole seat
backward.

STEERING WHEEL AND MIRRORS
197
Compass (vehicles without navigation
system)
16x271a
The compass indicates the direction in which the vehicle
is heading. The illustration shown above indicates that the
vehicle is heading north.Displays
Directions
N
NE
E
SE S
SW W
NWNorth
Northeast
East
Southeast South
Southwest West
Northwest
Pushing the “AUTO” button for longer than 3 seconds
turns on or off the compass display.
The compass may not show the correct direction in the
following conditions:
 The vehicle is stopped immediately after turning.
The compass does not adjust while the vehicle is stopped.
 The ignition switch is turned off immediately after turning.
 The vehicle is on an inclined surface.
 The vehicle is in a place where the earth’s magnetic field is
subject to interference by artificial magnetic fields
(underground parking, under a steel tower, between
buildings, roof parking, near a crossing, near a large
vehicle, etc.).
 The vehicle is magnetized. (There is a magnet or a metal
object on or near the inside rear view mirror.)
 The battery has been disconnected.
 Any door is open.
If the deviation is small, the compass works to calibrate the
direction automatically while the vehicle in motion.
For obtaining additional precision or for complete calibrating,
see “CALIBRATING THE COMPASS” below.