2005 Acura RSX ECU

Other LATCH-compatible seats have
a f lexible-type connector as shown
above.Whatever type you have, f ollow
the child seat maker’s instructions
f or adjusting or tightening the f it. Route the tether strap over the top
of the seat-back, making sure the
strap is not twisted.
Attach the tether strap hook to the
tether anchor, then tighten the
strap as instructed by the child
seat maker.Pushandpullthechildseat
f orward and f rom side to side to
verif y that it is secure.
4. 5.
6.7.
Installing a Child Seat
Driver and Passenger Saf ety
37
Flexible type

When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.With the child seat in the desired
seating position, route the belt
through the child seat according
to the seat maker’s instructions,
then insert the latch plate into the
buckle.To activate the lockable retractor,
slowly pull the shoulder part of the
belt all the way out until it stops,
then let the belt feed back into the
retractor.
Af ter the belt has retracted, tug on
it. If the belt is locked, you will not
be able to pull it out. If you can pull
thebeltout,itisnotlocked,and
you will need to repeat these steps.
In addition, the lap/shoulder belts in
all seating positions except the
driver’s have a locking mechanism
that must be activated to secure a
child seat.
1.2.
3.
Installing a Child Seat with a L ap/
Shoulder Belt
Installing a Child Seat
38

Af ter conf irming that the belt is
locked, grab the shoulder part of
the belt near the buckle, and pull
up to remove any slack from the
lap part of the belt. Remember, if
the lap part of the belt is not tight,
the child seat will not be secure.
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt.A child seat with a tether can be
installed in either seating position in
the back seat, using one of the
anchorage points.
Push and pull the child seat
f orward and f rom side to side to
verif y that it is f irmly secured
during normal driving maneuvers.
If the child seat is not secure,
unlatch the belt, allow it to retract
f ully, then repeat these steps.
To deactivate the locking
mechanism and remove a child seat,
unlatch the buckle, unroute the seat
belt, and let the belt f ully retract. Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available.
4. 5.
CONT INUED
Installing a Child Seat with a
Tether
Installing a Child Seat
Driver and Passenger Saf ety
39

The tether anchorage points are
located under plastic covers. Pivot
the cover downward to access the
anchorage point.Af ter properly securing the child
seat (see page ), route the
tether strap over the seat-back.
Attach the tether strap hook to the
anchor, making sure the strap is
not twisted.
Tighten the strap according to the
seat maker’s instructions.
1.
2.
3.
38
Installing a Child Seat
40
TETHER ANCHORAGE POINT
COVER

The National Highway Traffic Safety
Administration and Transport
Canada recommend that all children
age 12 and under be properly
restrained in the back seat.
If the passenger’s f ront airbag
inf lates in a moderate to severe
f rontal collision, the airbag can cause
serious injuries to a child who is
unrestrained, improperly restrained,
sitting too close to the airbag, or out
of position.
A side airbag also poses risks. If any
part of a larger child’s body is in the
path of a deploying side airbag, the
child could receive possibly serious
injuries.Of course, children vary widely. And
while age may be one indicator of
when a child can saf ely ride in f ront,
there are other important f actors you
should consider.
Physically, a child must be large
enough f or the lap/shoulder belt to
properly f it (see page ). If the seat
belt does not f it properly, with or
without the child sitting on a booster
seat, the child should not sit in f ront.
To saf ely ride in f ront, a child must
be able to f ollow the rules, including
sitting properly, and wearing the seat
belt properly throughout a ride.
If you decide that a child can saf ely
ride up f ront, be sure to:
Caref ully read the owner’s manual,
and make sure you understand all
seat belt instructions and all saf ety
inf ormation.
Move the vehicle seat to the rear-
most position.
Have the child sit up straight, back
against the seat, and feet on or
near the f loor.
Check that the child’s seat belt is
properly and securely positioned.
Supervise the child. Even mature
children sometimes need to be
reminded to f asten the seat belts
or sit properly.
41
Protecting L arger Children
When Can a L arger Child Sit in
Front
Physical Size
Maturity
Driver and Passenger Saf ety
43

ÎÎ
ÎThe U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Instrument Panel
Inst rument s and Cont rols
51
HIGH BEAM INDICATOR
CRUISE CONTROL INDICATOR
PARKING BRAKE AND BRAKE SYSTEM
INDICATOR
MALFUNCTION INDICATOR LAMP
LOW OIL PRESSURE INDICATOR
CHARGING SYSTEM INDICATOR MAINTENANCE REQUIRED
INDICATOR
IMMOBILIZER SYSTEM
INDICATOR
SECURITY SYSTEM
INDICATOR (P.
54)
ANTI-LOCK BRAKE SYSTEM INDICATOR (P. 53)
(P. 54)
(P. 54)
(P. 56)
(P.
55)
(P.53)
(P. 205)
(P. 53, 204)
(P. 53, 204) SUPPLEMENTAL RESTRAINT SYSTEM INDICATOR
(P.
52)
SIDE AIRBAG OFF INDICATOR (P. 52)
TURN SIGNAL AND HAZARD
WARNING INDICATOR (P.
54)
(P. 52)
SEAT BELT REMINDER
INDICATOR
(P. 54) SELECT/RESET
BUTTON
DOOR-OPEN INDICATOR
LOW FUEL INDICATOR (P.
54)

Press and hold the select/reset
button in the instrument panel,
then turn the ignition switch to
ON (II).
Hold the button for about 10
seconds until the indicator goes
off.This indicator comes on when the
security system is set. See page
f or more inf ormation on the
security system.
If you exceed 10,000 miles (16,000
km) without having the scheduled
maintenance perf ormed, this
indicator will remain on as a constant
reminder.
Your dealer will reset this indicator
af ter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
dealer, reset the indicator as f ollows.
Turn of f the engine.
1.
2.
3. 114
Security System Indicator
Instrument Panel Indicators
56
SELECT/RESET BUTTON
SECURITY SYSTEM INDICATOR

Make sure the rear window is clear
and you have good visibility bef ore
starting to drive.
Thedefoggerwiresontheinsideof
the rear window can be accidentally
damaged. When cleaning the glass,
always wipe side-to-side.Make any steering wheel adjustment
bef ore you start driving.
Push the lever under the steering
column all the way down. Move the steering wheel so it
points to your chest, not toward
yourface.Makesureyoucansee
the instrument panel gauges and
indicators.
Push the lever up to lock the
steering wheel in position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up and down.
1.
2.
3.
4.
Steering Wheel A djustment
Rear Window Def ogger, Steering Wheel A djustment
Inst rument s and Cont rols
63
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.