Page 113 of 388
4. Locate the loops at the ends of the cables.
One has a red band on it, and the other has a
green band.
The cable with the green band opens the tonneau
latch, and the cable with the red band closes it.
5. Using the release tool for the convertible top,
hook the tool into the green loop.
The convertible top release tool is stored in the
glovebox for new vehicles purchased from your
GM dealer.6. Pull the cable with the release tool.
7. Repeat Steps 4 through 6 on the other side.
2-55
Page 114 of 388
8. Lift up on the roof tonneau and raise it to the
upright position.9. Grasp the front panel of the convertible top
and pull up.
More than one person is needed to do this.
One person working on each side is best.
2-56
Page 115 of 388
10. Insert the front panel into the roof latches.
One person should hold the convertible top up
from the rear in the closed position while another
person performs the next steps.11. Pry off the plastic cap
located between the
sun visors.
12. Slide the tool side of
the convertible release
tool until the entire
tool forms a right angle
as shown. Driver’s side latches shown, passenger’s side similar
2-57
Page 116 of 388
13. Insert the convertible top release tool into the latch
closing mechanism between the sun visors and turn
it counterclockwise until the latches are secured
and the convertible top is fully closed.14. From the upright position, push down on the outer
area of the boot cover panel where the hinges and
hydraulic cylinders are located to separate it
from the roof tonneau. Then, continue to push the
boot cover panel down as far as it will go.
2-58
Page 117 of 388