2006 ACURA CSX diagram

Î
(#'
)
8-6Engine Lubrication
Low Oil Pressure Indicator Circuit Diagram
D2
Q9
H1
191
17
36
B7
CANL
CANH DRIVERBRN
12 V
5V GAUGE CONTROL MODULE (TACH)
IGNITION SWITCH
BATIG1
ECM/PCM
OPSW
A37
A36 RED
WHT CPU
No. 2 (50 A)
No. 10
(7.5 A)
BATTERY
UNDER-HOOD FUSE/RELAY BOX
No. 1 (100 A)
YEL/REDUNDER-DASH
FUSE/RELAY BOX
LOW OIL
PRESSURE
INDICATOR
OIL PRESSURE SWITCH
(Closed: Lost pressure)
IG1 HOT in ON (II)
and START (III)
1
WHT BLU
CANH
CANL
08/08/21 14:36:41 61SNR030_080_0006
ProCarManuals.com
DYNOMITE -2009-

(#'

/)
Engine Cooling
Cooling System
Fan Controls
........................................
........................................................
................................................................ ....................................................................................................................... ........................................................................................
.............................................................. ................................................................................................................................... ....................
.....................
..................................
........................................
........................................................
................................................................ ....................................................................................................................... ........................................................................................
.............................................................. ................................................................................................................................... ....................
.....................
..................................
Component Location Index
. 10-2
Radiator Cap Test . 10-4
Radiator Test . 10-4
Fan Motor Test . 10-5
Thermostat Test . 10-5
Water Pump Inspection . 10-6
Water Pump Replacement . 10-6
Coolant Check . 10-7
Coolant Replacement . 10-8
Thermostat Replacement . 10-10
Water Passage Replacement . 10-11
EGR Passage Removal and Installation . 10-13
Water Outlet Removal and Installation . 10-16
Radiator and Fan Replacement . 10-19
........................................ ..............................
............................................................ ..
........................................
..............................
............................................................ ..
Component Location Index
. 10-23
Symptom Troubleshooting Index . 10-24
Circuit Diagram . 10-25
Radiator Fan High Speed Circuit Troubleshooting . 10-26
08/08/21 14:39:50 61SNR030_100_0001
ProCarManuals.com
DYNOMITE -2009-

Î
(#'

)
10-25
Circuit Diagram
ECT2
SG6
SG2
ECT1 FANH
FANL
SUBRLY IG2HOTinON(II)
PNK
5V No. 15 (7.5 A)
A21
PUR
ECM/PCM
2G301
BLK
2
1
No. 11 (15 A)
(10 A) No. 36
B23
RED/WHT GRN/BLK B33
BLU GRY
BRN
A33
BLK GRN A9 IGNITION SWITCH
IG2
BAT
RED
3
2 5
4 1
A4
A5 13
4
2
1 2 23 4
1 No. 2 (50 A)
BLK
UNDER-HOOD FUSE/RELAY BOX
BATTERY
G301No. 1 (100 A)
No. 6 (20 A)
A/C
CONDENSER
FAN RELAY
ENGINE COOLANT
TEMPERATURE
(ECT) SENSOR 1
A/C
CONDENSER
FAN MOTOR
FAN
CONTROL
RELAY
RADIATOR
FAN
MOTOR
ENGINE COOLANT
TEMPERATURE
(ECT) SENSOR 2 RADIATOR
FAN
RELAY
PGM-FI
SUB RELAY
H1
3 4
ORN
G12
D1
F16
F7
F2
F12
F14
F1
F11 No. 7 (20 A)
21
1 UNDER-DASH
FUSE/RELAY
BOX
BRN
WHT
43
12 C3
08/08/21 14:40:32 61SNR030_100_0025
ProCarManuals.com
DYNOMITE -2009-



M/T
Secondary Heated Oxygen Sensor (Secondary HO2S)
Accelerator Pedal Position (APP) Sensor
Electronic Throttle Control System
11-35
TERMINAL
MAGNET O-RING O-RING
ZIRCONIA
ELEMENT SENSOR
TERMINALS
HEATER
TERMINALS
HEATER
APP SENSOR A/B
ACCELERATOR
PEDAL MODULE
The secondary HO2S detects the oxygen content in the
exhaust gas downstream of the three way catalytic
converter (TWC), and sends signals to the ECM/PCM
which varies the duration of fuel injection accordingly.
To stabilize its output, the sensor has an internal heater.
The ECM/PCM compares the HO2S output with the A/F
sensor output to determine catalyst efficiency. The
secondary HO2S is on the TWC. The throttle is electronically controlled by the electronic
throttle control system. Refer to the system diagram to
see a functional layout of the system.
Idle control: When the engine is idling, the ECM/PCM
controls the throttle actuator to maintain the proper idle
speed according to engine loads.
Acceleration control: When the accelerator pedal is
pressed, the ECM/PCM opens the throttle valve,
depending on the accelerator pedal position (APP)
sensor signal.
Cruise control: The ECM/PCM controls the throttle
actuator to maintain the set speed when the cruise
control is operating. The throttle actuator takes the
place of the cruise control actuator.
As the accelerator pedal position changes, the sensor
varies the signal voltage to the ECM/PCM.
(cont’d)
08/08/21 14:13:39 61SNR030_110_0035
ProCarManuals.com
DYNOMITE -2009-




VTEC/VTC
System Diagram
Camshaft Position (CMP) Sensor A
11-39
VTC
RETARD
CHAMBERFrom No. 3
ALTERNATOR
(10 A) FUSE
VARIOUS
SENSORS
ECM/PCM
CMP SENSOR A
INTAKE
CAMSHAFT
VTC
ADVANCE
CHAMBER ADVANCE
RETARD
VANE
VTC ACTUATOR VANE
HOUSING
From
OIL PUMP
VTC OIL CONTROL
SOLENOID VALVE
SPOOL
VALVE
ROCKER ARM
OIL CONTROL
SOLENOID ROCKER
ARM OIL
PRESSURE
SWITCH BLK
BLK GRN/YEL
BLU/BLK BLK/YEL
BLU/WHT BLU/WHT YEL
BRN/YEL
BLK
BRN/YEL
VTC STRAINERO-RING
MAGNET
TERMINAL
DRAIN
DRAIN
CMP sensor A detects camshaft angle position for the VTC system.
(cont’d)
08/08/21 14:13:41 61SNR030_110_0039
ProCarManuals.com
DYNOMITE -2009-



Exhaust Gas Recirculation (EGR) System
(K20Z2 engine)
Evaporative Emission (EVAP) Control
System
EGR Valve
EVAP Canister
EVAP Canister Purge Valve
Fuel Tank Pressure (FTP) Sensor
EVAP Canister Vent Shut Valve
11-41
TERMINAL
COIL
OUT
IN O-RING
TERMINAL
SENSOR UNIT
O-RING VALVE O-RING TERMINAL
Refer to the system diagram to see a functional layout
of the system.
The EGR valve lowers peak combustion temperatures
and reduces oxides of nitrogen emissions (NOx) by
recirculating exhaust gas through the intake manifold
and into the combustion chambers.
Refer to the system diagram to see a functional layout
of the system.
The EVAP canister temporarily stores fuel vapor from
the fuel tank until it can be purged back into the engine
and burned.
When the engine coolant temperature is below 60 °C
(140 °F), the ECM/PCM turns off the EVAP canister
purge valve which cuts vacuum to the EVAP canister. The FTP sensor converts fuel tank absolute pressure
into an electrical input to the ECM/PCM.
The EVAP canister vent shut valve is on the EVAP
canister.
The EVAP canister vent shut valve controls the venting
of the EVAP canister.
(cont’d)
08/08/21 14:13:42 61SNR030_110_0041
ProCarManuals.com
DYNOMITE -2009-



Electronic Throttle Control System Diagram
11-43
TP SENSOR A
TP SENSOR B THROTTLE
ACTUATOR
THROTTLE
BODY
From
ETCS CONTROL
RELAY
VARIOUS
SENSORS
ECM/
PCM
APP
SENSOR A
APP
SENSOR B BRN
YEL
BLU
PUR
LT BLU GRY
BLK YEL
GRN
RED/BLU BLUBLU/RED
GRN/YEL
RED/BLK
The electronic throttle control system consists of the throttle actuator, throttle position (TP) sensor A/B, accelerator
pedal position (APP) sensor A/B, the electronic throttle control system (ETCS) control relay, and the ECM/PCM.
(cont’d)
* : This illustration shows K20Z2 engine
08/08/21 14:13:43 61SNR030_110_0043
ProCarManuals.com
DYNOMITE -2009-

Î

Exhaust Gas Recirculation (EGR) System Diagram (K20Z2 engine)
11-44Fuel and Emissions Systems
System Description (cont’d)
INTAKE MANIFOLD
EGR VALVE
EGR VALVE
POSITION SENSOR
YEL/BLU
GRN/BLK
WHT/BLK
BLU/RED
BLK/RED
(BLK)
BLK
ECM/PCM
VARIOUS
SENSORS
* : ’07-09 models
*
The EGR system reduces oxides of nitrogen (NOx) emissions by recirculating exhaust gas through the EGR valve and
the intake manifold into the combustion chambers. The ECM/PCM memory includes the ideal EGR valve position for
varying operating conditions.
The EGR valve position sensor detects the amount of EGR valve lift and sends it to the ECM/PCM. The ECM/PCM then
compares it with the ideal lift in its memory (based on signals sent from other sensors). If there is any difference
between the two, the ECM/PCM cuts current to the EGR valve.
08/08/21 14:13:43 61SNR030_110_0044
ProCarManuals.com
DYNOMITE -2009-