2004 YAMAHA YZF-R1S oil

8-35
SIGNALING SYSTEMELEC
1Main switch
4Fuse (main)
6Battery
10Starting circuit cut-off relay
11Neutral switch
13Fuel pump
14E.C.U.
27Speed sensor
38Fuel level warning light
39Oil level warning light
40Neutral indicator light
41Tachometer
42Shift timing indicator light
43Multi function meter
45Coolant temperature indicator light
47Turn signal indicator light (left)
48Turn signal indicator light (light)
55Turn signal relay
58Horn switch
60Turn signal switch
61Horn
62Front turn signal / position light (left)
63Front turn signal / position light (right)
64Rear turn signal light (left)
65Rear turn signal light (right)
73Fuse (ignition)
74Fuse (signal)
ProCarManuals.com

8-40
SIGNALING SYSTEMELEC
YESNO
Replace the starting
circuit cut-off relay.
YESNO 4. Voltage

Connect the pocket tester (DC 20 V) to the
meter assembly coupler (wire harness side)
as shown.
The wiring circuit
from the main switch
to the meter assem-
bly coupler is faulty
and must be re-
paired. Positive tester probe
brown
Negative tester probe
ground
1

Turn the main switch to “ON”.

Measure the voltage (DC 12 V) of brown
at the meter assembly coupler (wire harness
side).

Is the voltage within specification?
This circuit is OK.

Are the tester readings correct?
YESNO 1. Oil level warning light (LEDs)

Check the oil level warning light for continu-
ity.
When the main switch is turn to “ON”, the oil
level warning light is come on.

Are the oil level warning light OK?
Replace the meter
assembly.
EAS00802
5. The oil level warning light fails to come on.
YESNO 2. Oil level switch

Drain the engine oil and remove the oil level
switch from the oil pan.

Connect the pocket tester (Ω
100) to the
oil level switch as shown.
Replace the oil level
switch. Positive tester probe

Connector (white)
Negative tester probe
Body ground
1
12

Measure the oil level switch resistance.
Oil level switch resistance
114  126 Ω at 20C (68F)
484  536 Ω at 20C (68F)
1
2

Is the oil level switch OK?
2
When you switch the positive and negative
tester probes, the readings in the above
chart will be reversed.
NOTE:
1
ProCarManuals.com

8-53
SELF-DIAGNOSISELEC
SELF-DIAGNOSIS
The YZF-R1(S) features a self-diagnosing system for the following circuit(-s):

Fuel pump thermistor

Oil level switch
If any of these circuits are defective, their respective condition codes will be displayed on the warning
light when the main switch is turned “ON” (irrespective of whether the engine is running or not).
Circuit
Defect(-s)System responseCondition code
Fuel pump
thermistor
Open-circuit

Short-circuit
The fuel level warning light indi-
cate the condition code.Refer to *1
Oil level switch
Open-circuit

Short-circuit
The oil level warning light indicate
the condition code.Refer to *2
*1Condition code
Fuel level warning light
*
2Condition code
Oil level warning light
ProCarManuals.com

8-54
SELF-DIAGNOSISELEC
L/B B
Lg
B
BG/W
B R/L
Y/LY/BR/G
Sb/W
W
G/W
G/W
R/L
B
R/W
LgLgB
Sb/WSb/WA
Br BrA
R/G R/GBB/R B/RBY/B Y/BBY/L Y/LBG/W G/WA
GY
14
3839
40
41
42
43
44
45
Repair or replace the
wire harness.
NO
1. Wire harness

Check the wire harness for continuity.
Refer to “CIRCUIT DIAGRAM”.

Is the wire harness OK?
YES
NO
2. Fuel pump thermistor

Check the fuel pump thermistor for continuity.
Refer to “The fuel level warning light fails to
come on”.

Is the fuel pump thermistor OK?
YES
Replace the fuel
pump.Replace the multi-
function meter.
NOTE:
14Fuel pump
45Multi-function meter
TROUBLESHOOTING
The warning light starts to indicate the
self-diagnosis sequence.
Check:
1. fuel pump thermistor
2. oil level switch

Before troubleshooting, remove the following
part(-s):
1. seat
2. fuel tank

Troubleshoot with the following special
tool(-s).
Pocket tester
90890-03112, YU-3112
1. Fuel pump thermistor
CIRCUIT DIAGRAM
ProCarManuals.com

8-55
SELF-DIAGNOSISELEC
Replace the oil level
switch.
NO
2. Oil level switch

Check the oil level switch for continuity.
Refer to “The oil level warning light fails to
come on”.

Is the oil level switch OK?
YES
Repair or replace the
wire harness.
NO
1. Wire harness

Check the wire harness for continuity.
Refer to “CIRCUIT DIAGRAM”.

Is the wire harness OK?
YES
Replace the multi-
function meter.
B/WWW
Y/LY/BR/G
Sb/W
W
WG/W
R/WSb/WSb/WA
Br BrA
R/G R/GBB/R B/RBY/B Y/BBY/L Y/L
Dg
Ch
BG/W G/WA
B/W B/W
GY
B
40
41
42
43
44
45
46
47
48
49
50
51
52
45Multi-function meter
52Oil level switch
2. Oil level switch
CIRCUIT DIAGRAM
ProCarManuals.com

9-1
STARTING FAILURES
TRBL
SHTG
NOTE:
FUEL SYSTEM
Fuel tank
Empty fuel tank

Clogged fuel filter

Clogged fuel strainer

Clogged fuel tank drain hose

Deteriorated or contaminated fuel
Fuel pump
Faulty fuel pump

Faulty fuel pump relay
Throttle body (-ies)

Deteriorated or contaminated fuel

Sucked-in air
Ignition coil(s)
Cracked or broken ignition coil body

Broken or shorted primary or secondary
coils
Ignition system
Faulty ECU

Faulty crankshaft position sensor
EAS00844
TROUBLESHOOTING
The following guide for troubleshooting does not cover all the possible \
causes of trouble. It should be
helpful, however, as a guide to basic troubleshooting. Refer to the relative procedure i\
n this manual for
checks, adjustments, and replacement of parts.
STARTING FAILURES
ENGINE
Cylinder(s) and cylinder head(s)

Loose spark plug

Loose cylinder head or cylinder

Damaged cylinder head gasket

Damaged cylinder gasket

Worn or damaged cylinder

Incorrect valve clearance

Improperly sealed valve

Incorrect valve-to-valve-seat contact

Incorrect valve timing

Faulty valve spring

Seized valve
Piston(s) and piston ring(s)
Improperly installed piston ring

Damaged, worn or fatigued piston ring

Seized piston ring

Seized or damaged piston
Air filter
Improperly installed air filter

Clogged air filter element
Crankcase and crankshaft
Improperly assembled crankcase

Seized crankshaft
ELECTRICAL SYSTEMS
Battery
Discharged battery

Faulty battery
Fuse(s)
Blown, damaged or incorrect fuse

Improperly installed fuse
Spark plug(s)

Incorrect spark plug gap

Incorrect spark plug heat range

Fouled spark plug

Worn or damaged electrode

Worn or damaged insulator
ProCarManuals.com

9-2
9
Starting system
Faulty starter motor

Faulty starter relay

Faulty starting circuit cut-off relay

Faulty starter clutch
STARTING FAILURES / INCORRECT ENGINE IDLING SPEED /
POOR MEDIUM-AND-HIGH-SPEED PERFORMANCETRBL
SHTG
ELECTRICAL SYSTEMS
Battery

Discharged battery

Faulty battery
Spark plug(s)
Incorrect spark plug gap

Incorrect spark plug heat range

Fouled spark plug

Worn or damaged electrode

Worn or damaged insulator
Ignition coil(s)

Broken or shorted primary or secondary
coils

Cracked or broken ignition coil
Ignition system
Faulty ECU

Faulty crankshaft position sensor
Switches and wiring

Faulty main switch

Faulty engine stop switch

Broken or shorted wiring

Faulty neutral switch

Faulty start switch

Faulty sidestand switch

Faulty clutch switch

Improperly grounded circuit

Loose connections
EAS00846
INCORRECT ENGINE IDLING SPEED
ENGINE
Cylinder(s) and cylinder head(s)

Incorrect valve clearance

Damaged valve train components
Air filter
Clogged air filter element
FUEL SYSTEM
Throttle body (-ies)
Damaged or loose throttle body joint

Improperly synchronized throttle bodies

Improperly adjusted engine idling speed (idle
adjusting screw)

Improper throttle cable free play

Flooded throttle body

Faulty air induction system
EAS00848
POOR MEDIUM-AND-HIGH-SPEED PERFORMANCE
Refer to “STARTING FAILURES”.
ENGINE
Air filter

Clogged air filter element
FUEL SYSTEM
Fuel pump
Faulty fuel pump
ProCarManuals.com

9-3
FAULTY GEAR SHIFTING / FAULTY CLUTCH
TRBL
SHTG
JUMPS OUT OF GEAR
Shift shaft

Incorrect shift pedal position

Improperly returned stopper lever
Shift forks

Worn shift fork
Shift drum

Incorrect axial play

Worn shift drum groove
Transmission

Worn gear dog
CLUTCH DRAGS
Clutch

Unevenly tensioned clutch springs

Warped pressure plate

Bent clutch plate

Swollen friction plate

Bent clutch pull rod

Broken clutch boss

Burnt primary driven gear bushing

Match marks not aligned
Engine oil

Incorrect oil level

Incorrect oil viscosity (high)

Deteriorated oil
EAS00850
FAULTY GEAR SHIFTING
SHIFTING IS DIFFICULT
Refer to “CLUTCH DRAGS”.
SHIFT PEDAL DOES NOT MOVE
Shift shaft

Improperly adjusted shift rod

Bent shift shaft.
Shift drum and shift forks

Foreign object in a shift drum groove

Seized shift fork

Bent shift fork guide bar
Transmission

Seized transmission gear

Foreign object between transmission gears

Improperly assembled transmission
EAS00851
FAULTY CLUTCH
CLUTCH SLIPS
Clutch

Improperly assembled clutch

Improperly adjusted clutch cable

Loose or fatigued clutch spring

Worn friction plate

Worn clutch plate
Engine oil

Incorrect oil level

Incorrect oil viscosity (low)

Deteriorated oil
ProCarManuals.com