Page 65 of 307

GETTING TO KNOW YOUR CAR
63
If the display shows a failure message, see the details given in the
“Warning lights” chapter; if there are two or more failures, the display
shows them in cycle, one after the other. To eliminate the display of the
message and/or of the warning light repeated on the rev counter
by the reconfigurable multifunction display press button
Q.
INITIAL CHECK
Turning the ignition key to MAR, the reconfigurable multifunction display shows the message CHECK ACTIVE: the diagnostic phase of
all the electronic systems on the car has started; this lasts for about 4 seconds (for JTD versions only, the multifunction reconfigurable dis-
play is also able to show the engine oil level, see the “Engine oil level check” paragraph below). If no faults are detected, when the engine
has started, the display shows the OK message.
IMPORTANT If the reconfigurable multifunction display shows a failure message, see the details given in the “Warning lights” chapter.
Standard screen with
mechanical transmission Only JTD versionsStandard screen with
Selespeed transmission
The Programmed Maintenance
Schedule includes vehicle
maintenance every 20,000
km; this is shown automatical-
ly with the ignition key at
MAR, starting from 2,000
km (or miles) from this dead-
line and it is shown again
every 200 km.
If no failures
are presentIs the
engine
started?YES
NO
Page 66 of 307

GETTING TO KNOW YOUR CAR
64
Engine oil level check
(JTD
16Vversions)
Turning the ignition key to MARthe
reconfigurable multifunction display shows
the engine oil level for 10 seconds. During
this phase, to clear the display and move
to the next screen, press
Q.
IMPORTANTTo make sure that the
engine oil level displayed is correct, carry
out the check with the vehicle on the level
ground.
(Fig. 84) refers to the correct engine
oil level display. As the oil level gradually
falls, the full bars go off leaving room for
the empty ones.
fig. 84
A0A9101g
fig. 85
A0A9102g
fig. 86
A0A9103g
(Fig. 85) refers to the display with an
oil level below the foreseen minimum. In
this condition the bars are all empty.
IMPORTANTIn this case the correct
engine oil level should be restored as soon
as possible, see “Checking levels” in the
“Vehicle Maintenance” chapter. (Fig. 86) refers to the display with an
oil level above the foreseen maximum. In
this condition the bars are all full.
IMPORTANTIn this case, contact Alfa
Romeo Authorised Services who will
restore the correct engine oil level.
Page 80 of 307
GETTING TO KNOW YOUR CAR
78
SERVICE
With the SERVICE function it is possible
to receive information connected with cor-
rect vehicle maintenance. To consult this
function, proceed as follows:
Menu screen
Return to menu screen
Return to
standard screen
IMPORTANT
The Programmed Mainte-
nance Schedule includes ve-
hicle maintenance every
20,000 km; this is shown
automatically, with the ignition key at MAR, start-
ing from 2,000 km (or miles) from this deadline and
it is shown again every 200 km.
This display can only be reset by Alfa Romeo Authorised
Services.
Q
QR
â
ã
â
ã
â
ã
â
ãâ
ã
â
ã
â
ã
See INITIAL CHECK and ACCESS
TO THE MENU SCREEN
Petrol versions
(
•) (
•)
1.9 JTD
16Vversions
Page 82 of 307

GETTING TO KNOW YOUR CAR
80
GENERAL TRIP - TRIP B
The TRIP COMPUTER function gives information relating to the operating status of the vehicle on the reconfigurable multifunction display.
This function comprises the GENERAL TRIP concerning the complete mission of the car and TRIP B concerning the partial car mission. This
function (as shown in the graph below) is contained within the complete mission. Both functions are resettable.
The GENERAL TRIP displays the figures relating to
ACTUAL CONSUMPTION,AVERAGE CONSUMPTION,RANGE,AVERAGE VELOCITY,TRAVEL TIME(driving time),
TRAVEL DISTANCE.
TRIP B, displays information concerning
AVERAGE CONSUMPTION B,AVERAGE VELOCITY B,TRAVEL TIME B(driving time), TRAVEL DISTANCE B.
Start of journey procedure (reset)
To start a new journey monitored by the GENERAL TRIP, with the ignition key at MAR, press the button with
U(see “Control buttons”).
The reset operation (pressing the
Ubutton) in the presence of the screen concerning the GENERAL TRIP also makes it possible to reset
TRIP B. The reset operation (pressing the
Ubutton) in the presence of only the screens concerning TRIP B makes it possible to reset only the
information associated with this function.
IMPORTANT The range and actual consumption information cannot be reset.
End of partial mission
Start of new partial mission
Reset TRIP B
˙Reset TRIP B
End of partial mission
Start of new partial mission˙
˙Reset TRIP B
˙˙
˙
TRIP B
TRIP B
TRIP B
End of partial mission
Start of new partial missionEnd of partial mission
Start of new partial mission
Reset TRIP B
GENERAL TRIP
End of complete mission
Start of new mission
Reset GENERAL TRIP
˙
End of complete mission
Start of new mission
Reset GENERAL TRIP
˙
Page 86 of 307
GETTING TO KNOW YOUR CAR
84
DISPLAYS IN CONCURRENCE WITH THE EVENT
Standard screen:
when the radio is
turned on in the
RADIO DISPLAY ON
condition
Standard screen:
when a phone call is
received in the TELEPHONE
DISPLAY ON conditionDisplay with the ignition key removed open-
ing or closing a door.
The reconfigurable multifunction display
together with the mileage recorder display
(total and trip) is timed, after 10 seconds it
goes off automatically.
In the event of a failure
see the “Warning lights”
chapterStandard screen:
during assisted
navigation in the
NAVIGATION DISPLAY
ON condition
The displays illustrated
are purely indicative.
fig. 87
A0A0676b
Page 87 of 307

GETTING TO KNOW YOUR CAR
85
Warning
light on dialMessage
on display
WARNING LIGHTS
IMPORTANTThe number of warning lights present depends on the type of engine and equipment with which the car is fitted.
x
LOW BRAKE FLUID AND/OR HANDBRAKE ON
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds.
The warning light turns on when the level of the brake fluid in the reservoir falls below the min-
imum level, due to a possible leak in the circuit and when the handbrake is engaged.
If the
xwarning light turns on when travelling check that the hand-
brake is not engaged. If the warning light stays on with the handbrake
off (on some versions together with the message + symbol shown on
the reconfigurable multifunction display) stop the car immediately and contact
Alfa Romeo Authorised Services.
u
HIGH ENGINE COOLANT FLUID TEMPERATURE
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds.
The warning light turns on (on some versions together with the message + symbol shown on
the reconfigurable multifunction display) when the engine is overheated. If it turns on when trav-
elling, stop the car, leaving the engine on and slightly accelerated to further activate the circula-
tion of the coolant fluid.
If the warning doesn’t go off within 2 or 3 minutes, stop the car immediately and contact Alfa
Romeo Authorised Services.
Page 88 of 307

GETTING TO KNOW YOUR CAR
86
Warning
light on dialMessage
on display
¬
AIR BAG FAILURE
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds. The warning light stays on glowing steadily if there is an operating failure in
the Air bag system.
If the
¬warning light does not turn on when turning the ignition key
to MAR or if it stays on when travelling, this could indicate a failure in
safety retaining systems; under this condition air bags or pretension-
ers could not trigger in the event of collision or, in a restricted number of cas-
es, they could trigger accidentally. Stop the car and contact Alfa Romeo Autho-
rised Services.
The failure of the ¬warning light (warning light off) is also indicat-
ed by the flashing for more than the normal 4 seconds of the passen-
ger’s front air bag deactivated warning light.
v
LOW ENGINE OIL PRESSURE
Turning the key to MARthe warning light on the dial turns on, but it should go out as soon as
the engine is started.
If the
vwarning light turns on when the car is travelling (on
some versions there is also the message + symbol on the reconfig-
urable multifunction display), stop the engine immediately and contact
Alfa Romeo Authorised Services.
Page 89 of 307
GETTING TO KNOW YOUR CAR
87
Warning
light on dialMessage
on display
w
LOW BATTERY CHARGE
Turning the key to MARthe warning light on the dial turns on, but it should go out as soon as
the engine is started.
If with the engine running the message + symbol are shown on the reconfigurable multifunction
display, contact Alfa Romeo Authorised Services.
<
SEAT BELTS NOT FASTENED
The warning light on the dial turns on glowing steadily when, with the ignition key turned to
MAR, the driver’s belt is not correctly fastened.