2006 ACURA CSX Air cleaner

Î
Fluorescent Dye Usage Tips
Refrigerant Capacity:
400 to 450 g
0.40 to 0.45 kg
0.9 to 1.0 lbs
14.1 to 15.9 oz
21-94Climate Control
Refrigerant Leak Check (cont’d)
A
C B
 Use only Tracer-Stick single dose fluorescent dyecapsules from Tracerline
. Other dyes contain
solvents that may contaminate the refrigerant oil,
leading to component failure.
 Adding excessive amounts of dye can damage the compressor.
 PAG oil is water soluble, so condensation on the evaporator core or the refrigerant lines may wash the
PAG oil and fluorescent dye away from the actual
leak. Condensation may also carry dye through the
evaporator module drain.
 After checking and repairing leaks, thoroughly clean any residual dye from the areas where leaks were
found. Use GLO-AWAY dye cleaner, from Tracerline
,
and hot water to remove the dye (follow the
instructions on the bottle). Residual dye stains can
cause misdiagnosis of any future A/C system leaks.
 If any refrigerant dye contacts an exterior paint surface, remove it by doing this:
– Carefully wash the affected surfaces to remove any dirt, and to prevent paint scratching.
– Mix water and isopropyl alcohol in a 50/50 mixture.
– Soak a soft 100 percent cotton towel with the water/ alcohol mixture, and place the cloth on the affected
areas to remove the dye.
– After removing the dye with the water/alcohol- soaked cloth, carefully wash the affected areas, and
check that there is no remaining dye. 1. Connect an R-134a refrigerant recovery/recycling/
charging station (A) to the high-pressure service
port (B) and the low-pressure service port (C), as
shown, following the equipment manufacturer’s
instructions.
2. Recover refrigerant from the A/C system (see page 21-90), and evacuate the system (see page 21-91). If
the system achieves a vacuum of approximately
93.3 kPa (700 mmHg, 27.6 in.Hg) in 15 minutes, and
holds the vacuum for 15 minutes, then the system
does not have a leak at this time. If the system
cannot achieve or hold a vacuum, continue the
refrigerant leak check.
3. Open the high pressure valve to charge the system to the specified capacity.
Select the appropriate units of measure for your
refrigerant charging station.
08/08/21 14:44:54 61SNR030_210_0095
ProCarManuals.com
DYNOMITE -2009-

µ
Audio Glossary
Item Definition
23-8Audio System
System Description (cont’d)
NOTE: All items may not apply to this vehicle. See the owner’s manual for more information.
Active noise cancellation The active noise cancellation system cancels some of the vehicle noise. This occurs in the 1,500 2,400 rpm range. Microphones detect the low frequency
sound, and the system outputs a canceling sound from the audio speaker.
AM (Amplitude Modulation)
Amplifier A device that increases the level of a signal by increasing the current or voltage.
Antenna A device used to send or receive electromagnetic waves thr ough the air.
ATA (PC Card) A type of card that has been tested for use in playing WMA, and MP3 music files in the PC Card slot. Sizes of up to 1 GB have been tested.
Audio remote switch The switches on the steering wheel that control the audio system.
Auxiliary jack Allows the customer to use a portable audio device to i nput audio recordings.
Balance A control that changes the relative volume of the left and right channels.
Band A range of frequencies between two definite limits. Bands are assigned by the Federal Communications Commission for specific uses.
Bass An adjustment for the low frequency sounds of around 160 Hz and below.
Byte A unit of storage for computer files and memory. A CD holds approximately 700 million bytes.
Cassette Audio or video magnetic tape container having two reels. Customers can insert it for play back
Compactflash Astandardforsmall-size(3x4cm),memorycardsusedinmobilecomputers, PDAs, digital cameras. Compact flash memory cards are available in size of
32 MB up to 4 GB or more and can be played in the audio PC slot. Sizes above
1 GB have not been tested.
CD (Compact Disc) A 4.5-inch plastic disc containing digital audio recording that is played optically on a laser equipped player. Never use discs with a paper label. In a hot vehicle,
labels can curl up and jam the unit.
CD (audio disc) changer CD player that can store and play more than one CD. Two types are available. Some units accept CDs fed into the changer one at a time, and others accept a
magazine (with CDs stacked in a container).
CD player A com ponent designed to play compact disc recordings using a laser optical
pickup. The signal from a CD player usually requires amplification.
Decibels (db)
Distortion Inexact repr oduction of an audio signal caused by playing music at levels the
audio system cannot handle.
Dolby (noise reduction) A processing system developed by Dolby Laboratories that reduces the background noise on recording media. The result is a cleaner playback from the
audio system.
DUET A serial data communication line used for sub display.
DVD (Digital Versatile Disc) A 4.5-inch CD-like format used for storing movies with digital audio and video features. The DVD-A format is a DVD format designed for DVD audio systems.
Some vehicles can play DVD and DVD-A formats.
Equalizer A device that changes the relative volume of individual frequency bands to suit personal tastes of the listener.
Fader The control that adjusts the relative volume levels of front and rear speakers in a four-speaker system.
Format To prepare a PC Card to receive files this function is done on a PC. Always choose either FAT or FAT32, as the NTFS format is not accepted by the system.
Pick the default sectors for the format method selected.
FM (Frequency Modulation) The form of modulation used for radio and television sound transmission in most of the world. Less prone to interference than AM. The FM broadcast band
in North America covers roughly 87.7 to 107.9 MHz.
The type of transmission used in the standard radio broadcast band from 530 to 1710 kHz.
A method of measuring sound or radio signal strength received by the audio unit antenna.
08/08/21 14:03:45 61SNR030_230_0011
ProCarManuals.com
DYNOMITE -2009-

µ
Audio Glossary
Item Definition
23-167
NOTE: All items may not apply to this vehicle. See the owner’s manual for more information.
Active noise cancellation The active noise cancellation system cancels some of the vehicle noise. This occurs in the 1,500 2,400 rpm range. Microphones detect the low frequency
sound, and the system outputs a canceling sound from the audio speaker.
AM (Amplitude Modulation)
Amplifier A device that increases the level of a signal by increasing the current or voltage.
Antenna A device used to send or receive electromagnetic waves thr ough the air.
ATA (PC Card) A type of card that has been tested for use in playing WMA, and MP3 music files in the PC Card slot. Sizes of up to 1 GB have been tested.
Audio remote switch The switches on the steering wheel that control the audio system.
Auxiliary jack Allows the customer to use a portable audio device to i nput audio recordings.
Balance A control that changes the relative volume of the left and right channels.
Band A range of frequencies between two definite limits. Bands are assigned by the Federal Communications Commission for specific uses.
Bass An adjustment for the low frequency sounds of around 160 Hz and below.
Byte A unit of storage for computer files and memory. A CD holds approximately 700 million bytes.
Cassette Audio or video magnetic tape container having two reels. Customers can insert it for play back
Compactflash Astandardforsmall-size(3x4cm),memorycardsusedinmobilecomputers, PDAs, digital cameras. Compact flash memory cards are available in size of
32 MB up to 4 GB or more and can be played in the audio PC slot. Sizes above
1 GB have not been tested.
CD (Compact Disc) A 4.5-inch plastic disc containing digital audio recording that is played optically on a laser equipped player. Never use discs with a paper label. In a hot vehicle,
labels can curl up and jam the unit.
CD (audio disc) changer CD player that can store and play more than one CD. Two types are available. Some units accept CDs fed into the changer one at a time, and others accept a
magazine (with CDs stacked in a container).
CD player A com ponent designed to play compact disc recordings using a laser optical
pickup. The signal from a CD player usually requires amplification.
Decibels (db)
Distortion Inexact repr oduction of an audio signal caused by playing music at levels the
audio system cannot handle.
Dolby (noise reduction) A processing system developed by Dolby Laboratories that reduces the background noise on recording media. The result is a cleaner playback from the
audio system.
DUET A serial data communication line used for sub display.
DVD (Digital Versatile Disc) A 4.5-inch CD-like format used for storing movies with digital audio and video features. The DVD-A format is a DVD format designed for DVD audio systems.
Some vehicles can play DVD and DVD-A formats.
Equalizer A device that changes the relative volume of individual frequency bands to suit personal tastes of the listener.
Fader The control that adjusts the relative volume levels of front and rear speakers in a four-speaker system.
Format To prepare a PC Card to receive files this function is done on a PC. Always choose either FAT or FAT32, as the NTFS format is not accepted by the system.
Pick the default sectors for the format method selected.
FM (Frequency Modulation) The form of modulation used for radio and television sound transmission in most of the world. Less prone to interference than AM. The FM broadcast band
in North America covers roughly 87.7 to 107.9 MHz.
(cont’d)
The type of transmission used in the standard radio broadcast band from 530 to 1710 kHz.
A method of measuring sound or radio signal strength received by the audio unit antenna.
08/08/21 14:08:46 61SNR030_230_0170
ProCarManuals.com
DYNOMITE -2009-







Wiring Precautions
Precautions for Electrical Inspections
24-16SRS
Precautions and Procedures (cont’d)
Some of the SRS wiring can be identified by a special
yellow outer covering, and the SRS connectors can be
identified by their yellow color. Observe the following
instructions:
 Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage to the SRS wiring,
replace the harness.
 Be sure to install the harness wires so they do not get pinched or interfere with other parts.
 Make sure all SRS ground locations are clean, and grounds are securely fastened for optimum metal-to-
metal contact. Poor grounds can cause intermittent
problems that are difficult to diagnose.
 Do not use any silicone based cleaners or lubricants on any SRS connectors or terminals.  When using electrical test equipment, insert the
probe of the tester into the wire side of the connector.
Do not insert the probe of the tester into the terminal
side of the connector, and do not tamper with the
connector.
 Use backprobe adapter 07TAZ-001020A. Do not insert the probe forcibly.
 Use specified service connectors in troubleshooting. Using improper tools could cause a diagnostic error
due to poor metal-to-metal contact.
08/08/21 13:54:19 61SNR030_240_0016
ProCarManuals.com
DYNOMITE -2009-

Î




Opening the SRS Unit Shorting Connectors
for Diagnosis
Special Tools Required
24-18SRS
Precautions and Procedures (cont’d)
B
070AZ-SAA0100
SRS UNIT
A SRS UNIT CONNECTOR A (28P)
SRS UNIT CONNECTOR B (28P)
SRS short canceller 070AZ-SAA0100
NOTE:
 To prevent damage to the c onnector cavity, insert
short canceller straight into the cavity from the
terminal side.
 Before installing a short canceller, wash it with electrical contact cleaner, then dry it with
compressed air.
 Do not use a short canceller if it is damaged.
 Make sure to remove the short canceller before reconnection.
 Some systems store data in memory that is lost when the battery is disconnected. Before disconnecting the
battery, refer to Battery Terminal Disconnection and
Reconnection (see page 22-68).
When SRS unit connectors A (28P) and B (28P) are
disconnected, a short circuit is automatically created in
the connector by its own function to pr event an airbag
deployment. The circuit may need to be open
sometimes when testing the system. Insert a short
canceller (070AZ-SAA0100) in the specified cavities
when necessary to keep the circuit open for testing. Terminal numbers are shown from the wire side of the
female terminals. Insert the short canceller(s) into the
cavities on the terminal side of connector.
Terminal side of
female terminals Wire side of female terminals
Insert short canceller(s) here.
Wire side of female terminals Insert short canceller(s) here.
08/08/21 13:54:20 61SNR030_240_0018
ProCarManuals.com
DYNOMITE -2009-