2005 MITSUBISHI LANCER EVOLUTION IX engine

[x] Cancel search: engine

Page 161 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual LAYOUT DIAGRAMS - INSTRUMENT PANEL1-11
C-22 (25) Instrument panel harness / Control
harness junction
C-23 (33) J/C (6)
C-28 (2) Blower motor (vehicle with heater, manual
A/C)
(6) Blower pulse controll

Page 177 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual PART INSTALLATION POSITIONS - ECU2-7
Front ECU
Headlamp ASSY
(with built-in discharge ECU) Radiator fan
controller
Radiator ASSY
Column switch (column
ECU built into wiper
switch)
Immobiliser 
ECU
Blo

Page 179 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual PART INSTALLATION POSITIONS - RELAY2-9
RELAYS
Fuel pump relay 3
Electric pump relay 
Hydraulic unit 
A/C compressor relay
Engine control relay
Ignition coil relay
Starter relayCompressor fan relay (HI

Page 183 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual PART INSTALLATION POSITIONS - INSPECTION CONNECTORS / SPARE CONNECTORS2-13
INSPECTION CONNECTORS / SPARE CONNECTORS
Front ECU
Spare connector
for fog lamp relay
Spare audio
connector
Spare generic
con

Page 186 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual PART INSTALLATION POSITIONS - EARTHS2-16
Engine ECU
Exhaust cam
position sensorSunroof motor
ASSY

Page 188 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual 3-1
SECTION 3
CIRCUIT DIAGRAMS
CONTENTS
J/B ............................................................3-4
J/C ............................................................3-6
Central Junction........

Page 189 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual 3-2
Equipment
ABS ................................................................3-122
ACD (vehicle without AYC) ............................3-130
ACD, AYC ...........................................

Page 193 of 364

MITSUBISHI LANCER EVOLUTION IX 2005  Workshop Manual CIRCUIT DIAGRAMS - J/C3-6
J/C
Note : 
In the actual vehicle, any of the terminals connected inside the J/C
may be used.  Therefore the terminal numbers indicated on the circuit
diagrams may not corres