2005 NISSAN NAVARA heating

AXLE SHAFT
RAX-11
[M226]
C
E
F
G
H
I
J
K
L
MA
B
RAX
INSPECTION AFTER DISASSEMBLY
Axle Shaft
lClean and remove all nicks and burrs.
lCheck for straightness and distortion. Replace if necessary.
lInspect machined surfaces for evidence of overheating, damage and wear. Replace if necessary.
lMeasure the bearing ring retainer axle journal diameter. Replace if necessary.
ASSEMBLY
1. Install a new grease catcher onto the axle shaft.
2. Reinstall studs on the axle shaft retainer, and install the axle shaft retainer on the axle shaft.
3. Install a new seal lip onto the axle shaft.
CAUTION:
lSeal lip can not be reused. Do not attempt to reuse it.
lWhen installing oil seals, apply multi-purpose grease to oil seal lips.
4. Install a new bearing on the axle shaft.
CAUTION:
lWheel bearing can not be reused. Do not attempt to reuse it.
5. Using a bearing inserter, and a suitable press, press fit the axle
shaft to the new bearing ring retainer, until the snap ring groove.
CAUTION:
lMake sure the bearing ring retainer, axle shaft bearing,
axle shaft lip seal, and axle shaft retainer are installed
facing in the correct direction.
lBearing ring retainer can not be reused. Do not attempt to
reuse it.
6. Apply grease to the bearing cup, and install onto the axle shaft
bearing.
7. Install a new snap ring using a suitable snap ring pliers.
CAUTION:
Discard the old snap ring: replace with new ones.
8. Install the new ABS rotor sensor. Refer toBRC-39, "
SENSOR ROTOR".
CAUTION:
Discard the old sensor rotor; replace with a new one.Bearing ring retainer axle journal diameter (minimum)
: 45.027 mm (1.7727 in)
MDIB9047E

SE-12
HEATED SEAT
HEATED SEAT
PFP:87335
DescriptionEIS00BC8
lWhen handling seat, be extremely careful not to scratch heating unit.
lTo replace heating unit, seat trim and pad should be separated.
lDo not use any organic solvent, such as thinner, benzene, alcohol, etc. to clean trim.
WIIA0031E