2005 MERCEDES-BENZ SL55AMG buttons

248 Controls in detailUseful featuresProgramming or reprogramming the in-
tegrated remote control
Step 1:
Switch on the ignition (
page 36).
Step 2:

If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when indicator lamp 1 be-
gins to flash after approximately 20
seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.Step 3:

Hold the end of the hand-held remote
control transmitter6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp1 in view.
Step 4:

Using both hands, simultaneously
press the hand-held transmitter
button5 and the desired integrated
signal transmitter button (2, 3
or4). Do not release the buttons until
completing step 5.
The indicator lamp1 on the integrat-
ed remote control will flash, first slowly
and then rapidly.Step 5:

When the indicator lamp1 flashes
rapidly, release both buttons.
Step 6:

Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp1.
If the indicator lamp1 stays on con-
stantly, programming is complete and
your device should activate when the
integrated signal transmitter button is
pressed and released.iThe indicator lamp1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after 20 sec-
onds.

249 Controls in detail
Useful features
Step 7:
To program the remaining two buttons,
repeat the steps above starting with
step 3.Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Step 8:

Locate “training” button on the garage
door opener motor head unit.
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the “train-
ing” button may also be referred to as
“learn”or “smart” button. If there is dif-
ficulty locating the transmitting button,
refer to the garage door opener opera-
tor’s manual.
Step 9:

Press “training” button on the garage
door opener motor head unit.
The “training light” is activated.You have 30 seconds to initiate the follow-
ing step.
Step 10:

Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (2, 3
or4).
Step 11:

Press, hold for two seconds and re-
lease same button a second time to
complete the training process.
Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.
Step 12:

Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3
or4).
iIf the indicator lamp1 blinks rapidly
for about two seconds and then turns
to a constant light, continue with pro-
gramming steps 8 through 12 as your
garage door opener may be equipped
with the “rolling code” feature.


250 Controls in detailUseful featuresStep 13:
To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner. If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:

Continue to press and hold the inte-
grated signal transmitter button (2,
3 or4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp1 will flash slowly and
then rapidly after several seconds.

Proceed with programming step 5 and
step 6 to complete. Operation of integrated remote control

Switch on ignition.

Select and press the appropriate inte-
grated signal transmitter button (2,
3 or4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory

Switch on ignition.

Simultaneously hold down the signal
transmitter buttons2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp1 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.


440 Technical termsCAN system
(C
ontroller A
rea N
etwork)
Data bus network serving to control ve-
hicle functions such as door locking or
windshield wiping depending on vehi-
cle settings and/or ambient condi-
tions.
Cockpit
All instruments, switches, buttons and
indicator/warning lamps in the passen-
ger compartment needed for vehicle
operation and monitoring.
Collapsible tire
An especially compact spare tire that
must be inflated with a provided air
pump before using. It should only be
used to bring the vehicle to the nearest
service station.COMAND
(Co
ckpit Man
agement and
D
ata System)
Information and operating center for
vehicle sound and communications
systems, including the radio, CD
changer and navigation system, as well
as other optional equipment (e.g. tele-
phone).
Control system
The control system is used to call up
vehicle information and to change
component settings. Information and
messages appear in the multifunction
display. The driver uses the buttons on
the multifunction steering wheel to
navigate through the system and to ad-
just settings.
Cruise control
Driving convenience system for auto-
matically maintaining the vehicle speed
set by the driver.Distronic*
A driving convenience cruise control
system which helps the driver maintain
a pre-selected speed:


If there is no vehicle directly ahead,
the system operates in the same
way as conventional cruise control.


If a slower moving vehicle is ahead,
Distronic* will reduce your vehicle
speed to the extent permitted by re-
duced throttle and up to 20% brak-
ing power to maintain the preset
minimum following distance.
DTR
(->Distr
onic*)
Engine number
The number set by the manufacturer
and placed on the cylinder block to
uniquely identify each engine pro-
duced.

442 Technical termsMemory function
Used to store three individual seat,
steering wheel and mirror positions for
each SmartKey or SmartKey with
KEYLESS-GO*.
MON
The Motor Octane Number for gasoline
as determined by a standardized
method. It is an indication of a gaso-
line’s ability to resist undesired detona-
tion (knocking). The average of both
the MON (Motor Octane Number) and
RON (Research Octane Number) is
posted at the pump, also known as
ANTI-KNOCK INDEX.
Multifunction display
Two display fields in the instrument
cluster used to present information
provided by the control system.Multifunction steering wheel
Steering wheel with buttons for operat-
ing the control system.
Overspeed range
Engine speeds within the red marking
on the tachometer dial, see “Tachome-
ter” (
page 132). Avoid this engine
speed range, as it may result in serious
engine damage that is not covered by
the Mercedes-Benz Limited Warranty.
Parktronic (Parking assist)*
System which uses visual and acoustic
signals to assist the driver during park-
ing maneuvers.
Poly-V-belt drive
Drives engine-components (alternator,
AC compressor, etc.) from the engine.Power train
Collective term designating all compo-
nents used to generate and transmit
motive power to the drive axles, includ-
ing


engine


clutch/torque converter


transmission


transfer case


drive shaft


differential


axle shafts/axles
Program mode selector switch
Used to switch the automatic transmis-
sion between standard operation (S)
and comfort operation (C).
SL 55 AMG with steering wheel gear-
shift control and manual shift program:
in addition to S and C (for regular S or
comfort C operation, see above), you
can use MANUAL for manual shift pro-
gram

455 Index
Light sensor 361
Replacing bulbs for rear 381, 385
Switching off 123
Switching on 123
Lamps, indicator and warning
ABS 27, 325
ABS/ESP 324
AIRBAG OFF 334
Airbag Off 68
Brakes 326
CHECK ENGINE 327, 328
Coolant 328
DTR* 210
Engine diagnostics 327, 328
ESP 82
Fuel reserve 330
SBC 85
Seat belts 332
SRS 63, 332
Turn signals 25Language
Multifunction display 149
Leather upholstery
Cleaning 321
License plate lamps 153, 381
Replacing bulbs 385
Light sensor 361
Lighter see Cigarette lighter
Lighting
Instruments 131
Interior 129
Settings (control system) 152
Trunk 130
Limiting the gear range 167
Limp Home Mode 177
Load assist 235
Lowering manually 376
Loading terminology 305
Loading the vehicle 282
Lock buttons 34
Door handle (KEYLESS-GO*) 60
Trunk (KEYLESS-GO*) 104Locking 56
Automatic while driving 110
Centrally from inside 111
Fuel filler flap 267
Global (SmartKey with
KEYLESS-GO*) 102
Global (SmartKey) 96
Storage compartments 230
Vehicle in an emergency 376
Low beam headlamps 51, 123, 381
Replacing bulbs 383
Lowering
Load assist manually 376
Roll bar 74
Luggage compartment, rear 232
Luggage cover 197
Messages in display 371
Opening/closing 197
Lumbar support adjustment 115

457 Index
Multifunction display messages
ABC 337
ABS 338
Battery 345, 346
Brake pads 346
Brake system 350
CHECK ENGINE 351
Coolant 352
Coolant level 351, 353
Display malfunction 354
Doors 354
Easy-entry/exit feature 354
Fuel reserve tank 357
Hood 357
Luggage cover 371
Retractable hardtop 357
Roll bar 364
SBC brake system 347, 348
Seat belts 364
SmartKey 357
SmartKey with KEYLESS-GO* 359
Tele Aid 364
Telephone* 364Tires 365
Trunk 371
Washer fluid 371
Multifunction steering wheel 28, 135,
442
Buttons 135
N
Navigation system
Operating 142
Night security illumination 154
Normal occupant weight 306
O
Occupant distribution 306
Octane number 443
Odometer, main 25
Oil
Adding 274
Consumption 272
Filler neck 274
Oil level
Checking 269One-touch gearshifting 166
Canceling gear range limit 166
Downshifting 166
Upshifting 166
Opening
Doors from the inside 106
Fuel filler flap 267
Hood 270
Luggage cover 197
Retractable hardtop (SmartKey) 200
Retractable hardtop (switch) 197
Side windows 194
Storage compartment in the
armrest 230
Storage compartment in the center
console 230
Sunshade 204
Trunk from inside vehicle 108
Trunk lid 107
Windows 193

460 IndexResume function
Cruise control 208
Distronic* 215
Retractable hardtop 443
Closing (SmartKey) 201
Closing (switch) 198
Convenience feature 201
Locking after raising/lowering 199
Message in display 357
Opening (SmartKey) 200
Opening (switch) 197
Problems when operating 201
Summer opening feature 200
Rim 306
Roll bar 73, 443
Lowering 74
Messages in display 364
Raising 73
Warning lamp 27
Roll bar buttons 30RON 268, 443
Roof see Retractable hardtop
Rubber parts
Cleaning 321
S
Satellite-radio* 140
SBC brake system 79, 85, 443
Activation 86
Deactivation 87
Driving hints 87
Messages in display 347, 348
Self-check 86
Warning lamp 85
Seat belt force limiter 72
Seat belts 45, 62, 69
Cleaning 320
Messages in display 364
Telltale 332
Seat heating
Switching off 117
Switching on 117Seat ventilation*
Switching off 119
Switching on 119
Seating capacity 284
Seats
Adjusting height 40
Adjusting lumbar support 116
Adjusting shoulder support 116
Easy entry/exit feature 113
Heating 117
Massage function 116
Moving 115
Service
Basic service (Service A) 312
Batteries 401
Calling up the maintenance service
indicator 313
Extended service (Service B) 312
Types 312
Service life (tires) 280