2005 SKODA OCTAVIA Owner's Manual

Seats and Stowage
88
Removing and installi ng a head restraint
– Pull the head restraint up out of the backrest of the seat as far as the stop (on the rear head restraints fold forward the seat
backrest).
– Press the locking button in the direction of arrow ⇒ fig. 64 and
pull the head restraint out.
– To re-insert the head restraint, push it down into the backrest of the seat far enough until you hear the locking button
engage.
The head restraints of the front seats can be adjusted for angle and
height. The outer head restraints at the rear can only be adjusted for
height. The middle rear head restraint* is adjustable in two positions.
The head restraints must be adjusted to match the size of the seat occu-
pant. Correctly adjusted head restraints together with the seat belts offer
effective protection for the occupants ⇒page 179.
Active head restraints*
The front seats can be equipped with active head restraints, which protect
the occupants from injury to the cervical vertebra in the event of a rear
impact
WARNING
•The head restraints must be correctly adjusted in order to offer
effective protection for the occupants in the event of an accident.
•Do not drive under any circumstance with removed head
restraints - risk of injury!
•If the rear seats are occupied, the rear head restraint must not
be in the lower position.
Heating the front seats*
The seating and leaning surfaces of the front seats can be heated
when the ignition is switched on.
Front seats
– Heating on the driver's and front pasenger's seat can be switched on and regulated by turning the control dial ⇒fig. 65.
– The system is switched off by turning the control dial to the home position “0”.
Caution
•You should not kneel on the seats or otherwise apply pressure at
specific points in order to avoid damaging the heating elements of the seat
heaters.
•Do not clean the seats moist ⇒page 239.
Fig. 65 Dash panel:
Control dial for heating
the front seats
s24s.book Page 88 Thursday, November 24, 2005 12:27 PM

Seats and Stowage89
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Note
•The seat heating should only be switched on when the engine is
running. This has a significant effect of saving on the battery capacity.
•If the on-board voltage drops, the seat heating is switched off automat-
ically, in order to provide sufficient electrical energy for the engine
control.
Rear seats
Folding the rear seats forwards
To enlarge the luggage compartment, the rear seats can be
folded forwards, if necessary remove the rear seats. Both rear
seats can be folded forward individually on vehicles with divided
rear seats*.
Folding the rear seats forwards
– In order to avoid causing any damage when folding the rear seat forward it is important to adjust the front seats so that no
damage can occur when this is done.
– Pull up the rear seats in the direction of arrow and fold forwards in direction of arrow ⇒ fig. 66.
– Press the unlocking knob and fold the rear seat backrest forwards ⇒fig. 67.
If the front seats are too far back, we recommend that you have the rear
head restraints removed before the seat backrests are folded forward.
Store the removed head restraints in such a way that they cannot be
Fig. 66 Folding the
rear seats forwards
Fig. 67 Unlock the seat
backrest
A1
A2
AA
s24s.book Page 89 Thursday, November 24, 2005 12:27 PM

Seats and Stowage
90
damaged or soiled. Please refer to the guidelines ⇒page 92, “Luggage
compartment”.
Folding the rear seats back into position
Folding the rear seats back into position
– Install the head restraint in the partially lifted rear seat back- rest.
– Place the rear lateral seat belt behind the edge of the side trim panel ⇒fig. 68 .
– Then push the seat backrest back into the upright position until the locking button clicks into place - check by pulling on
the rear seat backrest.
– Make sure that the red pin is covered ⇒page 89, fig. 67. – Fold the rear seats back into its original position.
WARNING
•The belts and the belt locks must
be in their original position
after folding back the rear seats and seat backrests - they must be
ready to use.
•The seat backrests must be securely interlocked in position so
that no objects in the luggage compartment can slide into the
passenger compartment if there is sudden braking - risk of injury.
•Pay attention that the rear seat backresst are correctly inter-
locked. It is only then that the th ree-point seat belt for the middle
seat can reliably fulfil its function.
•Before folding the seat backrest back into the secure position,
place the rear lateral seat belt behind the edge of the side trim
panel. Take suitable measures to prevent that the seat belt is
jammed between the seat backrest and the side trim panel is thus
damaged.
Fig. 68 Lock the seat
backrest
AC
AB
s24s.book Page 90 Thursday, November 24, 2005 12:27 PM

Seats and Stowage91
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Remove the rear seats
You can enlarge the luggage compartment on vehicles with
divided rear seats* by removing the rear seat.
Removing
– Fold the rear seats forwards completely
– Press the wire clamps in the direction of the arrow ⇒fig. 69
and remove the rear seats from its holder.
Installing
– Press the wire clamp in the direction of the arrow and place the seat upholstery in its holder.
– Fold the rear seats back into its original position.
Armrest of rear seats*
– You can fold down the armrest at the loop to enhance occu- pant comfort ⇒fig. 70 .
Pedals
Concerning a secure depressing of the pedal, you should use only foot-
mats from the Škoda genuine accessories.
Operation of the pedals must not be hindered!
WARNING
•Greater pedal distances may be needed when there is a fault in
the brake system.
Fig. 69 Remove the
rear seatsFig. 70 Rear seats:
Armrest
s24s.book Page 91 Thursday, November 24, 2005 12:27 PM

Seats and Stowage
92
•Do not place any footmats or other additional floor coverings in
the area of the pedals in order to ensure that all the pedals can be
fully depressed and are able to return unobstructed to their initial
position - risk of accident!
•There must be no objects on the floor which could roll under the
pedals. You would then no longer be able to apply the brakes,
operate the clutch or accelerator - risk of accident!
Luggage compartment
Loading the luggage compartment
Please observe the following in the interest of having good
handling characteristics of your vehicle:
– Distribute the items of luggage as evenly as possible.
– Place heavy objects as far forward as possible.
– Attach the items of luggage to the lashing eyes or the safety net* ⇒page 93.
In the event of an accident, there is such a high kinetic energy which is
produced by small and light objects that they can cause severe injuries.
The magnitude of the kinetic energy depends on the speed at which the
vehicle is travelling and on the weight of the object. The speed at which
the vehicle is travelling is in this case the more significant factor.
Example: In the event of a frontal collision at a speed of 50 km/h, an unse-
cured object with a weight of 4.5 kg produces an energy, which corre- sponds to 20 times its own weight. This means that it results in a weight
of approx. 90 kg. You can imagine the injuries that can occur, if this “bullet”
is flying through the interior compartment and hits an occupant.
WARNING
•Store the objects in the luggage compartment and attach them
to the lashing eyes.
•Loose objects in the passenger compartment can be thrown
forward during a sudden manoeuvre or in case of an accident and
can injure the occupants or other oncoming traffic. This risk is still
increased, if the objects which are flying around are hit by a
deployed airbag. In this case, the objects which are thrown back
can injure the occupants - hazard.
•Please note that the handling properties of your vehicle may be
affected when transporting heavy objects as a result of the
displacement of the centre of gravity. The speed and style of
driving must be adjusted accordingly.
•The items carried in the luggage compartment should be stored
in such a way that no objects are able to slip forward if there are any
sudden driving or braking manoeuvres undertaken - risk of injury!
•Never drive with the boot lid sli ghtly ajar or even fully opened
otherwise exhaust gases may get into the interior of the vehicle -
risk of poisoning!
•On no account exceed the permissible axle loads and the
permissible gross weight of th e vehicle - risk of accident!
•Never transport occupants in the luggage compartment!
Caution
Please ensure that the heating elements of the rear window heater are not
damaged as a result of objects sliding in this area.
WARNING (continued)
s24s.book Page 92 Thursday, November 24, 2005 12:27 PM

Seats and Stowage93
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Note
Tyre pressure must be adjusted to the load ⇒page 264, fig. 199 .
Lashing eyes
Eyes are located on the sides of the loading area for lashing the goods to
be loaded.
You can also attach a floor fixing net* to these eyes for lashing small
objects.
The floor fixing net* and the installation instruction are located in a
container under the floor covering of the luggage compartment behind the
spare wheel.
WARNING
•The load to be transported must be fixed in place in such a way
that it cannot move during the journey and when braking.
•If the items of luggage or objects are attached to the lashing
eyes with unsuitable or damaged lashing straps, injuries can occur
in the event of braking manoeuvres or accidents. In order to
prevent the items of luggage being thrown forward, always use
suitable lashing straps which are firmly attached to the lashing
eyes.
Fig. 71 Luggage
compartment: Lashing
eyes (Octavia)
Fig. 72 Luggage
compartment: Lashing
eyes (Estate car)
s24s.book Page 93 Thursday, November 24, 2005 12:27 PM

Seats and Stowage
94
Note
On vehicles in the version Octavia, the top front lashing eyes are located
behind the seat backrest ⇒page 93, fig. 71 .
Fixing nets - Net programme Octavia*
Fixing examples of the fixing net as horizontal pocket ⇒fig. 73 and vertical
pocket ⇒fig. 74 .
The fixing net and the installation instruction are located in a container
under the floor covering of the luggage compartment behind the spare
wheel.
WARNING
The whole strength of the net makes it possible to load the pocket
with objects of up to 1.5 kg in weight. Heavy objects are not
secured sufficiently - risk of injury and net damage!
Caution
Do not place any objects with sharp edges in the nets - risk of net
damage.
Fig. 73 Fixing net:
Horizontal pocket
Fig. 74 Fixing net:
Vertical pocket
s24s.book Page 94 Thursday, November 24, 2005 12:27 PM

Seats and Stowage95
Using the systemSafetyDriving TipsGeneral MaintenanceBreakdown assistanceTechnical Data
Fixing nets - Net programme estate car*
Fixing examples of the fixing net as pocket ⇒fig. 75 and as division of the
luggage compartment ⇒fig. 76 . The fixing net and the installation instruction are located in a container
under the floor covering of the luggage compartment behind the spare
wheel.
WARNING
The whole strength of the net makes it possible to load the pocket
with objects of up to 1.5 kg in weight. Heavy objects are not
secured sufficiently - risk of injury and net damage!
Caution
Do not place any objects with sharp edges in the nets - risk of net
damage.
Folding double hooks* (Octavia)
Fig. 75 Fixing net:
Pocket
Fig. 76 Fixing net:
Division of the luggage
compartment
Fig. 77 Luggage
compartment: Folding
double hooks
s24s.book Page 95 Thursday, November 24, 2005 12:27 PM