2006 HONDA CIVIC brake

´´
Although this seems like a simple
procedure, you should take several
precautions.
You cannot start your vehicle with an
automatic transmission by pushing
or pulling it.
Open the hood, and check the
physical condition of the battery.
In very cold weather, check the
condition of the electrolyte. If it
seems slushy or f rozen, do not try
jump starting until it thaws.
The numbers in the illustration show
you the order to connect the jumper
cables.
To jump start your vehicle:
Connect one jumper cable to the
positive ( ) terminal on your
battery. Connect the other end to
the positive ( ) terminal on the
booster battery.
Turn of f all the electrical
accessories: heater, A/C (if
equipped), audio system (if
equipped), lights, etc. Put the
transmission in neutral (M/T) or
Park (A/T), and set the parking
brake.
1. 2.
3.
CONT INUED
Jump Starting
T aking Care of t he Unexpect ed
225
BOOSTER
BATTERY
A battery can explode if you do
not follow the correct procedure,
seriously injuring anyonenearby.
Keep all sparks, open flames,
and smoking materials away
from the battery.If a battery sits in extreme cold, the
electrolyte inside can f reeze.
Attempting to jump start with a f rozen
battery can cause it to rupture.
——y
y
(#yy

If you do not f ind an obvious leak,
check the coolant level in the
radiator reserve tank. Add coolant
if the level is below the MIN mark.
Look f or any obvious coolant leaks,
such as a split radiator hose.
Everything is still extremely hot,
so use caution. If you f ind a leak, it
must be repaired bef ore you
continue driving (see
on page ).
If the temperature gauge reading
stays at the red mark, turn of f the
engine.
Saf ely pull to the side of the road.
Put the transmission in neutral
(M/T) or Park (A/T), and set the
parking brake. Turn of f all the
accessories, and turn on the
hazard indicator.
If you see steam and/or spray
coming f rom under the hood, turn
of f the engine. Wait until you see
no more signs of steam or spray,
then open the hood.
If you do not see steam or spray,
leave the engine running, and
watch the temperature gauge. If
the high heat is due to overloading,
the engine should start to cool
down almost immediately. If it
does, wait until the temperature
gauge reading comes down to the
midpoint, then continue driving.
1. 2. 3.
4. 5. 6.
237
CONT INUED
If theEngineOverheats
Emergency
Towing
T aking Care of t he Unexpect ed
227
Steam and spray from an
overheated engine can
seriously scald you.
Do not open the hood if steam
is coming out.
——y
y
(#yy

However, if the brake pedal does not
f eel normal, you should take
immediate action. A problem in one
part of the system’s dual circuit
design will still give you braking at
two wheels. You will f eel the brake
pedal go down much f arther bef ore
the vehicle begins to slow down, and
you will have to press harder on the
pedal.
Slow down by shif ting to a lower
gear, and pull to the side of the road
when it is saf e. Because of the long
distance needed to stop, it is
hazardous to drive the vehicle. You
should have it towed and repaired as
soon as possible (seeon page ).
If you must drive the vehicle a short
distance in this condition, drive
slowly and caref ully.
The brake system indicator
normally comes on when
you turn the ignition switch
to the ON (II) position and
as a reminder to check the
parking brake. It will stay
on if you do not f ully
release the parking brake.
If the brake system indicator comes
on while driving, the brake f luid level
is probably low. Press lightly on the
brake pedal to see if it f eels normal.
If it does, check the brake f luid level
thenexttimeyoustopataservice
station (see page ). If the ABS indicator comes on with
the brake system indicator, have
your vehicle inspected by your
dealer immediately.
If the f luid level is low, take your
vehicle to a dealer, and have the
brake system inspected f or leaks or
worn brake pads. 198
237Emergency
Towing
Brake System Indicator
T aking Care of t he Unexpect ed
231
Canada U.S.
——y
y
(#yy

The under-hood f use box is on the
driver’s side, next to the brake f luid
reservoir. To open it, push the tabs
as shown.If something electrical in your
vehicle stops working, the first thing
youshouldcheckforisablownfuse.
Determine f rom the chart on pages
and , or the diagram on the
f use box lid, which f use or f uses
control that device. Check those
f uses f irst, but check all the f uses
bef ore deciding that a blown f use is
the cause. Replace any blown f uses,
and check if the device works.
Thefusesareintwofuseboxes.The
interior f use box is underneath the
steering column. 235 236
Fuses
Checking and Replacing Fuses
232
INTERIOR
UNDER-HOOD
TAB
FUSE LABEL
——
y
y
(#yy

µµ
If yo ur vehic le needs to be to wed,
c all a pro fessio nal to wing servic e o r
o rg anizatio n. Never to w yo ur vehic le
with just a ro pe o r c hain. It is very
dang ero us. T he o perato r
lo ads yo ur vehic le o n the bac k o f a
truck.
Therearetwo waysto towyour
vehic le: If, due to damag e, yo ur vehic le must
be to wed with the fro nt wheels o n
the g ro und, do this:
Release the parking brake.
Release the parking brake.
Start the eng ine.
Shiftto D,thento N.
Turn o ff t he e ng in e. speedbelow35mph(55km/h).
The tow
truck uses two pivoting arms that go
under the tires ( fro nt) and lift them
o ff the g ro und. T he o ther two tires
remain o n the g ro und.
M anual T ransmissio n:
Auto matic T ransmissio n:
CONT INUED
Flat -bed EquipmentWheel-lif t Equipment
This is the best way to trans-
port your vehicle.
T his is an
acceptable way to tow your
vehicle.
Emergency Towing
T aking Care of t he Unexpect ed
237
Improper towing preparation will
damage the transmission. Follow the
above procedure exactly. If you cannot
shif t the transmission or start the
engine (automatic transmission), your
vehicle must be transported with the
f ront wheels of f the ground.
——y
y
(#yy
W it h t he f r o nt w hee ls o n t he g ro und,
50 m iles ( 80 k m ) , a n d k eep t h e
do no t
t o w t h e v e h ic le mo re than
Shift the transmissio n to neutral.
Leave the ignition switch in
the ACCESSORY (I) position so
the steering wheel does not lock.
Leave the ignition switch in
the ACCESSORY (I) position so
the steering wheel does not lock.

µµµ
µ µµ µ µµµµµµµµµ
Î ÎÎ
µµµµ
Î ÎÎ
ÎÎ
Specif icat ions
Technical Inf ormation
243
Air Conditioning Fuses
Alignment
Battery Tires
Lights
HFC-134a (R-134a)
14.1 15.9 oz (400 450 g) SP-10
12 V 60 W (HB3)
7°24’1°30’
0°
0.00 in (0.0 mm)
P195/65R15 89H 0.08 in (2.0 mm)
Refrigerant type
Charge quantity
Lubricant oil type
Interior
Under-hood
Toe-in
CamberCaster
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
8W
5W
21 W
3CP
21 W
21/5 W
21 W
21/5 W
12 V 51 W (HB4)
12 V 2 CP
12 V 8 W
12 V 5 W
Capacity 12 V P205/55R16 89H
Size
Pressure
12 V 45 AH/20 HR 36 AH/5 HR T125/70D15 95M
60 psi (420 kPa , 4.2 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm)
30 psi (210 kPa , 2.1 kgf/cm)
See page 236 or the fuse label
attached to the inside of the fuse
box door under the steering
column.
See page 235 or the fuse box
cover.
Headlights
Front turn signal/side marker/
Parking lights
Rear turn signal lights
Stop/Taillights
Rear side marker lights
Back-up lights
Taillights
High-mount brake light
License plate lights
Ceiling light
Spotlights
Trunk light
12 V
12 V38 AH/5 HR
45 AH/20 HR
HighLow
FrontRear
FrontRear
Front
1: LX,EX 1:
2: LX,EXFront/Rear
Spare
Front/Rear
Spare
DX, Canadian DX-G
U.S.
Vehicles
Canada
Vehicles
1 12
12
——y

y
(#yy

If you take your vehicle f or a state
emissions test shortly af ter the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the on-
board diagnostics f or the emissions
systems. These codes are erased
when the battery is disconnected,
and set again only after several days
of driving under a variety of
conditions.
If the testing f acility determines that
the readiness codes are not set, you
will be requested to return at a later
date to complete the test. If you must
get the vehicle retested within the
next two or three days, you can
condition the vehicle f or retesting by
doing the f ollowing.Make sure the gas tank is nearly,
but not completely f ull (around
3/4). Without touching the accelerator
pedal, start the engine, and let it
idle f or 20 seconds.
Select a nearby lightly traveled
major highway where you can
maintain a speed of 50 to 60 mph
(80to97km/h)foratleast20
minutes. Drive on the highway in
D (A/T) or 5th (M/T). Do not usethecruisecontrol.Whentraffic
allows, drive f or 90 seconds
without moving the accelerator
pedal. (Vehicle speed may vary
slightly; this is okay.) If you cannot
do this f or a continuous 90
seconds because of traf f ic
conditions, drive f or at least 30
seconds, then repeat it two more
times (for a total of 90 seconds).
Then drive in city/suburban
traffic for at least 10 minutes.
When traffic conditions allow, let
the vehicle coast f or several
seconds without using the
accelerator pedal or the brake
pedal.
Make sure the vehicle has been
parked with the engine of f f or 6
hours or more.
Make sure the ambient
temperature is between 40° and
95°F.
Keep the vehicle in Park
(automatic transmission) or
neutral (manual transmission).
Increase the engine speed to 2,000
rpm,andholditthereuntilthe
temperature gauge rises to at least
1/4of thescale(about3minutes).
If the testing f acility determines the
readiness codes are still not set, see
your dealer.Stop the vehicle, turn of f the
ignition switch, and leave it of f f or
30 minutes.
T esting of Readiness Codes
St at e Emissions T est ing
250
——y
y
(#yy

CONT INUED
BatteryCharging System ...........................
Indicator . 64, 229
............................
Jump Starting . 225
..............................
Maintenance . 215
............................
Specif ications . 243
..............................
Bef ore Driving . 149
..................................
Belts, Seat . 10, 20
.........................
Beverage Holders . 100
Brakes
...........
Anti-lock System (ABS) . 172
.............
Break-in, New Linings . 150
....................
Bulb Replacement . 203
...........................................
Fluid . 198
.................
Pad Wear Indicators . 171
.......................................
Parking . 170
.................
System Indicator . 60, 231
.............................
Braking System . 171
.................
Break-in, New Vehicle . 150
..
Brightness Control, Instruments . 72
........................
Brights, Headlights . 71
....................................
Accessories . 155
ACCESSORY (Ignition Key
.......................................
Position) . 77
.............
Accessory Power Socket . 100
....................
Additives, Engine Oil . 192
.............................
Airbag (SRS) . 11, 23
...
Airbags, Additional Information . 23
...
Additional Safety Precautions . 34
..........
AdvancedAirbagSystem .28
.............................
Airbag Service . 33
How the Passenger Airbag Of f
......................
Indicator Works . 32
How the Side Airbag Of f ......................
Indicator Works . 32
..
How the SRS Indicator Works . 31
How Your Front Airbags
.........................................
Work . 26
...
How Your Side Airbags Work . 29
How Your Side Curtain Airbags
.........................................
Work . 31
........................
SRS Components . 23
..............
Air Conditioning System . 102
.......................
Air Pressure, Tires . 210
......................................
Antif reeze . 194 Anti-lock Brakes (ABS)
...............................
Indicator . 61, 172
...................................
Operation . 172
..............
Anti-thef t, Audio System . 142
Anti-thef t Steering Column
..........................................
Lock . 77
............................................
Armrest . 90
................................
Audio System . 106
.....
Auto Door Locking/Unlocking . 79
.........................
Auto Door Locking . 79
.....................
Auto Door Unlocking . 81
...
Automatic Seat Belt Tensioners . 21
.............
Automatic Speed Control . 145
..............
Automatic Transmission . 166
..........................
Capacity, Fluid . 242
...............
Checking Fluid Level . 196
.......................................
Shif ting . 166
Shif t Lever Position
...............................
Indicators . 166
................
Shif t Lever Positions . 167
....................
Shif t Lock Release . 169
Index
A B
INDEX
I
——y

y
(#yy