2006 Alfa Romeo GT brake fluid

GETTING TO KNOW YOUR CAR
85
Warning
light on dialMessage
on display
WARNING LIGHTS
IMPORTANTThe number of warning lights present depends on the type of engine and equipment with which the car is fitted.
x
LOW BRAKE FLUID AND/OR HANDBRAKE ON
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds.
The warning light turns on when the level of the brake fluid in the reservoir falls below the min-
imum level, due to a possible leak in the circuit and when the handbrake is engaged.
If the
xwarning light turns on when travelling check that the hand-
brake is not engaged. If the warning light stays on with the handbrake
off (on some versions together with the message + symbol shown on
the reconfigurable multifunction display) stop the car immediately and contact
Alfa Romeo Authorised Services.
u
HIGH ENGINE COOLANT FLUID TEMPERATURE
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds.
The warning light turns on (on some versions together with the message + symbol shown on
the reconfigurable multifunction display) when the engine is overheated. If it turns on when trav-
elling, stop the car, leaving the engine on and slightly accelerated to further activate the circula-
tion of the coolant fluid.
If the warning doesn’t go off within 2 or 3 minutes, stop the car immediately and contact Alfa
Romeo Authorised Services.

GETTING TO KNOW YOUR CAR
151
Always take due care when braking on
bends, even with the help of the ABS.
The most important advice of all, howev-
er, is this:
When the ABS cuts in, and
you feel the pulsing on the
pedal, do not lighten the
pressure, but keep the pedal firm-
ly pressed with no fear; this way
you will stop in the least space
possible, compatibly with the con-
ditions of the road surface.
Following these instructions you will be
in the best braking condition under all cir-
cumstances.
IMPORTANTCars fitted with ABS may
only be fitted with the wheel rims, tyres and
brake linings of type and brand approved by
the Manufacturer.
The system is completed by the EBD (Elec-
tronic Brake Distributor) which distributes
the braking action through the control unit
and the ABS system sensors.The car is fitted with an
electronic braking distribu-
tor (EBD). If the
>andx
warning lights turn on simultane-
ously with the engine running, this
indicates an EBD system failure; in
this case with sharp braking the
rear wheels might lock too early,
with the possibility of skidding.
Driving extremely carefully, go to
the nearest Alfa Romeo Authorised
Service to have the system
checked.
The turning on of only the
>warning light with the
engine running normally in-
dicates a fault to the ABS system
only. In this case the braking sys-
tem is still efficient, though with-
out the aid of the anti-lock device.
Under these conditions perfor-
mance of the EBD system may be
reduced. In this case too, you are
advised to go immediately to the
nearest Alfa Romeo Authorised
Service to have the system checked
over, driving in such a way as to
avoid sharp braking.
If the low brake fluid lev-
el
xwarning light turns
on, stop the car immedi-
ately and contact the nearest Alfa
Romeo Authorised Service. Any
loss of fluid from the hydraulic sys-
tem will negatively affect the op-
eration of the braking system be it
of the conventional type or of the
type with ABS.
If the compact spare wheel
is used, operation of the
ABS system is cut off and
the
>warning light on the instru-
ment cluster turns on.
IMPORTANTIf the battery is run down
the
>andxwarning lights might turn
on when starting the engine and go off af-
ter starting. This should not be considered
as a fault but as a warning that during start-
ing the ABS is not active. The turning off
of the warning lights ensures normal system
operation.

IN AN EMERGENCY
219
The compressor shall not
be operated for more than
20 minutes. Risk of over-
heating!. Tyres repaired with the
quick tyre repair kit shall be used
temporarily only.
Replace the cylinder if
sealer has run out. Do not
throw away the cylinder
and the sealing fluid. Have the
sealing fluid and the cylinder dis-
posed of in compliance with na-
tional and local regulations.INFLATING PROCEDURE
Put on the protection
gloves provided together
with quick tyre repair kit.
Proceed as follows:
– set the wheel to be repaired with valve
A-fig. 13in the position shown in the fig-
ure, then pull up the handbrake, take
the quick tyre repair kit and put it on the
ground near the wheel to be repaired;– loosen tyre inflation valve cap, take out
the filler hose A-fig.1 4and screw the ring
nutB-fig. 15on the tyre valve;
fig. 13
A0A1097bfig. 14
A0A1098b
fig. 15
A0A1099b

IN AN EMERGENCY
221
– after driving for about 10 minutes stop
and check again the tyre pressure; pull up
the handbrake;
If pressure falls below
1.8 bar, stop the car since
the tyre is excessively
damaged and the quick tyre repair
kit Fix & Go automatic cannot
guarantee suitable sealing, contact
Alfa Romeo Authorized Services.
– if at least 1.8 bar pressure is read, re-
store proper pressure (with engine running
and handbrake on) and restart;
– drive with the utmost care to the near-
est Alfa Romeo Authorized Service.You shall absolutely com-
municate that the tyre has
been repaired with the
quick tyre repair kit. Hand the in-
struction brochure to the personnel
charged with treating the tyre re-
paired with the kit.CHECKING AND RESTORING
PRESSURE ONLY
The compressor can be also used just for
restoring pressure. Disconnect the quick con-
nectionA-fig. 18and connect it directly
to the tyre valve fig. 19; in this way the
cylinder is not connected to compressor and
the sealing fluid will not flow into the tyre.
fig. 18
A0A1101b
fig. 19
A0A1102b

VEHICLE MAINTENANCE
248
SCHEDULED MAINTENANCE PROGRAMME
20 40 60 80 100 120 140 160 180Thousands of km
Check tyre conditions/wear and adjust pressure if necessary
Check operation of lighting system (headlights, direction indicators, hazard warning
lights, boot, passenger compartment, glovebox lights, warning lights, etc..)
Check operation of windscreen washer system, adjust spray jets
Check position/wear of windscreen/rearscreen wiper blades
Check operation of front disk brake pad wear indicator
Check wear conditions of rear disk brake pads
Sight check the conditions of: body exterior, underbody protection, stiff pipes
and hoses (exhaust - fuel supply - brakes), rubber parts
(boots - sleeves - bushes etc..)
Check for bonnet and boot lock cleanness, lever cleanness and lubrication
Sight check for accessory drive belt conditions
Check handbrake lever stroke adjustment
Check antievaporation system (petrol versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (JTD versions)
Top up fluid levels (engine coolant, brakes, windscreen washer, battery, etc..)
Check and if necessary top up the Selespeed automatic transmission oil level
(2.0 JTS versions)
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●
●●●●●●●●●
●●●●●●●●●
●●
●●●●
●●
●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●

●●
●
●
●
●●●
●●●●
●●
●●●●●●●●●
●●●
●●●●●●●●●
●●●●●●●●●
●●●●
VEHICLE MAINTENANCE
249
20 40 60 80 100 120 140 160 180Thousands of km
(*) Or every 3 years for harsh conditions (cold climates, city driving or prolonged lengths of time at idle speed, dusty roads or roads covered with sand and/or salt).
Or every 5 years, regardless of mileage.
Sight check for conditions of timing gear drive toothed belt
Change counter-rotating shaft drive belt
Change timing gear drive belt (*)
Change accessory poly-V drive belt
Change spark plugs
Check operation of engine control system (through diagnosis socket)
Check mechanical transmission oil level
Change engine oil and engine oil filter
Change brake fluid (or every 2 years)
Change fuel filter (JTD versions)
Change pollen filter (or every year)
Check emissions/smoke at the exhaust (JTD versions)

VEHICLE MAINTENANCE
250
ADDITIONAL
OPERATIONS
Every 1000 kmor before long jour-
neys, check and if necessary top up:
– engine coolant fluid level
– brake/hydraulic clutch control fluid
level
– power steering fluid level
– windscreen and headlamp washer
fluid level
– tyre pressure and conditions.
Every 3000 kmcheck and if necessary
top up the engine oil level.
The use of FL Seleniaproducts is rec-
ommended which have been designed
and made expressly for Alfa Romeo cars
(see “Refuelling” in the “Technical
Specifications” chapter).
ANNUAL INSPECTION
PROGRAMME
For cars with an annual mileage
of below 20,000 km (for exam-
ple about 10,000 km) the follow-
ing yearly inspection programme
is advised:
– Check tyre conditions/wear and if
necessary adjust the pressure (including
spare wheel)
– Check operation of lighting system
(headlights, direction indicators, hazard
warning lights, boot, passenger compart-
ment, glovebox lights, warning lights,
etc.)
– Check operation of windscreen wiper
system, spray jet adjustment
– Check position/wear of windscreen
– Check front disk brake pad conditions
and wear– Sight check for conditions of: engine,
gearbox, transmission, pipes (exhaust -
fuel supply - brakes), rubber parts (boots
- sleeves - bushes etc..), brake and fuel
supply system hoses
– Check for bonnet and boot lock clean-
ness, lever cleanness and lubrication
– Check battery charge
– Sight check for conditions of various
drive belts
– Check and if necessary top up fluid
levels (engine coolant, brakes, wind-
screen washer, battery etc. )
– Change engine oil and engine oil filter
– Change pollen filter.

VEHICLE MAINTENANCE
253
1Engine oil - 2Battery - 3Brake fluid -4
Windscreen/rearscreen/headlamp
washer fluid - 5Engine coolant fluid -
6Power steering fluid - 7Selespeed
transmission oil (2.0 JTS Selespeed ver-
sions)
CHECKING LEVELS
Never smoke while
working in the engine
compartment; gas and
inflammable vapours may be pre-
sent, with the risk of fire.
When topping up take
care not to confuse the
various types of fluids:
they are incompatible with one
another and could seriously dam-
age the vehicle.fig. 1 - 1.8 T. SPARK version
A0A0736b
A0A0681b
fig. 1a - 2.0 JTS version