2005 DODGE VIPER lock

the vehicle is not going to be driven in the next 3
weeks, follow the battery recharge procedure in the
Service Manual, then disconnect the battery at the
negative terminal or use the save feature described in
Maintaining your Vehicle section under the Mainte-
nance Procedures sub-section, within Maintenance-
Free Battery.
CAUTION!
Use care when disconnecting the remote positive
cable. It is connected to the battery and can short out
to any metal on the vehicle. Always tape or wrap the
exposed cable end to prevent electrical shorts.
•Disconnecting the battery causes the engine control
system to lose memory of some“learned”functions,
unless using the Battery Save feature described inMaintaining your Vehicle section under the Mainte-
nance Procedures sub-section, within Maintenance-
Free Battery. The engine may run rough when first
started after a battery disconnect until the control
module“relearns”these functions.
Check the battery every 4 to 6 weeks to ensure that the
voltage is above 12.40. Voltage will drop more rapidly
in hot temperatures. If battery voltage drops below
12.40, follow the battery recharge procedure in the
Service Manual.
•Check that the radiator coolant level of protection is to
at least -20°F (-29°C).
•Block the wheels. Do not apply the Parking Brake.
•Make sure that all tires are inflated to the optimum
pressure, (29 PSI).
MAINTAINING YOUR VEHICLE 203
7

•Cut blocks of plywood about the same size of the tires.
Cover each block with indoor/outdoor carpeting and
place them between the tires and concrete. This will
prevent tire flat spotting.
•For long term storage, remove the tires and put the
vehicle up on blocks. Stack the tires on plywood and
cover with a tarp to prevent flat spotting.
•Move the wiper blades away from the windshield.
NOTE:To help prevent the battery from discharging
during shorter periods of inactivity, perform the follow-
ing:
1. Make sure that the trunk, hood, doors, windows and
convertible top are completely closed.
2. Make sure that remote transmitter is operating and
that the battery is good.3. Make sure that the hood, trunk and door switches are
in adjustment. Perform the quick system check which
follows.
Use the remote transmitter to set the alarm. If the alarm
SET light comes on and flashes, the system is operating
properly. If not, there is a problem with a switch or the
system. See your dealer for service.REPLACEMENT BULBS
Interior Light Bulbs
Message Center Indicators.................. 103
Cluster................................ 103
Gauge Pack............................ 103
Heater Control........................... 37
Interior Light..........................212–2
Courtesy Footwell Lights................... 194
204 MAINTAINING YOUR VEHICLE

2. Twist off sockets counter-clockwise and pull out bulbs
from the socket, install the new bulbs, and reinstall the
bulb and socket assembly. Replace the splash shield.
NOTE:On vehicles equipped with High Intensity Dis-
charge Headlights (HID), when the headlights are turned
on there is a blue hue to the lights. This diminishes and
becomes more white after approximately 10 seconds, as
the system charges.
206 MAINTAINING YOUR VEHICLE

2. Twist sockets counter-clockwise to pull out bulbs.
Replace tail, tail/stop, or marker lamp bulb.
3. Reinstall the appropriate bulb and socket assembly.
Replace the access panel. Close the trunk.Backup and Rear Turn Signal Lamp Bulb
Replacement
1. Open the trunk. Remove two access panel fasteners.
Remove the access panel.
208 MAINTAINING YOUR VEHICLE

3. Twist sockets of the three bulbs shown counter-
clockwise. Disconnect bulb and socket assemblies from
the upper lamp assembly. Pull the upper lamp assembly
clear in order to access backup and rear turn signal lamp
bulbs.4. Replace the backup or rear turn signal lamp bulb.
Reinstall the appropriate bulb and socket assembly. Re-
install the three bulb and socket assemblies in the upper
lamp assembly. Reinstall the upper lamp assembly. Re-
place the access panel. Close the trunk.
210 MAINTAINING YOUR VEHICLE

License Plate Light
Twist off sockets counter-clockwise and pull out bulbs.
Replace as required.
MAINTAINING YOUR VEHICLE 211
7

Body
Component Fluid, Lubricant, or Genuine Part
Hinges:
Door, Trunk & Hood Springs and
LinksMoparSpray White Lube
Latches:
Door, Hood & Trunk MoparMulti-Purpose Lube NLGI Grade 2
Door Hinge Check Spring Lubriplate Mo-Lith No. 2 Grease or Petrocan Multiflex Moly EP 2 Grease
Seat Regulator & Track MoparMulti-Purpose Lube NLGI Grade 2
Window System Components MoparSpray White Lube
Lock Cylinders MoparSpray White Lube
Parking Brake Mechanism MoparSpray White Lube
MAINTAINING YOUR VEHICLE 215
7

About Your Brakes....................... 117
ABS (Anti-Lock Brake) System............... 87
Accessory Delay, Power..................13,26
Adding Engine Coolant (Antifreeze).......... 185
Adding Fuel........................... 145
Adding Washer Fluid..................... 182
Additives, Fuel......................... 144
Adjustable Pedals........................ 79
Aiming Headlights....................... 212
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 171
Air Conditioner Maintenance............... 176
Air Conditioning.....................104,176
Air Conditioning Refrigerant............... 177
Air Pressure, Tires....................... 131
Airbag................................ 41
Airbag Deployment....................... 45
Airbag Light..........................44,91
Airbag Maintenance....................... 49
Airbag On/Off Switch...................35,46Alarm System........................... 20
Alignment and Balance................... 138
Alterations/Modifications, Vehicle............. 7
Antenna.............................. 103
Antifreeze (Engine Coolant)...........184,185,212
Capacities........................... 212
Disposal............................ 186
Anti-Lock Warning Light................... 87
Anti-Theft Security Alarm.................. 20
Appearance Care........................ 194
Auto Down Power Windows................ 26
Automatic Door Locks..................... 15
Automatic Transmission
Adding Fluid......................... 214
Fluid Type........................... 214
Ball Joints............................. 179
Battery.............................90,171
Emergency Starting..................... 150
244 INDEX