2004 PONTIAC GTO Owners Manual

The control is located on the outboard side of the seat
cushion.
To increase or decrease lumbar support, turn the knob.
Reclining Seatbacks
Use the vertical switch on the outboard side of the front
seat cushion to recline the seatbacks.
Tilt the vertical switch to adjust the angle of the
seatback. The seatback moves in the same direction
that the switch is tilted to.But don’t have a seatback reclined if your vehicle is
moving.
{CAUTION:
Sitting in a reclined position when your vehicle
is in motion can be dangerous. Even if you
buckle up, your safety belts can’t do their job
when you’re reclined like this.
The shoulder belt can’t do its job because it
won’t be against your body. Instead, it will be
in front of you. In a crash you could go into it,
receiving neck or other injuries.
The lap belt can’t do its job either. In a crash
the belt could go up over your abdomen. The
belt forces would be there, not at your pelvic
bones. This could cause serious internal
injuries.
For proper protection when the vehicle is in
motion, have the seatback upright. Then sit
well back in the seat and wear your safety belt
properly.
1-3

Head Restraints
To raise the height of the head restraint, pull the head
restraint up. To lower the height of the head restraint,
push in the locking clip at the base of the head restraint
and push the head restraint down. The locking clip
needs to be pushed outboard on the driver’s side head
restraint and inboard on the passenger’s side. The
upper edge of the head restraint should be about at eye
level, never at neck level. This position reduces the
chance of a neck injury in a crash.
Seatback Latches
The front seatbacks fold
forward to let people get
into the back seat.
To fold a front seatback forward, lift the entry lever
located near the top of the outboard shoulders of each
front seat. Then tilt the seatback forward. To move
the seat forward, push the button located below
the seatback latch. Then move the seat forward.
For safety of front seat passengers, a weight sensor
has been built into the front seats. The seat will
not move forward if there is more than 27 lbs (12 kg) on
the seat sensor.
1-4

{CAUTION:
If the seatback isn’t locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
press rearward on the seatback to be sure it is
locked.
To return the seat to the original position after it has
been moved forward, do the following:
1. Before moving the seat, ensure there are no
objects in front or behind the seat.
2. Tilt the seatback
rearward until the
seatback latches
upright.3. Press and hold the
button under the front
seat lever to return
the seat to its original
position. The seat
will pause for
two seconds when it
reaches its original
position.
The seatback must first be returned upright before
pressing the button, otherwise it will not pause for two
seconds at the original position, and instead will
continue rearwards until the button is released.
When rear seat passengers are entering or exiting the
vehicle, it may be helpful to move the seat belt
anchor arm towards the rear of the vehicle, to avoid
tripping.
1-5

Safety Belts
Safety Belts: They Are for Everyone
This part of the manual tells you how to use safety
belts properly. It also tells you some things you should
not do with safety belts.
{CAUTION:
Don’t let anyone ride where he or she can’t
wear a safety belt properly. If you are in a
crash and you’re not wearing a safety belt,
your injuries can be much worse. You can hit
things inside the vehicle or be ejected from it.
You can be seriously injured or killed. In the
same crash, you might not be, if you are
buckled up. Always fasten your safety belt,
and check that your passengers’ belts are
fastened properly too.
{CAUTION:
It is extremely dangerous to ride in a cargo
area, inside or outside of a vehicle. In a
collision, people riding in these areas are more
likely to be seriously injured or killed. Do not
allow people to ride in any area of your vehicle
that is not equipped with seats and safety
belts. Be sure everyone in your vehicle is in a
seat and using a safety belt properly.
Your vehicle has a light
that comes on as a
reminder to buckle up. See
Safety Belt Reminder
Light on page 3-25.
In most states and in all Canadian provinces, the law
says to wear safety belts. Here’s why:They work.
1-6

You never know if you’ll be in a crash. If you do have a
crash, you don’t know if it will be a bad one.
A few crashes are mild, and some crashes can be so
serious that even buckled up, a person wouldn’t survive.
But most crashes are in between. In many of them,
people who buckle up can survive and sometimes walk
away. Without belts they could have been badly hurt
or killed.
After more than 30 years of safety belts in vehicles, the
facts are clear. In most crashes buckling up does
matter... a lot!Why Safety Belts Work
When you ride in or on anything, you go as fast as
it goes.
Take the simplest vehicle. Suppose it’s just a seat
on wheels.
1-7

Put someone on it. Get it up to speed. Then stop the vehicle. The rider
doesn’t stop.
1-8

The person keeps going until stopped by something. In
a real vehicle, it could be the windshield...or the instrument panel...
1-9

or the safety belts!
With safety belts, you slow down as the vehicle does.
You get more time to stop. You stop over more distance,
and your strongest bones take the forces. That’s why
safety belts make such good sense.
Questions and Answers About
Safety Belts
Q:Won’t I be trapped in the vehicle after an
accident if I’m wearing a safety belt?
A:Youcouldbe – whether you’re wearing a safety
belt or not. But you can unbuckle a safety belt,
even if you’re upside down. And your chance
of being conscious during and after an accident, so
youcanunbuckle and get out, ismuchgreater if
you are belted.
1-10