2006 FIAT DUCATO warning

fig. 13
F0D0263m
After using the rear side
seat belts (first row seats),
fasten seat belts into the relevant
catches set aside the seats to pre-
vent obstacles when getting in/out
of the vehicle.
WARNING
16GETTING TO KNOW YOUR VEHICLE
fig. 12
F0D0262m
fig. 11
F0D0261m
For rear single seats
(Panorama versions) and
bench seats (Combi versions)
The rear seat is fitted with inertial
seat belts with three anchor points
and reel for the side and centre seats
fig. 11.For their use see the following fig-
ures:
- fig. 11first row left-hand side seat
- fig. 12first row central seat
- fig. 13first row right-hand side seat
On certain versions, after using seat
belts, insert tongues Dinto the rele-
vant catches Eto prevent obstacles
when getting in/out of the vehicle.

17GETTING TO KNOW YOUR VEHICLE
For rear central bench seat,
lap belt without retractor
(Combi versions)
To fasten the seat belt: insert the
fastener tongue A-fig. 14into the
buckle Buntil hearing the locking
click.
Side seats are fitted with seat belts
with three anchor points.
To unfasten the seat belts: press
button C.
To adjust the seat belt: slide the web-
bing through adjuster D, pulling end E
to shorten it and length F to length-
en it.
IMPORTANT The belt is adjust-
ed properly when it fits closely across
the hips.
fig. 14
F0D 0002m
Remember that in the case
of a violent collision, back
seat passengers not wearing seat
belts also represent a serious dan-
ger to the passengers in the front
(Panorama, Combi and CrewCab
versions).
WARNING
For rear central bench seat,
seat belt with retractor
(Combi versions)
Rear bech seat is fitted with three
point belt and retractor for central
seat.
fig. 15
F0D0291m
Belt use is shown in fig. 15
fig. 15a
F0D0298m
The rear central seat belt
safety action is only guar-
anteed when the bench seat back-
rest is tilted backwards completely
(see figure 15a).
WARNING

Always adjust the height of the seat
belt to fit the person wearing it. This
could greatly reduce the risk of injury
in the case of collision.
The belt is adjusted properly when
the webbing passes approximately
halfway between the edge of the
shoulder and the neck.
5 different adjustments in height are
provided.PRETENSIONERS
Ducato vehicles fitted with airbags
are also fitted with pretensioners to
improve protection.
These devices “feel” that a violent
collision is in progress via a sensor and
pull back a few inches of webbing. In
this way the pretensioners ensure that
the belt is adhering perfectly to the
body before the belt begins to hold
back the wearer.
When the pretensioner has been
triggered the retractor will lock. The
seat belt cannot be drawn back up
even when guiding it manually.
After you have made the
adjustment, always make
sure that the loop is attached firm-
ly in one of the preset positions. To
do this, with the button released,
exert a further pressure to allow
the anchoring device to catch if re-
lease did not take place at one of
the preset positions.
WARNING
18GETTING TO KNOW YOUR VEHICLE
To adjust, press button A-fig. 16and
raise or lower the grip B-fig. 16. ADJUSTING THE FRONT
SEAT BELT HEIGHT
fig. 16
F0D 0051m
Only adjust seat belt
height when the vehicle is
stationary.
WARNING

19GETTING TO KNOW YOUR VEHICLE
IMPORTANTThe pretensioner
will give maximum protection when
the seat belt adheres snugly to the
wearer’s chest and hips.
A small amount of smoke may be
produced when the pretensioners are
fired. This smoke is harmless and does
not indicate the principle of a fire.
The pretensioner does not require
any maintenance or lubrication. Any
modification of its original state inval-
idates its efficiency. If, as the result of
exceptional natural occurrences
(floods, sea storms, etc.) the device is
soaked through with water and mud,
it must be replaced.Operations involving
banging, vibrations or
heating (exceeding 100°C
for a maximum of 6 hours) in the
area around the pretensioner
may trigger or damage the de-
vice. Vibrations from rough road
surfaces or accidental jolting
caused by mounting pavements,
etc. do not have any effect on the
pretensioner. If, however, you
need any assistance, go to a Fiat
Dealership.
fig. 17
F0D0264m
The pretensioner can only
be used once. After a colli-
sion that has triggered it, have it re-
placed at a Fiat Dealership. Pre-
tensioner validity is written on the
plate set on the front left door post
near the hinges (fig. 17). Have pre-
tensioners replaced at a Fiat Deal-
ership as this date approaches.
WARNING

20GETTING TO KNOW YOUR VEHICLE
fig. 18
F0D0003m
The webbing must not be
twisted. The upper section
must pass across the shoulder and
chest diagonally. The lower section
must fit closely across the passen-
ger’s hips and not the abdomen (fig.
18). Do not use clips, fasteners, etc.
to prevent the belt adhering to the
passenger’s body.
WARNING
Under no circumstances
should the components of
seat belts and pretensioners be
tampered with or removed. Any in-
terventions should be carried out by
qualified and authorised personnel.
Always contact a Fiat Dealership.
WARNINGGENERAL INSTRUCTIONS
FOR THE USE OF THE SEAT
BELTS
The driver is responsible for re-
specting and enforcing the local rules
and laws regarding the use of seat
belts.
Always fasten the seat belts before
starting.
For maximum safety, keep
the back of your seat up-
right, lean back into it and make
sure the seat belt fits closely across
your chest and hips. Always fasten
seat belts, in front and rear seats!
Travelling without seat belts in-
creases the risk of severe and fatal
injury in the event of a crash.
WARNING

21GETTING TO KNOW YOUR VEHICLE
Seat belts must also be worn by ex-
pectant mothers: the risk of injury in
the case of accident is much greater for
them and their unborn child too if they
do not have a seat belt on. Of course
they must position the lower part of
the belt very low down so that it pass-
es under the abdomen (fig. 20).
fig. 19
F0D0004m
fig. 20
F0D0005m
If the belt has been sub-
jected to heavy stress, for
example after an accident, it should
be changed completely together
with the anchors, anchor fastening
screws and the pretensioners. In
fact, even if the belt has no visible
defects, it could have lost its re-
silience.
WARNING
Never travel with a child
sitting on the passenger’s
lap with a single belt to protect
them both (fig. 19). Do not fasten
other objects to the body.
WARNING

23GETTING TO KNOW YOUR VEHICLE
Over 1.50 m in height, from the
point of view of restraint systems, chil-
dren are considered as adults and
wear the seat belts normally.
We recommend using Lineaccessori
Fiat child restraint systems for each
weight group. These systems were
specifically designed and tested for Fi-
at vehicles.
fig. 21
F0D0006m
With passenger’s air bag
active, never place child’s
seats with the cradle facing back-
wards since the air bag activation
could cause to the child serious in-
juries, even mortal, regardless of the
seriousness of the crash that trig-
gered it. You are advised to carry
children always with proper re-
straint systems on the rear seats, as
this is the most protected position
in the case of a crash.
WARNING
SERIOUS DANGER If it is
absolutely necessary to car-
ry a child on the front pas-
senger seat with the cradle
child’s seat facing back-
wards, the front passenger’s air bag
must be deactivated using the key
switch. In this case it is absolutely
necessary to check the warning
light
F(see paragraph “Passen-
ger’s front air bag”) to make sure
that deactivation has actually tak-
en place.
WARNING

24GETTING TO KNOW YOUR VEHICLE
GROUP 0 and 0+
Babies up to 13 kg must be carried
facing backwards on a cradle seat,
which, supporting the head, does not
induce stress on the neck in the event
of sharp deceleration.
The cradle is restrained by the vehi-
cle seat belts, as shown infig. 22and
in turn it must restrain the child with
its own belts.GROUP 1
Children from 9 to 18 kg are to be
seated facing forward in child seats
with front cushionfig. 23. The vehi-
cle seat belt secures both seat and
child.
fig. 22
F0D0007m
fig. 23
F0D0008m
The figure is only an exam-
ple. Attain to the instruc-
tions for fastening which must be
enclosed with the specific child re-
straint system you are using.
WARNING
The figure is only an exam-
ple. Attain to the instruc-
tions for fastening which must be
enclosed with the specific child re-
straint system you are using.
WARNING
Seats exist which are suit-
able for covering weight
groups 0 and 1 with a rear connec-
tion to the vehicle belts and their
own belts to restrain the child. Due
to their size, they can be dangerous
if installed incorrectly fastened to
the vehicle belts with a cushion.
Carefully follow the instructions for
installation provided with the seat.
WARNING