GETTING TO KNOW YOUR CAR
199
ENVIRONMENTAL
PROTECTION
The devices used to reduce petrol engine
emissions are:
– trivalent catalytic converter (catalytic si-
lencer);
– Lambda sensors;
– anti-evaporation system.
If one or more spark plugs are discon-
nected, do not run the engine, even for a
test.
The devices used to reduce diesel fuel en-
gine emissions are:
– oxidising catalyst;
– exhaust gas re-circulation system
(E. G. R.). Do not go near the fuel
filler with naked flames or
lit cigarettes: danger of
fire. Avoid going too near the fuel
filler with your face, to avoid in-
haling harmful vapours.
In the case of need, only
replace the fuel cap with
another genuine one, or the
efficiency of the fuel vapour re-
covery system could be adversely
affected.
Should it be not possible to open the fuel
flap electrically, use the special cable in the
boot (A-fig. 166) to open it manually.
Due to the high tempera-
tures reached during oper-
ation of the catalytic si-
lencer the vehicle should not be
parked over inflammable materials
(grass, dry leaves, pine needles,
etc.).
fig. 165
A0A0643b
fig. 166
A0A0652b
IMPORTANTThe sealing of the tank
may cause light pressurising. A little breath-
ing off, while slackening the cap is ab-
solutely normal.
After refuelling, turn the cap clockwise and
close the flap.
IMPORTANTFor your safety, before
starting the engine, also make sure that the
fuel nozzle is correctly inserted in the fuel
distributor.
●●
●
●
●
●●●
●●●●
●●
●●●●●●●●●
●●●
●●●●●●●●●
●●●●●●●●●
●●●●
VEHICLE MAINTENANCE
249
20 40 60 80 100 120 140 160 180Thousands of km
(*) Or every 3 years for harsh conditions (cold climates, city driving or prolonged lengths of time at idle speed, dusty roads or roads covered with sand and/or salt).
Or every 5 years, regardless of mileage.
Sight check for conditions of timing gear drive toothed belt
Change counter-rotating shaft drive belt
Change timing gear drive belt (*)
Change accessory poly-V drive belt
Change spark plugs
Check operation of engine control system (through diagnosis socket)
Check mechanical transmission oil level
Change engine oil and engine oil filter
Change brake fluid (or every 2 years)
Change fuel filter (JTD versions)
Change pollen filter (or every year)
Check emissions/smoke at the exhaust (JTD versions)
TECHNICAL SPECIFICATIONS
273
ENGINE
2.0 JTS
2.0 JTS
Selespeed
937A1000
Otto
4 in line
83 x 91
1970
11.5 : 1
121
165
6400
206
21
3250
NGK PFR6B
NGK BKR6EKPA
Unleaded
premium petrol
95 RON2.0 JTS (**)
932A2000
Otto
4 in line
83 x 91
1970
11.5 : 1
119
163
6400
201
22
3250
NGK PFR6B
NGK BKR6EKPA
Unleaded
premium petrol
95 RONJTD16V
937A5000
Diesel
4 in line
82 x 90.4
1910
17.5 : 1
110
150
4000
305
31
2000
Diesel for motor
vehicles
(Specification
EN 590) 3.2
V6
936A000
Otto
6 at V of 60°
93 x 78
3179
10 : 1
176.5
240
6200
300
30,6
4800
NGK PFR6B
Unleaded
premium petrol
95 RON
(*) There are two different spark plugs for each cylinder, one per type
(**) For versions/markets where applicable.1.8 T. SPARK
AR32205
Otto
4 in line
82.7
1747
11.5 : 1
103
140
6500
163
16.6
3900
NGK PFR6B+
NGK PMR7A
NGK BKR6EKPA+
NGK PMR7A
Unleaded
premium petrol
95 RONCode type
Cycle
Number and position of cylinders
Piston bore and stroke mm
Total displacement cm3
Compression ratio
Maximum horsepower (EEC):
kW
HP
at rpm
Maximum torque (EEC):
Nm
kgm
at rpm
Spark plugs (*)
Fuel
