2006 Alfa Romeo GT fuel pressure

Never leave children
unattended in the vehicle.
Always remove the igni-
tion key when leaving the vehicle
and take it with you.To avoid useless con-
sumption of power and
possible draining of the
battery, never leave the ignition
key in the MAR position when
the engine is not running.
CORRECT USE OF THE CAR
203
PARKING
When the vehicle is parked, proceed as
follows:
– Switch off the engine.
– Engage the handbrake.
– Engage first gear if the vehicle is faced
uphill or reverse if the vehicle is facing
downhill.
– Turn the front wheels so that the vehi-
cle will immediately come to a halt if the
handbrake slips.
REDUCING RUNNING
COSTS AND
ENVIRONMENT
POLLUTION
By following a few simple guidelines, it
is possible to save vehicle running costs
and reduce harmful emissions.
GENERAL CONSIDERATIONS
Vehicle maintenance
To take care of the car maintenance
have the checks and adjustments carried
out in accordance with the “Scheduled
Maintenance Programme”.
Tyres
Check the pressure of the tyres routinely
at an interval of no more than 4 weeks: if
the pressure is too low consumption levels
increase as resistance to rolling is higher.
Useless loads
Never travel with an overload in the
boot. The weight of the vehicle (especial-
ly in urban traffic), and its geometry heav-
ily affect consumption levels and stability.Electric services
Use electric devices only for the amount
of time needed. Rearscreen heating, addi-
tional headlights, windscreen wipers and
heater fan need a considerable amount of
energy, therefore increasing the require-
ment of current increases fuel consump-
tion (up to +25% in the urban cycle).
Climate control system
The climate control system is a further
load bearing heavily on the engine induc-
ing higher consumption levels(up to
+20% on average). Outside temperature
permitting, preferably use the air vents.
Aerodynamic items
The use of non-certified aerodynamic
items may adversely affect air drag and
consumption levels.

VEHICLE MAINTENANCE
248
SCHEDULED MAINTENANCE PROGRAMME
20 40 60 80 100 120 140 160 180Thousands of km
Check tyre conditions/wear and adjust pressure if necessary
Check operation of lighting system (headlights, direction indicators, hazard warning
lights, boot, passenger compartment, glovebox lights, warning lights, etc..)
Check operation of windscreen washer system, adjust spray jets
Check position/wear of windscreen/rearscreen wiper blades
Check operation of front disk brake pad wear indicator
Check wear conditions of rear disk brake pads
Sight check the conditions of: body exterior, underbody protection, stiff pipes
and hoses (exhaust - fuel supply - brakes), rubber parts
(boots - sleeves - bushes etc..)
Check for bonnet and boot lock cleanness, lever cleanness and lubrication
Sight check for accessory drive belt conditions
Check handbrake lever stroke adjustment
Check antievaporation system (petrol versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (JTD versions)
Top up fluid levels (engine coolant, brakes, windscreen washer, battery, etc..)
Check and if necessary top up the Selespeed automatic transmission oil level
(2.0 JTS versions)
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●
●●●●●●●●●
●●●●●●●●●
●●
●●●●
●●
●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●

VEHICLE MAINTENANCE
250
ADDITIONAL
OPERATIONS
Every 1000 kmor before long jour-
neys, check and if necessary top up:
– engine coolant fluid level
– brake/hydraulic clutch control fluid
level
– power steering fluid level
– windscreen and headlamp washer
fluid level
– tyre pressure and conditions.
Every 3000 kmcheck and if necessary
top up the engine oil level.
The use of FL Seleniaproducts is rec-
ommended which have been designed
and made expressly for Alfa Romeo cars
(see “Refuelling” in the “Technical
Specifications” chapter).
ANNUAL INSPECTION
PROGRAMME
For cars with an annual mileage
of below 20,000 km (for exam-
ple about 10,000 km) the follow-
ing yearly inspection programme
is advised:
– Check tyre conditions/wear and if
necessary adjust the pressure (including
spare wheel)
– Check operation of lighting system
(headlights, direction indicators, hazard
warning lights, boot, passenger compart-
ment, glovebox lights, warning lights,
etc.)
– Check operation of windscreen wiper
system, spray jet adjustment
– Check position/wear of windscreen
– Check front disk brake pad conditions
and wear– Sight check for conditions of: engine,
gearbox, transmission, pipes (exhaust -
fuel supply - brakes), rubber parts (boots
- sleeves - bushes etc..), brake and fuel
supply system hoses
– Check for bonnet and boot lock clean-
ness, lever cleanness and lubrication
– Check battery charge
– Sight check for conditions of various
drive belts
– Check and if necessary top up fluid
levels (engine coolant, brakes, wind-
screen washer, battery etc. )
– Change engine oil and engine oil filter
– Change pollen filter.

VEHICLE MAINTENANCE
265
Alloy rim painting
involving temperatures
exceeding 150 °C should
be avoided since wheel mechani-
cal characteristics could be
impaired.Do not cross switch the
tyres, moving them from
the right of the car to the
left and vice versa.Excessive low pressure
causes overheating of the
tyre with the possibility
of serious damage to it.Remember that vehicle
road holding also depends
on correct tyre inflation
pressure.
RUBBER HOSES
As far as the brake system and fuel sup-
ply rubber hoses are concerned, carefully
follow the Scheduled Maintenance
Programme. Indeed, ozone, high temper-
atures and the prolonged lack of fluid in
the system may cause hardening and
cracking of the hoses, with possible leaks.
Careful control is therefore necessary. IMPORTANTS
– Where possible, avoid sudden brak-
ing, tyre squealing starts, violent bumps
against kerbs, potholes or obstacles of var-
ious kinds. Prolonged driving on rough
roads may damage the tyres;
– Routinely check the tyres for cuts on
the sides, swellings or uneven tread wear.
If necessary contact Alfa Romeo
Authorised Services;
– Avoid overloading the vehicle when
travelling: this may cause serious damage
to the wheels and tyres;
– If a tyre is punctured, stop immedi-
ately and change it to avoid damage to
the tyre itself, the rim, suspensions and
steering system;
– Tyres age even if they are not used
much. Cracks in the tread rubber are a
sign of aging. In any case, if the tyres
have been on the vehicle for over 6 years,
they should be checked by specialised per-
sonnel, to see if they can still be used.
Also remember to check the compact
spare wheel;
– In case of replacement, always fit new
tyres, avoiding those of dubious origin;

TYRE INFLATION PRESSURES COLD
ENGINE OIL REPLEACEMENT
Oil sump and filter (1.8 T. SPARK - 2.0 JTS) ...................... litres 4.4
Oil sump and filter (3.2
V6) ............................................. litres 5.9
Oil sump and filter (JTD
16V)............................................ litres 4.5
Do not discard used oil in the environment.
REFUELLING
Fuel tank capacity .......................................................... litres 63
Reserve ......................................................................... litres 7
For cars with petrol engine, only use unleaded petrol with over 95 R.O.N.
For cars with diesel engine only use Diesel fuel for motor vehicles (Speci-
fication EN590)
QUALITYASSISTENZA TECNICA - INGEGNERIA ASSISTENZIALE
Largo Senatore G. Agnelli. 5 -10040 Volvera - Torino (Italia)
Fiat Auto S.p.A.
Publication no. 60431484 - 2
ndEdition - 09/2005All rights reserved. Reproduction, even in part is prohibited without written permission
from Fiat Auto S.p.A.
SERVICE
With the tyre hot the inflating pressure should be +0,3 bar compared with the specified rating
With winter tyres the inflation pressure should be +0,2 bar compared with the specified rating
Tyres
195/60 R15bar
205/60 R15bar
205/55 R16bar
205/55 ZR16bar
215/45 R17bar
225/45 ZR17bar
225/40 ZR18bar
Compact spare wheel
125/80 R15barreduced load
front rear
2.2 2.2
2.3 2.3
2.3 2.3
2.3 2.3
2.4 2.3
2.5 2.4
2.5 2.4
4.2full loadfront rear
2.5 2.5
2.6 2.6
2.6 2.6
2.6 2.6
2.7 2.6
2.8 2.7
2.8 2.7
4.2