2005 FORD EXCURSION Owners Manual

Page 185 of 280

FORD EXCURSION 2005 1.G Owners Manual •auto-manual hub locks can be
manually overridden by rotating
the hub lock control from AUTO
to LOCK if desired.
•automatic operation of the
hub locks is recommended,and
will increase fuel economy

Page 186 of 280

FORD EXCURSION 2005 1.G Owners Manual 4H (4WD High)–For winter and off-road conditions. Sends power to
front and rear wheels.
4L (4WD Low)–For low-speed off-road applications that require extra
power such as steep grades, deep sand or

Page 187 of 280

FORD EXCURSION 2005 1.G Owners Manual 3. Place the gearshift in N (Neutral).
4. Move the 4WD control to the 4x4
LOW position.
5. Hold the shift conditions until the
LOW RANGE indicator light
illuminates.
6. If the LOW RANGE indicator ligh

Page 188 of 280

FORD EXCURSION 2005 1.G Owners Manual The differences that make your vehicle so versatile also make it handle
differently than an ordinary passenger car.
Maintain steering wheel control at all times, especially in rough terrain.
Since sud

Page 189 of 280

FORD EXCURSION 2005 1.G Owners Manual Vehicles with a higher center of gravity such as utility and
four-wheel drive vehicles handle differently than vehicles with a
lower center of gravity. Utility and four-wheel drive vehicles arenot
des

Page 190 of 280

FORD EXCURSION 2005 1.G Owners Manual Vehicles with a higher center of gravity such as utility and
four-wheel drive vehicles handle differently than vehicles with a
lower center of gravity. Utility and four-wheel drive vehicles arenot
des

Page 191 of 280

FORD EXCURSION 2005 1.G Owners Manual Power is supplied to all four wheels
through a transfer case. On 4WD
vehicles, the transfer case allows
you to select 4WD when necessary.
Information on transfer case
operation and shifting procedures

Page 192 of 280

FORD EXCURSION 2005 1.G Owners Manual Once through water, always try the brakes. Wet brakes do not stop the
vehicle as effectively as dry brakes. Drying can be improved by moving
your vehicle slowly while applying light pressure on the br