Î
Î
(#' )
Removal Installation
24-211
Driver’s Seat Position Sensor Replacement
A
B C
C
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
B
NOTE: Removal of the driver’s seat position sensor must be done according Precautions and Procedures
(see page 24-13).
Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver’s
seat position sensor.
1. Do the battery terminal disconnection procedure (see page 22-68), then wait at least 3 minutes
before starting work.
2. Remove the driver’s seat assembly (see page 20-118).
3. Disconnect the seat position sensor harness 2P connector (A) from the driver’s seat position sensor
(B).
4. Using a TORX T30 bit, remove the TORX bolt (C), then remove the driver’s seat position sensor. NOTE:
Be sure to install the harness so it does not pinched or interfere with other parts.
Do not turn the ignition switch to ON (II), and do not connect the battery cable while insta lling the driver’s
seat position sensor.
After installing the driver’s seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the driver’s seat position sensor with a new TORX bolt (A), then connect the seat position
sensor harness 2P connector (B) to the driver’s seat
position sensor (C).
2. Install the driver’s seat assembly (see page 20-118).
3. Do the battery terminal reconnection procedure (see page 22-68).
4. Clear any DTCs (see page 24-23).
5. Check the operation of the driver’s seat position sensor with the HDS (see page 24-29).
Replace.
08/08/21 14:02:11 61SNR030_240_0211
ProCarManuals.com
DYNOMITE -2009-
