(#'
'
-)
µ
µ
µ
µ µ
µ
µ
µ
YES
NO
YES
NO YES
NO
YES
NO
DTC A1-1x (‘‘x’’ can be 0 thru 9 or A thru F):
24-17124-171
SRS UNIT CONNECTOR A (28P)
PASSENGER’S AIRBAG CUTOFF
INDICATOR 4P CONNECTOR BLU
SRS UNIT CONNECTOR A (28P)
6. Measure the resistance between SRS unitconnector A (28P) terminal No. 13 and passenger’s
airbag cutoff indicator 4P connector terminal No. 4.
There should be less than 1.0 .
Go to step 7.
Open in the dashboard wire harness; replace
the dashboard wire harness, then clear the DTC.
7. Measure the resistance between SRS unit connector A (28P) terminal No. 13 body ground.
There should be an open circuit or at least 1 M .
Check for a faulty SRS unit or passenger’s
airbag cutoff indicator; replace the passenger’s
airbag cutoff indicator (see page 24-212), then clear
the DTC. If the problem is still present, replace the
SRS unit (see page 24-203).
Short to ground in the dashboard wire
harness; replace the dashboard wire harness, then
clear the DTC. NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-13), General Troubleshooting Information (see page
24-22), and Battery Terminal Disconnection and
Reconnection (see page 22-68).
1. Clear the DTC memory (see page 24-23).
2. Turn the ignition switch to ON (II), and wait for 10 seconds.
3. Read the DTC (see page 24-22).
Go to step 4.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures
(see page 24-24). If another DTC is indicated,
troubleshoot the DTC.
4. Turn the ignition switch to LOCK (0).
5. Check the No. 9 (7.5 A) fuse in the under-dash fuse/ relay box.
Go to step 6.
Replace the fuse, then turn the ignition switch
to ON (II). If the fuse blows again, check for a short
in the No. 9 (7.5 A) fuse circuit (dashboard wire
harness, floor wire harness, front passenger’s seat
wire harness (with seat heater), or ODS unit
harness), then clear the DTC.
6. Disconnect the negative cable from the battery, then wait at least 3 minutes.
7. Disconnect the SRS unit connector A (28P) from the SRS unit (see step 9 on page 24-21).
8. Reconnect the negative cable to the battery.
9. Turn the ignition switch to ON (II).
(cont’d)
Faulty Power supply (VA Line)
Wire side of female terminals
Wire side of female terminals
Wire side of female terminals
Is the resistance as specif ied?
Is the resistance as specif ied? I s DT C A1-1x i nd i cat ed ?
IsthefuseOK?
08/08/21 14:00:56 61SNR030_240_0171
ProCarManuals.com
DYNOMITE -2009-
