2005 CHEVROLET AVALANCHE Owners Manual

Page 385 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual To disconnect the jumper cables from both vehicles do
the following:
1. Disconnect the black negative (−) cable from the
vehicle that had the dead battery.
2. Disconnect the black negative (−) cab

Page 386 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual What to Use
Refer to the Maintenance Schedule to determine what
kind of lubricant to use. SeeRecommended Fluids
and Lubricants on page 6-13.
Four-Wheel Drive
Transfer Case
It is not necessary to regul

Page 387 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual Front Axle
When to Check and Change Lubricant
It is not necessary to regularly check front axle �uid
unless you suspect there is a leak or you hear an
unusual noise. A �uid loss could indicate a probl

Page 388 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual Bulb Replacement
For the proper type of replacement bulbs, see
Replacement Bulbs on page 5-58.
For any bulb changing procedure not listed in this
section, contact your dealer.
Halogen Bulbs
{CAUTION:

Page 389 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual 4. Pull the pins away from their clips and pull them up
until they completely release from the vehicle.
5. Pull the headlamp assembly out of the vehicle.A. Low-Beam Headlamp
B. High-Beam Headlamp
6. T

Page 390 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual Vehicles without Body-Side Cladding
To replace a headlamp bulb, do the following:
1. Open the hood. SeeHood Release on page 5-10
for more information.
2. Remove the pin on the headlamp assembly by
tur

Page 391 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual Front Turn Signal, Sidemarker and
Parking Lamps
Vehicles with Body-Side Cladding
To replace a front turn signal, sidemarker, or parking
lamp bulb, do the following:
1. Open the hood. SeeHood Release o

Page 392 of 496

CHEVROLET AVALANCHE 2005 1.G Owners Manual 6. Put the new bulb into the bulb socket.
7. Put the bulb socket into the turn signal assembly
and turn it clockwise until it locks (the sidemarker
lamp does not lock into place).
8. Place the inboard