2005 KIA Rio belt

3-1
KNOWING YOUR VEHICLEKeys . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-2
Keyless Entry System . . . . . . . . . . . . . . . . . . . . . . . . . 3-3
Door Locks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
Windows . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-8
Seats . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11
Safety Belts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-20
Air Bag - Supplemental Restraint System . . . . . . . . . 3-46
Rear Hatch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-54
Trunk Lid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-55
Hood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-57
Fuel Filler Door . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-59
Steering Wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-62
Mirrors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-62
Interior Lights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-65
Cup Holders and Console Storage Compartment . . . 3-66
Sunglass Holder . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-67
Luggage Net . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-68
Roof Rack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-69
Power Outlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-70
Tonneau Cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-71
3
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 1

3-11
Passenger Door Power Window Controls
To open a window, press the front portion of the switch
down. To close a window, pull the front portion of the
switch up.
Seats
WARNING - Passengers
Do not allow children to play with the power
windows. They may seriously injure them-
selves or others.
WARNING - Drivers
 Never adjust the driver’s seat or seatback
when the vehicle is moving. Doing so could
cause loss of control, and serious personal
injury or death.
 Do not allow packages or other objects to
interfere with the normal position of a seat
back. These objects may prevent the seat
back from locking, which could result in
serious injury or death in the event of a sud-
den stop or collision.
 Always drive and ride with your seatback
upright and the lap portion of the safety belt
snug and low across the hips.
 If a child is riding in the front passenger seat,
they should always ride with the seatback in
the fully upright position.
1B3104006A
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 11

3-13
Adjusting the Front Seatback Recliner
To recline the seatback;
1. Lean forward slightly and lift up on the seatback
recline lever located on the outside of the seat,
toward the rear.
2. Lean back on the seat and adjust the back of the seat
to the position you desire.
3. Release the lever and make sure the seatback is
located in place. (The lever MUST return to its orig-
inal position for the seatback to lock.)
WARNING - Passengers
To reduce the risk of sliding under the lap por-
tion of the lap/shoulder belt, and potentially
suffering serious personal injury or death in
the event of a collision, do not use the front
seatback in a reclined position while the vehi-
cle is in motion. If a seat is reclined, the occu-
pant’s hip could slide under or out of the lap
portion of the lap/shoulder belt during a colli-
sion. If that occurs, the occupant may no
longer be properly restrained, and the safety
belt could apply restraint forces to the unpro-
tected abdomen resulting in serious personal
injury or death. Therefore, keep the seatbacks
in a comfortably upright position whenever the
vehicle is in motion.
AS2B03012
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 13

Knowing Your Vehicle3-18
Split Folding Rear Seat (If Equipped)
The rear aseatbacks fold froward to provide additional
cargo space and to provide an access to the trunk area.
 To fold the rear seatback(s) down, pull the unlock
knob located in the top of the seatbacks, then fold
the seatback forward and down.
 To raise the seatback, lift and push it firmly until it
clicks into place.
 When you return the seatback to its original posi-
tion, reposition the rear safety belts so that they can
be used by rear seat passengers.
1BC102001B
(Continued)
 Passengers should not ride in the cargo area
or sit or recline on folded seatbacks while
vehicle is in motion.
 When resetting the seatback to the upright
position, make sure it is securely latched by
pushing it forward and rearward.
 To avoid the possibility of burns, do not
remove the carpet in the cargo area.
Emission controls beneath this floor gener-
ate hight exhaust temperatures.
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 18

3-19
Rear Seat Armrest (If Equipped)
This armrest is located in the center of the rear
seatback. To use an armrest, pull it downward from the
seatback.
1BC102002
WARNING -Cargo
Cargo should always be secured to prevent it
from shifting and causing injury to the vehicle
occupants.✻ ✻
NOTICE
When returning the rear seatbacks to the upright
position, remember to return the rear shoulder
belts to their proper position. Routing the safety
belt webbing through the rear safety belt guides
will help keep the belts from being trapped
behind or under the seats.
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 19

Knowing Your Vehicle3-20Safety BeltsPretensioner Seat Belt (If Equipped)Your vehicle is equipped with driver’s and front pas-
senger’s pretensioner seat belts. The purpose of the
pre-tensioner is to make sure that the seat belts fit
tightly against the occupant’s body in certain frontal
collisions.
The pre-tensioner seat belts can be activated together
with the airbags, where the frontal collision is severe
enough.
The pre-tensioner seat belt operates in the same way as
an Emergency Locking Retractor (ELR) type of seat
belt. When the ignition switch is in the "ON" position
and if the vehicle stops suddenly, or if the occupant
tries to lean forward too quickly, the seat belt retractor
will lock into position. However, in certain frontal col-
lisions, the pretensioner will activate and pull the seat
belt into tighter contact against the occupant's body.
The seat belt pre-tensioner system consists mainly of
the following components.
Their locations are shown in the illustration.
1. SRS airbag warning light
EMSA3080AS2B030015C
1
3 2
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 20

3-21
2. Seatbelt pre-tensioner assembly
3. SRS control module.
WARNING
To obtain maximum benefit from a pre-ten-
sioner seat belt :
 The seat belt must be worn correctly.
 The seat belt must be adjusted to the correct
position.✻ ✻
NOTICE
 Both the driver's and front passenger's pre-ten-
sioner seat belts will be activated in certain
frontal collisions. The pre-tnesioner seat belts
can be activated, where the frontal collision is
severe enough, together with the airbag. The
pretensioners will be activated under these con-
ditions even if there is no one on the seat at the
time of the collision.
 When the pre-tensioner seat belts are activated,
a loud noise may be heard and fine dust, which
may appear to be smoke, may be visible in the
passenger compartments and they are not haz-
ardous. (Continued)
(Continued)
 Although it is harmless, the fine dust may
cause skin irritation and should not be breathed
for prolonged periods. Wash your hands and
face thoroughly after an accident in which the
pretensioner seat belts were activated.
CAUTION
• Because the sensor that activates the SRS airbag
is connected with pre-tensioner seat blet, the SRS
airbag warning light on the instrument panel
will illuminate for approximately 6 seconds after
the ignition key has been turned to the “ON”
positions, and then it should be turned off.
 If the pre-tensioner seat belt is not working
properly, this warning light will illuminate even
of there is no malfunction of SRS airbag system.
If the SRS airbag warning light does not illumi-
nate when the ignition key is turned to “ON”, or
if it remains illuminated after illuminating for
approximately 6 seconds, or if it illuminates
while the vehicle is being driven, please have an
Authorized Kia Dealer inspect the pre-tension-
er seat belt or SRS airbag system as soon as
possible.
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 21

Knowing Your Vehicle3-22
WARNING
 Pre-tensioners are designed to operate only
one time. After activation, pretensioner seat
belts must be replaced. All seat belts, of any
type, should always be replaced after they
have been worn during a collision.
 The Pre-tensioner seat belt assembly mecha-
nisms become hot during activation. Do not
touch the pretensioner seat belt assemblies
for several minutes after they have been
activated.
 Do not attempt to inspect or replace the pre-
tensioner seat belts yourself. This must be
done by an authorized Kia dealer.
 Do not strike the pre-tensioner seat belt
assemblise.
 Do not attempt to service or repair the pre-
tensioner seat belt system in any manner.
(Continued)
(Continued)
 Improper handling of the pre-tensioner seat
belt assemblies, and failure to heed the
warnings not to strike, modify, inspect,
replace, service or repair the pretensioner
seat belt assemblies may lead to improper
operation or inadvertent activation and seri-
ous injury.
Always wear the seat belts when driving or
riding in a motor vehicle.
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 22