2006 LEXUS LX470 low

AIR CONDITIONING
212
Center vents
20X039d
The center vents may be opened or closed as shown.
Side vents
20X025c
The side vents may be opened or closed as shown.
Lower vent
20X026a
The lower vent may be opened or closed as shown.
For removing frost or fog, it is recommended that you close the
lower vent when you push the windshield air flow button or use
the “Floor” or the “Floor/Windshield” mode.

AIR CONDITIONING
213
REAR AIR CONDITIONINGCONTROLS
20X054b
The control panel is located in the roof panel above the
second seat.
1 Automatic control button
2 Air flow control buttons
3 OFF button
4 Temperature control lever
5 Fan speed control buttons
The automatic air conditioning automatically maintains the set
temperature.
This air conditioning features automatic fan speed and air flow
control which automatically se lects the most suitable fan
speed and air flow to control the temperature. The ignition key
must be in the “ON” position.
NOTICE
To prevent the battery from being discharged, do not
leave the air conditioning on longer than necessary
when the engine is not running.

AIR CONDITIONING
214
21x611
Warm air
Cool airSETTING OPERATION automatic control
20X055a
1. Push the “AUTO” button.
Air flow quantity and switching of the diffusers are
automatically
adjusted. The operation status is shown by each
indicator.
When one of the manual control buttons is depressed while
operating in automatic mode, the operation corresponding to
the button depressed is set. Other conditions continue to be
adjusted automatically.
Push the “OFF” button to turn the rear air conditioning off.

AIR CONDITIONING
215
20X056
2. Use the temperature control lever to set the desired
temperature.
Slide the lever to the right for higher temperature and to the left
for lower temperature.
In the vehicles sold in U.S.A., the figures above the
temperature control lever are the temperature in degrees
Fahrenheit, while in the vehicles sold in Canada, the
temperature is indicated in degrees Centigrade. SETTING OPERATION manual control
If manual air flow selection is desired
20X057a
The outlets from which air is delivered can be selected
manually by
pressing in the appropriate air flow control button.
The function of each button is as follows:
1 Panel − Air flows mainly from the roof panel vents.
2
Bilevel − Air flows from both the floor vents and the roof
panel vents.
3 Floor − Air flows mainly from the floor vents.
Air at higher than room temperature does not flow from the roof
panel vents.
Air at lower than room temperature does not flow from the floor
vents.

AIR CONDITIONING
216If manual fan speed control is desired
20X058a
 1
Low speed 2Middle speed
3High speed
The fan speed can be set to your desired speed by pushing the
appropriate fan speed control button. The higher the fan speed
is, the more air is delivered. Pushing the “OFF” button turns
off the fan.

AUDIO
221
21X553
In the “TAPE” or “CD” mode, the applicable functions are
shown in the lowest part of the display. Push the switch
just below to turn on each function.
(b) Tone and balance
How good an audio program sounds to you is largely
determined by the mix of the treble, mid −range, and bass
levels. In fact, different kinds of music and vocal programs
usually sound better with different mixes of treble, mid− range,
and bass.
A good balance of the left and right stereo channels and of the
front and rear sound levels is also important.
Keep in mind that if you are listening to a stereo recording or
broadcast, changing the right/left balance will increase the
volume of one group of sounds while decreasing the volume
of another.
22X612
Each time you push the “AUDIOTUNE” knob, the display
changes as in the following. To adjust the tone and
balance or turn on or off the automatic sound levelizer,
turn the knob.
BAS: Adjusts low− pitched tones.
MID: Adjusts mid− pitched tones.
TRE: Adjusts high− pitched tones.
FAD: Adjusts the sound balance between the front and rear
speakers.
BAL: Adjusts the sound balance between the right and left
speakers.
ASL: Turns on or off the automatic sound levelizer.
Automatic Sound Levelizer (ASL): When the audio sound
becomes difficult to be heard due to road noise, wind noise,
etc. during driving, the system adjusts to the optimum volume
and tone quality according to the noise level. While the
Automatic Sound Levelizer (ASL) is on, “ASL” appears on the
display.

AUDIO
222(c) Your power antenna
The antenna automatically extends when the radio is on, and
retracts
when the radio mode is off. However, even if you turn
off the radio when the radio on the rear seat audio system is on,
the antenna does not retract.
21X509
To adjust the height of the antenna manually, push the
switch at either side, this may be performed during
antenna extension. The maximum extension length is 850
mm (33.5 in.).
Every time you turn the radio on, the antenna will extend to its
previous position.
Clean the antenna mast periodically with a clean dry cloth.
CAUTION
Before extending the antenna, confirm that no one is
close enough to get injured.
NOTICE
 Retract the antenna when entering or passing
through low structures, such as a garage or an
automatic car wash. Failure to do so may damage the
antenna.
 The antenna mast has to be extended higher than 100
mm (3.94 in.) length when the audio is on. Extend the
antenna mast when the radio signal is weak.
 Putting a film (especially a conductive or metallic
film) on the righthand rear quarter window may
affect the reception of radio or mobile telephone. For
the installation of the film, consult with your Lexus
dealer.

AUDIO
225
(b) Presetting a station
21X555
1. Tune in the desired station.
2. Push
one of the station selector buttons ( 16 ) and hold
it until a beep is heard. This sets the station to the button
and the button number ( 16 ) appears on the display.
Each button can store one AM station and two FM stations. To
change the preset station to a different one, follow the same
procedure.
The preset station memory is cancelled when the power
source is interrupted by battery disconnection or a blown fuse. (c) Selecting a station
Tune in the desired station using one of the following methods.
21X556b
Preset
tuning: Push the button ( 1− 6 ) for the station you want.
The button number ( 1− 6 ) and station frequency appear on the
display.
Manual tuning: Turn the “AUDIO− TUNE” knob. The radio will
step up or down to another frequency.
Seek tuning: Push the “SEEK” button. The radio will begin
seeking up or down for a station of the nearest frequency and
will stop on reception. Each time you push the button, the
stations will be searched automatically one after another.