2004 YAMAHA GRIZZLY 125 oil type

5-13
cC
8Do not use oils with a diesel specification
of “CD” or oils of a higher quality than
specified. In addition, do not use oils
labeled “ENERGY CONSERVING II” or
higher.
8Be sure no foreign material enters the
crankcase.
Recommended engine oil type and quantity:
See page 10-2.
Recommended final transmission oil type
and quantity:
See page 10-2.
1C5-9-60-05 15/12/03 7:59 PM Page 14

8-21
EBU14912
Final transmission oil
The final transmission case must be checked for
oil leakage before each ride. If any leakage is
found, have a Yamaha dealer check and repair
the machine. In addition, the final transmission
oil must be changed at the intervals specified in
the periodic maintenance and lubrication chart.
Final transmission oil measurement
1. Place the machine on a level surface.
2. Remove the screw and check the oil level. It
should be up to the brim of the hole. If the
oil level is low, remove the oil filler bolt, and
then add sufficient oil of the recommended
type to raise it to the proper level.
3. Install the screw and oil filler bolt, and then
tighten them to their specified torques.we
q
q
1. Screw 2. Brim 3. Correct oil level
1. Vis 2. Bord 3. Niveau d’huile correct
1. Tornillo 2. Borde 3. Nivel correcto de aceite
1. Oil filler bolt
1. Boulon de remplissage d’huile
1. Tapón de llenado de aceite
Tightening torque:
Screw:
16 Nm (1.6 m0kgf)
Oil filler bolt:
23 Nm (2.3 m0kgf)
1C5-9-60-08 9/12/03 8:38 PM Page 8-22

10-1
SPECIFICATIONS
Model YFM125
Dimensions:
Overall length 1,710 mm
Overall width 990 mm
Overall height 980 mm
Seat height 705 mm
Wheelbase 1,080 mm
Ground clearance 145 mm
Minimum turning radius 2,900 mm
Basic weight:
With oil and full fuel tank 152 kg
Noise and vibration level:
Noise level (77/311/EEC) (for Europe) 75.1db (A)
Vibration on seat (EN1032, ISO5008) (for Europe)Will not exceed 0.6 m/s
2
Vibration on handlebar (EN1032, ISO5008) (for Europe)Will not exceed 2.5 m/s2
Engine:
Engine type Air-cooled, 4-stroke, SOHC
Cylinder arrangement Singlel cylinder, Forward-inclined
Displacement 124 cm
3
Bore × stroke 49 ×66 mm
Compression ratio 9.0 : 1
Starting system Electric starter
Lubrication system Wet sump
EBU00428
1C5-9-60-09~11 15/12/03 7:59 PM Page 12

10-2
10
Model YFM125
Engine oil/final transmission oil:
Type
Recommended engine oil/final transmission API Service SE, SF, SG type or higher
oil classification:
Quantity
Engine oil:
Periodic oil change 1.25 L
Final transmission oil: 0.6 L
cC
8Do not use oils with a diesel specification
of “CD” or oils of a higher quality than
specified. In addition, do not use oils
labeled “ENERGY CONSERVING II” or
higher.
8Be sure no foreign material enters the
crankcase.
–20° 10° 20° 30° 40°
10W30
10W40
20W40
20W5050°C
0° –10°
5W30
15W40
1C5-9-60-09~11 15/12/03 7:59 PM Page 13

10-5
Model YFM125
Shock absorber:
Front Coil spring/Oil damper
Rear Coil spring/Oil damper
Wheel travel:
Front 70 mm
Rear 80 mm
Electrical:
Ignition system DC. C.D.I.
Charging system A.C. Magneto
Battery type/voltage, capacity 12N12C-4A-2/12V, 12Ah
Headlight type: Bulb
Bulb volgate, wattage ×quantity:
Headlight 12V, 30 W/30 W ×2
Tail/brake light 12V, 5 W/21 W ×1
Indicator light:
Neutral 12V, 1.7 W ×1
Reverse 12V, 1.7 W ×1
Fuse: 15A
1C5-9-60-09~11 15/12/03 7:59 PM Page 16