2006 LEXUS LX470 low

OCCUPANT RESTRAINT SYSTEMS
172
16X070c
CAUTION
Never install a rearfacing child restraint system on
the front passenger seat even if the front passenger
occupant classification indicator light indicates
“OFF”. In the event of an accident, the force of the
rapid inflation of the front passenger airbag can
cause death or serious injury to the child if the
rearfacing child restraint system is installed on the
front passenger seat.
16x633
 If the driver’s seat position does not allow sufficient
space for safe installation, install the child restraint
system on the second right seat.
 Child restraint systems installed on the second seat
should not contact the front seat backs.

OCCUPANT RESTRAINT SYSTEMS
173
16X106a
1. Run the lap and shoulder belt through or around the infant
seat following the instructions provided by its manufacturer
and insert the tab into the buckle taking care not to twist the
belt. Keep the lap portion of the belt tight.
CAUTION
After inserting the tab, make sure the tab and buckle
are locked and that the lap and shoulder portions of
the belt are not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent you from properly latching the tab and
buckle.
 If the seat belt does not function normally, it cannot
protect your child from death or serious injury.
Contact your Lexus dealer immediately. Do not
install the child restraint system on the seat until the
seat belt is fixed.
16X107a
2. Fully extend the shoulder belt to put it in the lock mode.
When the belt is then retrac ted even slightly, it cannot be
extended.
To hold the infant seat securely, make sure the belt is in the lock
mode before letting the belt retract.

OCCUPANT RESTRAINT SYSTEMS
174
16X108a
3. While pressing the infant seat firmly against the seat
cushion and seatback, let the shoulder belt retract as far as it
will go to hold the infant seat securely.
16X109a
CAUTION
Push and pull the child restraint system in different
directions to be sure it is secure. Follow all the
installation instructions provided by its manufacturer.

OCCUPANT RESTRAINT SYSTEMS
175
16X207
4. To remove the infant seat, press the buckle release button
and allow the belt to retract completely. The belt will move
freely again and be ready to work for an adult or older child
passenger.(B) Convertible seat installation
16X104b
A convertible seat must be used in forwardfacing or
rearfacing
position depending on the age and size of the
child. When installing, follow the manufacturer’s
instructions about the appropriate age and size of the
child as well as directions for installing the child restraint
system.

OCCUPANT RESTRAINT SYSTEMS
176Install the child restraint system on the front passenger seat
only when it is unavoidable. Your vehicle is equipped with a
front passenger occupant classification system. In order to
activate
the occupant classification system correctly, install the
forward−facing child restraint system on the front passenger
seat in the following order:
1. Turn the ignition key to the “ON” position.
2. Move the front passenger seat to the rearward position.
3. Put the child restraint system on the front passenger seat
without putting your weight on the front passenger seat.
4. Insert the seat belt tab into the seat belt buckle.
5. Fully extend the shoulder belt to put it in the lock mode.
When the belt is then retrac ted even slightly, it cannot be
extended. To hold the seat securely, make sure the belt is in the
lock mode before letting the belt retract.
6. While pressing the convertible seat firmly against the seat
cushion and seatback, let the shoulder belt retract as far as it
will go to hold the convertible seat securely.
CAUTION
Push and pull the child r estraint system in different
directions to be sure it is secure. Follow all the
installation instructions pr ovided by its manufacturer.
7. Put a child on the child restraint system and secure the child,
complying with the instructions provided by the child restraint
system manufacturer. The occupant classification indicator light should indicate
“OFF”
when the ignition key is in the “ON” position and the child
is in the child restraint system after following these procedures.
The “OFF” indicator indicates the SRS front passenger airbag
will not deploy. If the indicator light indicates “ON”, remove the
child restraint system and reinstall it with the ignition key in the
“ACC” or “LOCK” position. If the indicator light still indicates
“ON” when the ignition key is turned to the “ON” position, then
the SRS front passenger airbag may deploy in an accident. Do
not drive the vehicle in this condition. Remove the child
restraint system and contact your Lexus dealer.
CAUTION
Never install a rearfacing child restraint system on
the front passenger seat. A forwardfacing child
restraint system should only be installed on the front
passenger seat when unavoidable. If you must install
the child restraint system on the front passenger
seat, put the seat in its mo st rearward position, and
install the forwardfacing child restraint system in
the proper order. Otherw ise, the front passenger
occupant classification system cannot detect the
presence of the child rest raint system and the front
passenger airbag could deploy.

OCCUPANT RESTRAINT SYSTEMS
177
16X071b
CAUTION
Never install a rearfacing child restraint system on
the front passenger seat even if the front passenger
occupant classification indicator light indicates
“OFF”. In the event of an accident, the force of the
rapid inflation of the front passenger airbag can
cause death or serious injury to the child if the
rearfacing child restraint system is installed on the
front passenger seat.
16X111b
 Move seat fully back
 A forwardfacing child restraint system should be
allowed to be installed on the front passenger seat
only when it is unavoidable. Always move the seat
as far back as possible even if the front passenger
occupant classification indicator light indicates
“OFF”, because the front passenger airbag could
inflate with considerable speed and force. Otherwise,
the child may be killed or seriously injured.
 Do not allow the child to lean his/her head or any part
of his/her body against the door or the area of the
seat, front or rear pillar or roof side rail from which the
side airbags or curtain shield airbags deploy even if
the child is seated in the child restraint system. It is
dangerous if the side airbag and curtain shield airbag
inflate, and the impact could cause death or serious
injury to the child.

OCCUPANT RESTRAINT SYSTEMS
178
16x634
If the driver’s seat position does not allow sufficient
space for safe installation, install the child restraint
system on the second right seat.
 Child restraint systems installed on the third seat
should not contact the second seat backs.
16X112a
1. Run the lap and shoulder belt through or around the
convertible seat following the instructions provided by its
manufacturer and insert the tab into the buckle taking care not
to twist the belt. Keep the lap portion of the belt tight.
CAUTION
 After inserting the tab, make sure the tab and buckle
are locked and that the lap and shoulder portions of
the belt are not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent you from properly latching the tab and
buckle.
 If the seat belt does not function normally, it cannot
protect your child from death or serious injury.
Contact your Lexus dealer immediately. Do not
install the child restraint system on the seat until the
seat belt is fixed.

OCCUPANT RESTRAINT SYSTEMS
180
16X115a
CAUTION
Push and pull the child restraint system in different
directions to be sure it is secure. Follow all the
installation instructions provided by its manufacturer.
16X116a
4. To remove the convertible seat, press the buckle release
button and allow the belt to retract completely. The belt will
move freely again and be ready to work for an adult or older
child passenger.